板內的 的英文怎麼說

中文拼音 [bǎnnèide]
板內的 英文
intralamellar
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 內 : 名詞1. （內部; 里頭; 里邊） inner; inside; within 2. （妻子或妻子的親屬） one's wife or her relatives 3. （姓氏） a surname
  • 的 : 4次方是 The fourth power of 2 is direction
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Wherethe long bridge deck within 0. 5 l amidships is regarded as strengthdeck, the midship section modulus and minimum thickness of the deckplating comply with the requirements of 2. 2. 1 and 2. 4. 2. l of this ischapter

    例1 :在船中部0 . 5l區域內的長橋樓甲板作為強力甲板時，其船中剖面模數及最小厚度應滿足本章2 . 2 . 1及2 . 4 . 2 . 1的要求。
  3. Based on the previous research on the portal crane administration, one standpoint put forward in this paper is idea that is on the foundation of reliability in this paper, two viewpoints take shape when reason is analyzed, that is fatigue break and appearing the flaw that will extend. what is the fatigue break ? ( this phenomenon is always happen in some place ), the fatigue is that board appears apophysis and concave when the board is pressed. so that the board ability of bearing the weight of load will descend

    本論文建立在已有的港口裝卸機械管理的研究基礎之上，進一步提出了以可靠性為基礎的港口裝卸機械的管理思想，已有的研究表明，港口機械設備破壞主要由於兩個原因，第一是穩定性問題，特別是構件的局部穩定性，所謂穩定性是指：在板的平面內，板受到平行於板面的壓力作用，使板發生隆起、內陷等凹凸不平的結果，從而使板受載能力減弱；第二是結構出現疲勞裂紋及其擴展，這是由於設備長時期運行，而造成設備某些部位出現裂紋並得以擴展，使設備承載能力下降。
  4. Fine drops of oil were sprayed into the space between the plates by an atomizer.

    利用噴霧器把細小的油滴噴入極板間的空間內。
  5. Static mathematic model of drum accommodation and control is presented, and instruction model control strategy of sample intervals is presented based on differences between characteristic equations of lifting frame and characteristic equations of top and bottom board change among the sampling spots, the rules of this method are few, simple, easy to operate and meet controlling demands

    給出了滾筒調控靜態數學模型，並根據調高機構的調控特徵方程與采樣點間頂底板變化特徵方程的差異，給出了在其采樣區間內的指令式控制策略，其方法的規則條日少、簡單易運算、符合實際控制要求。
  6. Qinling fold belt is located at the junction of the north china plate and the yangtze plate, and its portion in henan province is a part of the east qinling mountains ( eqm )

    摘要秦嶺褶皺帶位於華北板塊和揚子板塊結合部位，其在河南省內的部分多劃為東秦嶺。
  7. Chagan sag is a secondary tectonic unit in chagandelesu depression, northeastern yingen - eji ' naqi basin, and the basement of the basin is a paleozoic fold belt of continental margin or island arc at the connection region of north china plate * tarim plate and kazakstan plate, with the character of erogenic belt. in working area and its adjacent area, the forming tectonic setting of indosinian intrusion was that orogenic belt pressed strongly, intracontinental subduction ; that of early yanshan movement epoch was the stress field transferred from compression to extension meanwhile the incrassate crust of orogenic zone turned to extensional collapse ; and that of early cretaceous volcanics was that the area structure extensional collapse further more during the post period of orogenic phase

    查干凹陷屬于銀根?額濟納旗盆地東北端查干德勒蘇坳陷內的一個次級構造單元，其盆地基底為古生代時期華北板塊、哈薩克斯坦板塊和塔里木板塊交接部位形成的陸緣或島弧褶皺帶，具有古生代造山帶的性質。研究區及鄰區印支期侵入巖形成於造山帶強烈擠壓陸內俯沖的構造環境；燕山早期侵入巖形成於由擠壓轉向拉伸、造山帶的增厚陸殼開始發生伸展垮塌的構造環境；早白堊世火山巖形成於造山期后進一步發生伸展垮塌的區域構造環境。
  8. Chagan fault depression is a secondary tectonic unit in chagandelesu subbasin, northeastern yingen - ejinaqi basin, and the basement of the basin is a paleozoic fold belt of continental margin or island arc with the character of erogenic belt at the connection region of north china plate, tarim plate and kazakstan plate

    查干德勒蘇凹陷屬于銀根?額濟納旗盆地東北端查干德勒蘇坳陷內的一個次級構造單元。其基底為古生代時期華北板塊、塔里木板塊和哈薩克斯坦板塊交接部位的陸緣或島弧褶皺帶，具有古生代造山帶的性質。
  9. The early years saw only the manufacture of a neat plaster that was used for internal cladding of walls and ceilings.

