校正量 的英文怎麼說

中文拼音 [jiàozhēngliáng]
校正量 英文
calibrating data
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 校正 : check; correction; adjust; revise; proofread and correct; rectify; calibrate; make true; master c...
  1. The dc ammeter will normally be calibrated at full range in each range

    直流電流表一般每程均作全量程校正。
  2. For single - range voltmeters, calibration will be made at cardinal points ( maximum 5 points )

    單量程電壓表將就其基點進行校正（最多不超過五點） 。
  3. For single - range voltmeters, calibration will be made at cardinal points ( normally not exceeding 5 points )

    單量程電壓表將按主要基點進行校正（一般最多不超過五點） 。
  4. Single range voltmeters are normally calibrated at cardinal points ( maximum 10 test points ). for multi - range voltmeters, the basic calibration will include measurements at full ranges and linearity check at 5 voltage levels for one range. linearity check for other ranges can be offered at extra cost

    單量程電壓表一般以基點（最多十個測試點）進行校正；多量程電壓表的基本校正則會包括全量程測量及按五個電壓量位為一個量程進行線性檢查。
  5. The energy centrobaric method is made use of correcting the doppler spectrum, the simulation predicted value of the target velocity is obtained

    用能量重心校正法對多普勒頻移校正，進而得到物體的運動速度的模擬計算值。
  6. Due to existing signal processing technology ’ s shortage such aslow measurement, narrow measurement range precision and other poor performance, we introduced a high - precise signal processing technology : firstly, to get power spectrum with hanning windowed welch modified periodogram, search its peak value frequency ; secondly, to apply zooming analysis via goertzel algorithm ; at last, to get a highly precise doppler frequency with energy centrobaric rectifying algorithm 。 the simulating result indicated that this technology introduced could get accurate doppler frequency 。 depending on above discussed technology, we designed a signal processing scheme, and developed a signal processing system. the running result showed high performance, verified the feasibility and reliability of the highly precise signal processing technology introduced. in a word, the technology improved ldv ’ s performance such as measurement precision, measurement range, dynamic response time 。 and it will have a wide application foreground

    針對存在的缺點，本文提出了一種應用於激光多普勒測速的高精度信號處理技術，即首先利用加hanning窗的welch修正周期圖演算法得到信號功率譜，搜索其譜峰值頻率，接著利用goertzel頻譜細化演算法對搜索的譜峰進行細化分析，再引入能量重心頻譜校正演算法對細化后的譜峰進行校正分析，從而將離散頻譜分析演算法、頻譜細化演算法和頻譜校正演算法三者有機結合起來，充分發揮各自的優點:通過加hanning窗的welch修正周期圖演算法快速得到功率譜及峰值頻率，通過goertzel演算法獲得分析頻帶的高解析度頻譜，然後通過能量重心校正演算法對細化后的頻譜進行高精度校正，這樣不僅保證了演算法的高效性，而且大大提高了分析的精度。
  7. To overcome the disadvantages of the linear calibration methods such as mlr and pls, least - squares support vector machine ( ls - svm ) is introduced to nir quantitative calibration in this thesis. for a set of diesel cetane number ( cn ) samples, the ls - svm model obtains the best performance in the cn prediction, compared with the mlr and pls model

    為克服mlr與pls等線性校正方法的局限性，本文將最小二乘支持向量機（ ls - svm ）演算法用於近紅外光譜的定量校正，並以一批柴油十六烷值樣品數據為例對以上方法進行了比較。
  8. Study shows that the basic principles of three existed methods for phase difference correction on discrete spectrum are identical, by which the twice fft analysis through time - domain shifting time series or changing window ' s length is performed, and the spectrum by making use of the phase difference of two corresponding peak lines are finally corrected

    在研究時域平移的離散頻譜相位差校正方法和改變窗長離散頻譜相位差校正方法的基礎上，發現這幾種離散頻譜相位差校正法的基本原理是一致的，就是通過時移和加不同的對稱窗進行兩次fft分析，並利用離散頻譜對應峰值譜線的相位差以求得頻率和相位校正量。
  9. The inversion results of the theory model and actual data show that the method can reconstruct near - surface velocity field of complex structure stably, quickly and accurately, thus, can calculate the statics and ensure structural imaging in complex area

    理論模型和實際資料的反演結果表明，該方法能穩定、快速、準確地重建復雜地區的近地表速度場，建立準確的近地表速度場，從而可計算準確的靜校正量，保證復雜地區的構造成像。
  10. The self - tuning algorithm of the parameter adopts eigenvalue of the systemic error and derivative error and so on. thus this method can overcome the disadvantage of the previous method which make the calibrating date not match up to the moveable track of the system, and improve the adaptability, rapidity and robustness of the human simulating intelligent control ' s algorithm

    該方法將誤差、誤差導數等特徵量引入參數在線校正公式，克服了以往採用盲目搜索法時校正量與系統實際運行軌跡不匹配的缺點，提高了仿人智能演算法的適應性，快速性和魯棒性。
  11. Hence, the pendulum is overcorrected during the initial stages of an acceleration and is undercorrected immediately following an acceleration.

