有機冷卻劑 的英文怎麼說

中文拼音 [yǒujīlěngquèjì]
有機冷卻劑 英文
organic coolant
  • 有 : 有副詞[書面語] （表示整數之外再加零數）: 30 有 5 thirty-five; 10 有 5年 fifteen years
  • 機 : machineengine
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 卻 : Ⅰ動詞1 （後退） step back 2 （使退卻） drive back; repulse 3 （推辭; 拒絕） decline; refuse; reje...
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 有機 : organic organic
  1. In the experiment of searching the agent for removal of phaeocystis globosa, six organic biocides were studied on their effect of removal of phaeocystis globosa. then isothiazolone biocide, glutaric dialdehyde and benzalkonium bromide were selected to apply to remove p. globosa red tide. their minimum use levels are 1. omg / l, 1. 4mg / l, 0. 6mg / l respectively, and the efficiencies of removal are above 80 %

    論文對有機除藻劑進行了篩選研究，對目前常用於工業循環冷卻水的6種有機殺生劑進行了試驗研究，發現異噻唑啉酮、戊二醛和新潔而滅對棕囊藻均具有良好的去除效果，它們使用的最低有效濃度分別是： 1 . 0mg l 、 1 . 4mg l 、 0 . 6mg l ，除藻率達80 。
  2. Therefore, sequential research on chf is necessary. when in accidental conditions of nuclear reactor, the mass flux of coolant is very low. in such condition, the steam quality is high, and the mechanism of chf is mainly controlled by bulk flow, whereas microcosmic parameters near the chf area are affected by the flow conditions in whole tube which called " upstream memory effect "

    在反應堆事故工況下，冷卻劑流量很低，含汽量很高，其臨界機制與正常運行工況下的臨界機制有所不同，不僅是一種主流控制臨界工況，更由於其局部的各微觀參數受上游流道的累積效果的影響而存在上游記憶效應。
  3. It can be used as dispersant in pour - cooling water if iron and steel plants, and also used together with organic phosphonate and zine salts in circulation cooling water with high hardness and high alkality

    用於鋼鐵廠淋洗的冷卻水，防止氧化鐵、氧化鋅和泥沙沉積，以及用於高堿度循環冷卻水中與有機膦酸鹽、鋅復配的阻垢緩蝕劑。
  4. The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film

    試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。
  5. The main content is : splitting tensile experiments were carried out about the standardized cube bonding specimens ( 150x 150x 150mm3 ) of the new - old concrete after high temperature. the temperature is divided into 9 groups from normal atmospheric temperature to 900, the cooling styles are natural cooling and spraying water cooling ; different interfacial treating methods : brushed with steel - wire brush, man - made chiseling ( not evenly ), man - made chiseling ( quite evenly ) ; different interfacial agents : no interfacial agent, neat cement paste, cement paste mixed with 10 % expanding agent

    主要內容有：本文對75個高溫作用后的標準立方體新老混凝土粘結試件進行了劈拉試驗，溫度從常溫到900c分9個溫度段，降溫方式分自然冷卻和噴水冷卻兩種。著重考察了溫度、降溫方式、界面粗糙度及界面劑對新老混凝土粘結劈拉強度的影響規律，闡述了高溫后粘結強度下降的機理。
  6. Foam glass is a new kind of inorganic heat insulating material with a structure of equally closed cells. it is mainly made of glass added with adequate foaming agents after heating and baking in high - temperature tunnel furnace, then annealing and cooling

    泡沫玻璃是一種以玻璃為主要原料，摻入適量發泡劑，通過高溫遂道窯爐加熱焙燒和退火冷卻加工處理后制得，具有均勻的獨立密閉氣隙結構的新型無機絕熱材料。
  7. Bwr is a light water reactor using ordinary water as coolant and moderator similar to the pwr except it only has a single circuit connecting the reactor and the turbine without a steam generator

    沸水式反應堆是輕水反應堆的一種，這種反應堆和壓水式反應堆相似，均利用普通水作為冷卻劑及慢化劑，但沸水式反應堆只有一個連接反應堆和渦輪機的迴路，且沒有裝設蒸汽發生器。
  8. Full - stainless stell ; oil - water separator, liquid heating ; auto - matic constant tempertature ; outside - jiint water or air cooler ; solution recobering system to keep the solution clean for a long time ; level auto - control ; fast cooling and drying ; convenient draining ; double protecting debice ; auto - reset function

    全不銹鋼結構，內置油水分離器，液體加熱與自動恆溫，外接冷水機，或冷氣機組，溶劑回收再生，使清洗劑長期清潔，具有液位自動控制，快速冷卻乾燥，排污方便，雙重保護裝置，自動復位功能。
  9. Standard test method for cavitation corrosion and erosion - corrosion characteristics of aluminum pumps with engine coolants

    帶有發動機冷卻劑的鋁泵的氣蝕和侵蝕特性的標準試驗方法
  10. In order to solve this problem, this paper analyzes the fault diagnosis method for chillers using wavelet packet analysis. this paper simulated 9 faults including decreasing of cooling water flow, decreasing of refrigerant and non - condense gas existed and so on. it also analyzed the fault diagnosis technology combined theory and experiments

    本論文模擬了冷卻水量改變、有不凝性氣體、製冷劑流量減小等九個故障，並採用理論分析與實驗驗證相結合的方法對單螺桿式冷水機組的故障診斷技術進行了研究。
分享友人
分享到 Line

分享到臉書