    頭幾年人們只生產一種用於墻壁和天花板內部裝潢的凈粉飾。
  10. In the study of the lumber carrier, one of the very important problem is the in spot and ultimate station due to flooding which will bring tremendous threat to the ship because of the few holds in order to study the lumber carrier buoyancy, stability and longitudinal strength under the condition of flooding, the paper adopt fundamental ship principle and iterative and accumulative concept on the basis of insumersibility theory to detailedly calculate the flooding speed flooding amount front draft after draft stability and longitudinal strength considering the ship " s sinking and inclination which will change the center of gravity and the loading station both in hold and on deck and the effect of flooding and lumber amount in holdo in the last, the paper introduces an example of the actual ship named " fei yun ling " and makes a contrast between not taking measure and taking measure which draws a reasonable conclusion and comes up to some advice the method avoids the cockamamie calculating while insures enough precision the paper draws a conclusion that not all the lumber carrier will submerge when suffering the damaged flooding if the loading or measure is suitable

    為了研究運木船舶在破艙狀態下的浮性、穩性和強度，本文在抗沉性理論的基礎上，運用船舶基本原理，採用了迭代和累計的思想，將船舶的進水過程劃分為很多次進水的積累，詳細計算了運木船在破艙進水的過程中，考慮到各種破艙參數、船舶本身的下沉、艙室內木材、甲板貨的裝載情況和在進水過程中船舶本身的傾斜對進水重心的影響，以及艙室內的進水量和木材對破口處進水速度的影響，船舶總的進水速度、進水量、首尾吃水、穩性的實時狀態和最終船舶的總縱強度，給出了計算實例，並進行了在採取用泵抽水前後浮態參數的對比，得出了該船舶在艙室內的貨物積載量達到某個數值時可以保證船舶在破艙進水時不會沉沒，或者在當開口小於某數值時，採取適當的措施后，可以使船舶避免沉沒。
  11. The measuring and filtering apparatuses have the same cpu board including the network port, serial port, external ram and flash. an additional cpld is added for further function expansion

    檢測儀和分選儀的cpu板採用相同的設計，板內的可用資源有網口，串口，外部ram ，外部flash等等。
  12. To build a table, matrix, or chart report, use a report layout template that contains predefined data regions and select a predefined report model, which contains report items such as data fields, then drag and drop the report items onto the data regions within the template

    若要生成表、矩陣或圖表報表，請使用包含預定義數據區域的報表布局模板，並選擇包含如數據欄位等報表項的報表模型，然後將不同報表項拖放到模板內的相應數據區域中。
  13. Frames can be reordered in the animation palette by clicking on the frame you want to move and dragging it to the desired location

    位於動畫控制面板內的幀可以被重新排序。你可以點擊指定幀並將其移動到你所希望的位置。
  14. [ if ! supportlists ] - - > 6. < ! - - [ endif ] - - > frames can be reordered in the animation palette by clicking on the frame you want to move and dragging it to the desired location

    位於動畫控制面板內的幀可以被重新排序。你可以點擊指定幀並將其移動到你所希望的位置。
  15. Comparing its results with those by ls - d yna, the accuracy of this algorithm was presented. moreover the failure process in concrete due to impact loading and the failure process of a steel bullet penetrating a concrete circular plane was demonstrated, which presented the dynamic transitional process from continuum to non - continuum. several different fundamental damage forms simulated by using this algorithm were discussed, comparing with the results from experiments

    應用該模型對正交各向異性平板內的應力波傳播、沖擊載荷下混凝土平板的破壞以及鋼彈侵徹混凝土圓板的破壞問題進行了研究，通過將計算結果與ls - dyna 、特徵線法以及實驗結果進行對比，證明了該模型的精確性和可靠性。
  16. For information about using power options, see help in control panel

    有關使用電源選項的信息，請參閱控制面板內的幫助。
  17. If users press enter while typing in a text box inside the panel, it has the same effect as if the user had clicked the specified default button

    如果用戶在面板內的文本框中進行輸入時按enter ，這與用戶單擊特定的默認按鈕具有相同的效果。
  18. A high degree of continuity can be achieved just providingthe slab with rebar running along the column. furthermore, stiffness and ultimate resistancecan be controlled in a rather simple way by a suitable selection of steel connection detailingand amount of reinforcement

    這種組合節點可以通過混凝土板內的縱向鋼筋實現組合梁在不同跨之間的連續性，而且通過選擇合適的型鋼樑柱連接方式和縱向鋼筋數量，可以有效地控制節點的剛度與承載能力。
  19. The study on the behavior of semi - rigid joints in steel - concrete composite frames gets widely attention recently. a high degree of continuity can be achieved at a very low cost just providing the slab with rebar running along the column. furthermore, stiffness and ultimate resistance can be controlled in a rather simple way by a suitable selection of steel connection detailing and amount of reinforcement

    鋼-混凝土組合框架中半剛性組合節點性能的研究近來引起了廣泛的關注，這種節點形式花很低的成本就可以通過混凝土板內的縱向鋼筋實現組合梁在不同跨之間的連續性，而且通過選擇合適的型鋼樑柱連接方式和縱向鋼筋數量，可以有效地控制節點的剛度與承載能力。
  20. Commercial building telecommunications cabling standard - addendum 5 - in - floor systems

    商用建築物電信布線標準.補充件5 .地板內的系統
分享友人
分享到 Line

分享到臉書