柵調放大器 的英文怎麼說

中文拼音 [zhàdiàofàngdàqì]
柵調放大器 英文
grid-modulated amplifier
  • 柵 : 柵名詞（柵欄） railings; paling; palisade; bars
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 放 : releaseset freelet go
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 放大器 : amplifier; pantograph; lawnmower; enlarger; magnifier
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. 2. the input stages of the ccii and the operational amplifier in transimpedance implifier are realized with folded cascode amplifier to reach high cmrr, large open loop gain and low offset

    2 .為了提高儀表放大器的電源抑制比，並得到大的開環增益，相對低的失調等性能，電流傳輸器的輸入級和跨阻放大器中運算放大器輸入級均採用折疊共源共柵放大器。
  2. ( 3 ). the flattening arithmetic of an edfa was presented based on the inter - correlative function between the gain spectrum function of the edfa and that of the reserve transmission spectrum of the lpfg. for optimal matching between the two spectra, the flattening arithmetic calculates the variation of the resonant amplitude and wavelength of the lpfg

    Iii .提出了一種動態增益均衡的平坦演算法，這種演算法的本質就是利用摻鉺光纖放大器增益譜函數和新型長周期光纖光柵的透射譜反轉譜函數的相關性，給出新型長周期光纖光柵諧振峰幅度和位置的調節量，使改變后的新型長周期光纖光柵的反轉譜線能和edfa的增益輸出譜線進行最佳匹配。
  3. The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier

    本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。
  4. In succession, the theory of chirped - pulse amplifier system is given in detail, firstly, studying from designing experimental light road and optical components to theoretical analysis, we par ' tly finished the system by ourselves. about ultr a - shoft pulse with a pulse - width of 9. 8f s and output power of 650mw and band - width of about l 20nm is output from oscillator source, secondiy, the stretching capacity of single grating four - pass stretcher is measured using abcd matrix combining collins function, and the effect of relativ e parameters to the streching ratio is also simulated. thirdly, a new type of disjunctional frequency moduiating function is provided according to the gain - narrowing and gain - saturation which are appeared in the co urse of amplification, under modulating the two effects are both controlled on some e xtent, fourthiy, the effect of ase that is often ignored by people is analyzed and the resolving methods are also given

    從光路、光學元件的自行設計到理論分析計算，初步建立了一臺實驗系統；採用abcd矩陣法結合collins公式計算了四通式單光柵展寬器的展寬量，並模擬了相關參數對展寬比的影響，對實驗具有指導意義；評價了再生放大器和多通放大器的優缺點，對放大過程中通常忽略的放大自發輻射現象（ ase ）進行了分析，並提出了相應的解決方法；針對放大過程中出現的增益窄化和增益飽和現象，對輸入種子脈沖提出了一種新的分段頻率調制函數，實現了對增益窄化效應和增益飽和效應的共同抑制；提出了系統的材料（包括放大介質和光路中的普通介質）正是融合高階色散的來源。
  5. According to the following design theory : the dsp calculates in real time and produces three phases spwm waves to control the on or off of the 6 igbts in ipm respectively. ipm then inverts the commutated single phase direct current ( insulated gate bipolar transistor ) into three phases alternating current. when modulated signals of spwm are changed, the on - off time of switches also changes, so as to the voltage and frequency of output signals

    本文提出了一種基於dsp （數字信號處理器tms320f240 ）的通用的三相間接變頻電源系統，利用分段同步調製法和混合查表法，實時計算不同頻率下的采樣周期、電壓幅值、輸出脈寬，產生雙極性spwm波形，經驅動放大後用于ipm （ intelligentpowermodule ）中的絕緣柵雙極型晶體管柵級驅動，以控制電源的輸出電壓和頻率，實現變頻電源的智能數字控制。
分享友人
分享到 Line

分享到臉書