柱式法 的英文怎麼說

中文拼音 [zhùshì]
柱式法 英文
column method
  • : 名詞1 (樣式) type; style 2 (格式) pattern; form 3 (儀式; 典禮) ceremony; ritual 4 (自然科...
  • : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
  1. On the basis of expound the theory of building exterior - protected construction energy consumption and the gene of influence the building energy, set up mathematics model, this article discuss the mechanism of dispelling the heat of the buildings " thermal bridge and the complication that influence it, and then synthetic analysis and calculate the influence range of building thermal bridge in exterior - protected construction column thermal bridge to the building outer wall get the conclusion that when the construction column can satisfy the building stress - area, in bulgy construction column dispel less heating than out bulgy construction column. but if the pole stuck out more than 100mm, in bulgy or out bulgy make no difference

    本文在闡述建築圍護結構耗熱原理以及影響建築能耗因子的基礎上,採用數值模擬方,探討了建築熱橋傳熱的基本機理和影響建築熱橋傳熱的因素,進而對建築熱橋在圍護結構傳熱中的影響范圍進行了綜合分析和計算,研究了構造熱橋型對建築外墻能耗的影響,得出了構造在滿足建築受力面積要求的情況下,內凸構造較外凸構造略能減少散熱量的結論,但是凸出過大( 100mm )無論內凸還是外凸對建築耗熱都沒有大的差別。
  2. Oils of calamus. determination of cis - beta - asarone. gas chromatographic method on packed column

    菖蒲油精.順細辛腦含量的測定.填充氣相色譜
  3. In the course of working, , the plow will make use of the shuttling method so that it can dig alternately either on the left or on the right. compared to the unilateral plow, it can improve the productivity because it can help leave off the soil 、 take from the consumed energy and reduce the empty journey. to meet the requests above, we will use a remote cylinder with both a small cubage and double functions, approximately designing the plow to be columniform and symmetric. after the experiment for a period in the field, we found that the most frayed areas had happened at the places of both plow shank and share and at the same time the base of the remote cylinder had ruptured suddenly

    與單向犁相比,其優點在於:耕地無開、閉壟,地表平整,降低了耕后整地的能量消耗,減少了地頭的空行程,因而大大提高班次生產率。為了滿足犁體梭作業的要求,我們採用了一隻小容積雙作用的液壓油缸;同時對犁壁曲面的形狀採用了近似圓形的對稱設計。但經過一段時間的田間試驗,我們發現:該犁犁胸部分的犁脛和犁鏵上的犁尖在工作中磨損較為嚴重;主犁梁和油缸缸體的連接部分(即油缸底座)突然發生了斷裂,造成整個犁體無正常工作。
  4. It is unlawful to injure a football goal post, doing so is punishable by a $ 200 fine

    毀壞美足球門是違的,這種行為可處以200美元的罰款。
  5. By physiognomy feature, it could be divided into three types of thermal structure : positive dome model, negative collapse model and border dome core collapse model. based on the depth degree or magma - thermal influenced, it could be divided into five types of thermal structure : ( ancient ) geothermal anomaly focus region model, superficial volcano eruption hydro - thermalism and hypabyssal intrusive model, thermal anticline ( thermal dome ) model, mid - deep intrusive model, deep mantle ( crust ) thermal plume model ; and put forward a perfect model of the thermal structure. there are many interaction system could be induced into a systematic thermal interaction, include : ocean - continent system, basin - mountain interaction, superficial and mid - deep crust - mantle interaction, crust - mantle commingle interaction, vertical thermal interaction ( delamination ) etc.

