有限樣本分佈 的英文怎麼說

中文拼音 [yǒuxiànyàngběnfēn]
有限樣本分佈 英文
finite sample distribution
  • : 有副詞[書面語] (表示整數之外再加零數): 30 有 5 thirty-five; 10 有 5年 fifteen years
  • : Ⅰ名詞(指定的范圍; 限度) limit; bounds Ⅱ動詞(指定范圍, 不許超過) set a limit; limit; restrict
  • : Ⅰ名詞1. (形狀) appearance; shape 2. (樣品) sample; model; pattern Ⅱ量詞(表示事物的種類) kind; type
  • : i 名詞1 (草木的莖或根)stem or root of plants 2 (事物的根源)foundation; origin; basis 3 (本錢...
  • : 分Ⅰ名詞1. (成分) component 2. (職責和權利的限度) what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] (料想) judge
  • 有限 : limited; restricted; finite; a little; not much
  • 樣本 : sample book; specimen; advanced copy; sample; muster; scantling; instance; statistics
  1. Firstly, by numerical and theoretical analysis, the author compares some existent confidence intervals, for example, " exact " confidence interval, wald confidence interval and bayesian confidence interval, and finds some deficiencies points of the confidence intervals, whose modification version has been proposed. also, several better confidence intervals such as are also presented. secondly, for given confidence coefficient and interval width, the author constructs a class of asymptotical two - stage interval estimate procedures. at the same time, under varies restriction of confidence coefflcientent interval width, the optional sample size of the first stage has been computed by numerical computation. the numerical computation shows that the method considered in this dissertation have good properties and applied value

    同時,由於poisson的特性,我們知道不存在其參數區間長度小於0 . 5的置信區間,基於這些情況,我們主要展開了以下兩個方面的研究:一是利用數值計算析與理論析的方法對現的若干置信區間如「精確」置信區間, wald置信區間, bayes置信區間等進行析比較,發現了一些缺陷,針對這些缺陷,我們進行適當的修正,並得到幾種性質較好的置信區間如:修正大區間jeffreys原則下置信區間二是針對已給定的置信系數與區間長度,我們提出了一種漸近的兩階段區間估計程序,並利用數值計算的方法,在各種置信系數與區間長度定下,算出了最優的第一階段觀測次數(抽量) ,大量數據表明,文考慮的方法性態良好,具應用價值。
  2. Based on nonlinear finite element theory, stress and deformation behaviors are analyzed after ground stabilization and foundation pit reinforcement with deep mixing method. by comparison of the conditions of treatment and non - treatment of two examples respectively, the results indicate that the match ratio scheme used for deep mixing method is more ideal when soft clay is stabilized in this area of fuzhou in the thesis. this scheme not only can fully utilize industrial waste material, but also can economize construction cost

    對于加固土的工程特性,文以非線性元理論為基礎,模擬析水泥攪拌樁加固地基和基坑支護加固的應力和變形情況;通過兩個例子別在處理和無處理情況下的對比,利用固化劑最佳摻入比來設計地基處理方案,並運用非線性元方法計算出土體內大小主應力的情況以及變形情況,結果表明文所得出的配合比方案用於深層攪拌樁法來對福州地區軟粘土進行地基加固時還是比較理想的,這不僅充利用工業廢料,還可節約工程造價。
  3. Against a prototype which is being produced , its three dimension end region entity model of stator is established , and with the aim of simplifying calculation , the theory of how to simplify entity model is studied , then the theory is made use of , and the end region entity model of stator is simplifi - ed ; meshing characteristics of three dimension entity model and shortcomin - gs of end region entity model of stator are studied , then meshing method of three dimension end region entity model of powerformer stator is studied as well , and the simplified entity model is meshed with this meshed model , the distribution of end region magnetic field of stator is analyzed , and the magnetic field energy and reactance of powerformer end region are calculated and compared with design value because the prototype is being produced , in this paper , stator core , gap and eddy equipment are not taken into consideration , and this has a little influence on the result , but through analysis , the result is proved to be good through the example calculation , it is known that the method of this paper is useful and through theoretic analysis , it is proved that end region

    針對一臺生產中的機,對其建立了定子端部三維實體模型,而且為了達到簡化計算的目的,研究了如何將其簡化的理論,並應用這些理論對機定子端部實體模型進行了簡化;研究了三維實體模型的剖特點和定子端部實體模型存在的缺點,在此基礎之上,研究了對簡化的powerformer定子端部三維實體模型的剖方法,並且對簡化的實體模型進行了剖。應用剖的三維實體模型,用元法析了powerformer定子端部的磁場,計算了端部區域的磁場儲能,並利用磁場儲能計算了powerformer定子端部漏抗,將計算值與設計值進行了比較、析。由於機處在設計生產階段,文暫時沒考慮定子鐵心、氣隙和渦流器件對端部磁場的影響,這對析結果一定的影響,但是仍然得到較好結果。
  4. However, the si3n4 is non - crystalline when power is 100w or 150w. the agglomeration and the distribution were important parameter of nanopowder, which were analyzed by the laser light scattering particle - size test instrument. but the result appeared great error because of this instrument itself and high requirement to sample