    因此，在加速度開始作用階段校正量過大，而在加速度作用過后校正量不足。
  12. The improved algorithm has three steps : 1 ) estimating the statics ; 2 ) selecting the best coherent time window from the common - receiver - point stack profile for the coherent computation and calculating the statics ; 3 ) correcting the value of " statics " by the underground structures corresponding to the formation of the p waves

    演算法可以分3步進行：估算靜校正量；在共接收點疊加剖面上選擇一個最優相千時窗進行相干運算，求取靜校正量；根據縱波對應層位的地下構造對相於結果進行校正。
  13. Rebuilding near - surface velocity field is very important for calculating statics

    摘要近地表速度場的重建是獲得準確靜校正量的關鍵。
  14. This paper presents a static correction method by using the first - arrival times in raw seismic data

    本文提出一個用折射波初至時間計算靜校正量的新方法。
  15. Consequently, there are much more noises in seismic acquisition, and static correction is difficult, and the seismic record is lower resolution and lower signal - to - noise, seismic data is far from the need of seismic interpretation

    受其影響，在地震勘探的採集過程中產生了大量的干擾波，使得地震勘探靜校正量大，干擾嚴重，造成地震資料信噪比和解析度低，遠遠不能滿足地震解釋的需要。
  16. In this dissertation, the method of field primary static correction and refraction statics are applied together is given firstly, avoid the fault of using refraction static alone ; compile the program of calculating static values, studying the automatic residual statics multiple iterating technique. practical data processing shows that the static correction processing flow given in this dissertation is feasible

    本文首次使用了野外靜校正和折射波靜校正聯合處理的方法，避免了折射波靜校正孤立使用的缺點，編制了計算低降速帶靜校正量的應用程序，研究了自動剩餘靜校正的多次迭代技術，在塔里木地區地震資料處理應用中，見到了明顯效果。
  17. We describe three static methods : field primary static correction, refraction statics and automatic residual statics, and then introduce the principle of the three static methods. second, the dissertation gives the method of elevation statics, calculating static values by using minor refraction data, first - break pickup method and residual technique

    其次，重點闡述了1 、野外靜校正方法中地面高程校正的過程、利用小折射測量數據計算低降速帶靜校正量的演算法； 2 、應用現有的折射波靜校正軟體進行初至拾取及靜校正量計算的操作要領； 3 、自動剩餘靜校正多次迭代技術。
  18. The algorithm of strapdown inertial navigation system is also discussed and then use the flight - track generator to give a simulation, since a closed loop feedback integrated navigation system is designed in this paper, and the output of the filter must feed back to the strapdown inertial navigation system, the analysis of the algorithm in strapdown inertial navigation system is important. the scheme to design the trajectory of gps and the simulation of gps constellation are then studied, the simulation of gps constellation is given from the calculation of vernal equinox base on the principle of celestial mechanics, this method of different from other methods given by other paper and is useful to the research of satellite navigation system. a new method to abstract noise modal in integrated navigation system is proved to be useful in practice, this method, which is given by use the principles of stochastic processes, statistics, time series analysis, and system identification, is suitable for the kalman filter in integrated navigation system

    如航跡產生器的設計，該航跡產生器是研究組合導航問題的前提，從國外一些研究組合導航系統的文獻中可以看出，設計這樣一個航跡產生器是非常必要的，所以本文自行設計了這樣一個系統；還討論了捷聯慣性導航系統中捷聯解算的方法，並進行了模擬研究，由於在本文設計的閉環反饋式組合導航系統中，對捷聯慣導系統的平臺誤差進行閉環控制，需要將濾波器輸出的校正量反饋到捷聯解算內部，所以必須對捷聯解算進行深入的研究和分析，更何況捷聯解算問題本身也是導航界的一個熱門研究課題；另外，本文還介紹了gps軌道及其星座模擬的設計思想和方案，與以往gps軌道和星座模擬不同的是本文從天體力學中計算春分點開始，逐步進行gps軌道及其星座模擬，這樣的設計方法對從事衛星導航的研究工作是有價值的；還對組合導航中誤差建模方法進行了研究，綜合運用隨機過程、概率統計、時序分析及系統辯識等方面的理論提出了一套適合組合導航卡爾曼濾波的誤差建模方法，並運用實際研究工作中的測量數據對該方法進行了驗證。
  19. The volume of the test volumetric vessel is determined from the number of " dumps " of the standard measure required to fill the test measure

    容積法則需一個標準（經校正）量器，由填滿測試量器所需傾倒標準量器的次數可測定測試容器的容量。
  20. The structure and character of deformable mirror were analyzed, and the conflict between the deformation band and the pitch of deformable cells was pointed out. the " two - time compensation " wave - front correct mode was introduced to settle that conflict. the method for allocating wave - front aberration and designing static corrector was found, and the " two - time compensation " wave - front correct mode was validated by simulation

    分析了變形鏡的結構特點，初步給出了變形鏡本身驅動單元數與校正量之間的制約關系；引入「二次補償」波前校正方案，解決了變形鏡校正量有限與高功率固體激光系統波前誤差起伏量大的矛盾，建立了波前校正對象優化分配、靜態校正器優化設計等細節過程所需要的方法，通過模擬模擬驗證了「二次補償」波前校正方案對于降低變形鏡校正量要求和放寬光學元件加工精度的作用； 5
分享友人
分享到 Line

分享到臉書