    依據地貌形態分為三類:正向穹窿型、負向塌陷型、邊隆核陷型:依據巖漿-熱力作用影響的深淺程度或深度分為五類: (古)地熱異常群集區、表淺層火山噴發-熱液活動與淺成侵入型、熱力背斜(熱穹窿) 、中深層侵入型、深部地幔(地殼)熱型;提出了熱力構造作用空間分佈的理想模,將洋陸系統、盆山作用、淺表與中深部殼幔作用、殼幔混合、垂向熱力作用(拆沉)等納入一個整體統一的熱力作用系統中,為盆地動力學研究打開了一個新窗口;研討了熱力構造研究方
  6. This paper explores physical essence of overrunning clutch torsion stiffness, builds torsion stiffness mathematical model and give calculation method of torsion stiffness in miler overrunning clutch

    摘要分析了滾超越離合器扭轉剛度的物理本質,建立扭轉剛度的數學模型,給出了滾超越離合器扭轉剛度的計算方
  7. The research works finished in this paper are listed below : 1. solving the problem in testing of cylinder vessels that the sensors disposition is very rigorous, carrying out study of freewill triangle network orientation and linear orientation, bringing forward the discriminance which distinguish the validity of orientation array using character string method the first time, at the same time, solving the problems that judgement of orientation array, elimination of camouflage location, avoidance of repeat location, etc. 1 '. carry ing out the study of the orientation of defects in stand lank floor with the method of freewill planar triangle orientation, advancing bran - new discriminance on the validity of orientation arrays, orientation points, and the disposing means of the acoustic sources near sensors and those near common border

    本文進行的主要研究工作有: 1解決容器檢測中傳感器排布要求較嚴格的問題,開展任意三角形網路排布檢測技術與線定位技術研究,首次提出了利用字元串格判斷線定位陣列有效性的判別方,並解決了任意三角形定位中存在的定位陣列判斷,偽定位的剔除,重復定位的避免等一系列問題; 2利用平面任意三角形定位方開展常壓立儲罐罐底缺陷定位技術研究,提出了全新的定位陣列有效性判斷、定位點的有效性判斷方;以及頂點聲源和邊界聲源的處理辦
  8. In kangding garden, people can see pseudo - roman columns, small french balconies and baroque curves

    在康定花園中,可以看到仿羅馬子、的小陽臺和巴洛克的弧線。
  9. Wet - process - porcelain insulators - high - voltage line - post type

    瓷絕緣子.高壓線路
  10. Pillar method of stoping

    采礦
  11. Three circumstances on the geometric non - linear analysis are considered : the sag phenomenon of cables the nonlinear behavior of bending members and the geometry change due to large displacement. the non - linear behavior of cables is verified by introduced the ernst cable modulus of elasticity and cr formation is applied to analyze the non - linear of beams. an incremental - iterative method based on the newton - raphson method is adopted here to solve the non - behavior equations

    幾何非線性分析主要考慮三個方面:索的垂度效應、樑效應和結構大位移,其中:索的非線性分析採用ernst彈性模量對索材料的彈性模量進行修正,計及索的垂度效應的方;梁單元的非線性分析採用cr列,計算中採用基於newton - raphson的增量迭代方求解非線性方程組。
  12. Analysis on developing new room and pillar mining method in shendong coalfield

    神東煤田發展新型房採煤方的分析
  13. Probing into roof - fall law of room - and - pillar and heading - and - stall systems

    和巷採煤方頂板冒落規律的探討
  14. A probe into the calculation method on coping ' s internal force of pillar pier

    橋墩蓋梁內力計算方探討
  15. Pillar and breast method

    井采
  16. Walking aids manipulated by one arm. requirements and test methods. part 4 : walking sticks with three or more legs

    單臂使用的助步器.要求和試驗方.第4部分:三或多助步手杖
  17. Heading and stall method

    開采
  18. Technical analysis on feasibility of new room and pillar mining method

    新型房採煤可行性技術分析
  19. Post and stall

    採煤
  20. This article analyzes some regulations for safety steering column, discusses the distribution of crashing energy and the structures and the safety control principls with flex steering shaft, breaking steering shaft, sleeve steering pillar tube as well as ripples tube steering pillar tube

    摘要分析了安全轉向規要求,汽車碰撞能量的分配,伸縮轉向軸、可斷開轉向軸、套筒轉向管、波紋管轉向管等的結構和安全控制原理。
分享友人