    粒徑和團聚是納米粉體材料重要的表徵手段,採用激光散射技術對納米氮化硅粉末粒徑的和團聚進行析,激光散射技術由於身的制和對品的高要求,測量納米材料的較大的誤差。
  5. Sampling methods for common distributing random numbers and the samples of random fields are proposed. combining the monte - carlo simulation technique with the one - dimensional discretization finite element method, the monte carlo - finite element method for stochastic analysis and the reliability computation of thin - walled box girders are proposed in this thesis

    建立了幾種常用隨機數以及隨機場隨機的產生方法;將蒙特卡羅數值模擬與薄壁箱梁一維離散元法相結合,提出了薄壁箱梁隨機析和可靠度計算的蒙特卡羅元法。
  6. This dissertation concentrates on the difficult problems that the pipeline or pipe defects are not estimated or evaluated quantitatively, intelligently by mfl ( magnetic flux leakage ) inspection method. from the practical demand, theoretical analysis and experiments or testing, the mfl inspection technology of pipeline or pipe defects are explained, summarized in detail in the whole paper, at the same time, the relationship between the mfl field distribution, the mfl signal shape and the defect geometry or severity, the analysis of the mfl data and the compensation of influencing the relationship factors, signal feature extraction, intelligent recognition of defect parameters and so on are studied systematically

    論文針對管道(鋼管)缺陷漏磁檢測定量化、智能化的難題,緊密結合檢測現場實際需要,通過理論析和大量實驗,系統析總結了管道(鋼管)缺陷漏磁智能檢測技術,並在缺陷漏磁場以及缺陷漏磁信號與缺陷外形參數間的關系、缺陷漏磁信號析、漏磁信號影響因素補償、缺陷漏磁場波形特徵提取和缺陷外形尺寸定量識別等方面進行了深入研究,主要成果和創新如下:引出磁偶極子模型近似析常見缺陷漏磁場,針對磁偶極子模型的不足,將元方法應用到缺陷漏磁場析,實現了常見管道缺陷漏磁場的模擬。
  7. However, rank vector of multi - dimensional sample based on depth function has something to do with depth function and underlying distribution, which limits its practice

    而多維的基於深度函數d的秩向量與深度函數和總體關。這使得它的應用受到制。
  8. Then, this paper empirically tested the validation and predictive accuracy of different var risk management model in the domestic financial market. finally, with the analysis of modem financial risk management development trend and the current domestic financial risk management situation, this paper made a prospect for the application of this model in the construction of domestic financial risk management system. through the analysis, the main conclusions are as follows : ( l ) the traditional mean - variance model is the special example of the portfolio selection based on the var risk management model for the case that the returns of the portfolio are assumed to be normally distributed ; compared with the mean - variance model, the var risk management model is more comprehensive and accurate in the measurement of the portfolio risk, so based on the var model, the investors can allocate the asset more effectively. ( 2 ) the var risk management model can provide the timely and comprehensive risk information for the top risk manager, so it is very helpful to the improvement of total risk management efficiency. ( 3 ) based on the var model, the raroc performance valuation approach can reflect the real performance of the portfolio manager and provide the coherent standard for the allocation of risk limitation and the construction of the incentive compatibility constraint mechanism in the financial instiutions

    通過研究析,文主要得出如下結論: ( 1 )傳統的markowitz均值? ?方差模型僅僅是在資產組合收益率正態假設條件下基於var風險管理模型進行資產組合選擇的特例,與均值? ?方差模型中的方差風險度量方法相比, var風險管理模型能夠更全面、更貼切地衡量資產組合的風險,且基於此模型能夠更效地進行資產配置決策; ( 2 ) var風險管理模型能夠滿足更高層次風險管理者對風險信息的需求,助於整體風險管理效率的提高; ( 3 )基於var風險管理模型的raroc績效評價能夠反映資產組合管理人的真實業績,從而為金融機構風險額的配和激勵約束機制的制定提供統一的標準; ( 4 )國內證券市場資產組合收益率服從正態的假設明顯不成立,實證檢驗表明基於資產組合收益率正態假設條件下的方差? ?協方差模型對國內資產組合風險的預測存在較大的偏差,由於文中證明在收益率正態假設條件下基於方差? ?協方差模型進行資產組合選擇的結果等價于markowitz的均值? ?方差模型,因此,均值? ?方差模型對國內資產組合風險的預測同會存在著較大的偏差,而半參數var風險管理模型則能夠取得較好的預測衡量效果; ( 5 ) var風險管理模型符合未來金融風險管理的發展趨勢,基於var風險管理模型建立內容提要風險額內控體系、風險信息披露體系和業績評價體系,並進行金融監管,將助於國內金融機構內部風險管理方法和外部監管技術跟上國際金融風險管理的發展潮流。
分享友人