校對系統 的英文怎麼說

中文拼音 [jiàoduìxìtǒng]
校對系統 英文
proofreading system
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 對 : Ⅰ動詞1 （回答） answer; reply 2 （對待; 對付） treat; cope with; counter 3 （朝; 向; 面對） be tr...
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 校對 : 1 （核對） proofread; proof; revision; check; collate2 （校對人） proofreader3 （核對是否符合標準...
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. Computer - aided chinese proofreading system

    計算機輔助漢語校對系統
  2. Angular calibration of radar antenna system is composed of the calibration of angular error sensitivities ( also called directional sensitivity ), adjustment of cross - coupling of azimuth and elevation signals, and the calibrations of system errors such as antenna axial system error, dynamic delay and so on

    雷達系統天線的角度標校包括對系統角誤差靈敏度（又稱定向靈敏度）的標定、方位俯仰信號交叉耦合的調整以及對天線軸系誤差、動態滯后等系統誤差的標定。
  3. The main steam pressure control system, bed temperature measure system, bed temperature adjust system and action condition of ham fuel trip ( mft ) are analyzed

    對主蒸汽壓力控制系統、床溫側量系統、床溫校正系統和主燃料跳閘的動作條件進行了詳細的分析。
  4. The principle and the mechanical structure of the air - gap inductance - type transducer are analyzed in this article, and the static parameters are calibrated. dynamic calibration is applied to air - gap inductance - type transducer which is not good in dynamic capability, to obtain the dynamic parameters of the transducer and its measuring circuit. based on the result of the dynamic calibration, the transducer and its serving circuit are modeled so that the method of how to improve the dynamic performance can be found

    本文對現有氣隙式電感傳感器在原理和機械結構上作了深入的分析，對其參數進行了靜態標定；並且針對常規電感傳感器動態響應低，不宜用於快速動態測量的缺點，引入測試系統動力學的思想，設計了一套動態校準系統，對現有傳感器進行多次動態校準，根據動態校準的實驗結果對現有傳感器建立數學模型，得到現有傳感器的動態特性；在此基礎上，根據磨床工件在線檢測的要求，設計一個硬體補償系統來提高整個測試系統的動態特性。
  5. In chapter 4, the improvements of automation by developing the high performance vcs controlled by pc are stated, which include the hardware system of vibration measured control instrument ( vmc ), the software system of vcs and the virtual device driver programme ( vxd )

    第四章著重介紹了高性能微機控制校準系統的開發及對校準精度和自動化程度的影響。主要開發了振動校準裝置測控儀硬體系統、振動校準測控軟體系統以及vxd虛擬設備驅動程序。
  6. The results of experiment verified the simulation of pspice software. in chapter five, the technology requirements of vibration calibration system are introduced, and thus the optical and electric design are realized. the laser - vibration - measuring - system is tested and the results are analyzed

    第五章介紹了振動校準系統對測振儀的技術要求，實現了相關光路和電路的設計；對系統進行測試，並對實測結果進行分析；最後對系統的誤差進行了分析。
  7. Resistance welding - welding current measurement for resistance welding - calibration system

    電阻焊.電阻焊的焊接電流測量.校對系統
  8. Research on and implementation of chinese text proof - reading system

    中文自動校對系統的研究與實現
  9. At last, the composition and critical technique of chinese text automatic proofreading system are given

    給出了中文文本自動校對系統的組成及關鍵技術。
  10. This paper presents a method of improving on frame & horizontal synchronization in laser phototypesetter, by using singal - chip computer system to detect real - time frequency deviation and adjust film transmission speed

    摘要提出了一種在激光照排機電控系統中，利用單晶片微機對轉鏡掃描光柵頻率信號的暫態波動量進行檢測、提取，並以此實時校正系統輸片速度，實現場掃描對行掃描的跟蹤、補償，從而提高行、場掃描同步精度的方案。
  11. Besides, the process of transferring the control center is certain to affect system operations. limiting this effect is an important topic to discuss from the points of view of design, construction and testing

    且行控中心於移設過程中將涉及系統營運監控作業移轉之問題，其間如何降低對系統營運之干擾，值得從系統設計、施工、及測試調校作業之安排進行探討。
  12. When unknown and bounded disturbance, parametric uncertainties and unmodelled dynamics exit at the same time, the system will automatically tune regulator parameters so as to guarantee robustness of speed synchronized control system and achieve indirectly position synchronized control

    對未知有界擾動、參數變化和未建模動態採用h _魯棒自校正調節器控制，可根據環境與特性變化自動整定調節器參數，有效抑制擾動、參數變化和未建模動態對系統同步性能的影響。
  13. Firstly establish it mathematical modal, research the affect of the system character by the system parameter and bring forward the method improving system character when the load is outside power

    在建立精校機電液位置伺服系統數學模型的基礎上，當負載為外負載力時，研究了系統參數對系統性能的影響，提出一些改善系統性能的方法。
  14. Because of high requirement of maneuverability for the system, the beforehand emendation in apt technology has been analyzed with great exertion in the last part of the thesis

    由於在擬用環境中對系統機動性要求較高，因此本文著重對apt技術中的超前校正進行了分析。
  15. Other imperfections are due to the practical limits to which correction can be made for systematic effects, such as offset of a measuring instrument, drift in its characteristics between calibrations, personal bias in reading an analogue scale or the uncertainty of the value of a reference standard

    其它非理想性因素是由於對系統效應的修正產生的實際限制，比如測量儀器的誤差，兩次校驗之間的性質偏移，個人讀取量數的偏差或者參考標準值的不確定性。
  16. 6. since the monitor precision of quasi - dynamic calibration system is very important, the model of the four channel electric pressure - measuring system in frequency domain is built up. the cause of variance is analyzed. the error function of the system is defined and the formula of correcting the system error is derived

    6由於落錘液壓動標裝置校準系統的校準壓力監測精度極為重要，本文對四路電測壓力系統進行頻域建模，分析了產生不一致的原因，定義了系統的誤差函數及推導了統一誤差模型的修正公式。
  17. A checksum system is used for each piece. when you specify the 4 edges correctly, it ' s border will turn from red to green

    有一個校驗系統自動對每一個方格進行檢查。當您把每個方格的顏色配置正確后，方格的邊界線將由紅色變為綠色。
  18. Finally, the paper validated five verifying means in actual statistics data and summarized the things which should be noticed, the further researches directions. key words : verifying statistics data, role, test

    最後用一些實際的統計數據對本系統進行驗證和測試，並對校驗系統的現存問題及今後的研究方向作了總結。
  19. Special investigation check : to check and recognize the overall data in different levels with the some accurate data which the investigate team has got i have developed a verifying statistics data software combined with the five methods mentioned above

    5專項調查校驗：用調查隊調查的局部準確數據對層層匯總的全面數據進行校驗識別。文中結合統計數據校驗的五種方法編制了一套統計數據校驗系統軟體。
  20. One dimension river flow roughness parameter inverse analysis kalman filter is introduced into the model to solve stochastic error in observed data. applying kalman filter automatism revising system, dynamic roughness course is obtained. using dynamic roughness course the model result precision is improved, it is more consistent with observed data

    對於一維河道糙率參數反分析，針對觀測資料存在的隨機誤差，引進卡爾曼濾波器的自動校正系統，求解出河道糙率變化的動態過程，使用動態糙率計算，明顯改善模型的模擬精度，使模擬過程和觀測過程很好吻合。
分享友人
分享到 Line

分享到臉書