格孔柵 的英文怎麼說

中文拼音 [gékǒngzhà]
格孔柵 英文
perforated grids
  • 格 : 格象聲詞rattle; gurgle
  • 柵 : 柵名詞（柵欄） railings; paling; palisade; bars
  1. There are blowholes in the floor which has a hollow lumen and strnthen grids

    地板有通風孔，內腔空心或加強型格柵
  2. Based on research of the antenna assemble procedure, the simulation model of the reflector is set up and error modeling and simulation of position of stick holes, grid bar acrossing the hole and rms of reflector face are achieved

    在分析柵格天線裝配過程基礎上，建立了其反射面裝配的模擬模型，並對柵支板中心圓孔位置誤差、柵條穿人誤差和柵面誤差進行了建模與模擬計算。
  3. 3lift up the ceiling assembled thread the iron wire to the hole of main carrrier 4proceed to level adjustment after paving all ceiling tiling squares

    3將預裝好后的格柵天花吊起鐵線穿在主骨孔內
  4. The sediment model tests for the desilting bottom intakes of two hydropower stations are introduced herein, in which a new combined type of " grid desilting gallery + desilting bottom intake " ( grid desilting bottom intake ) is put forward

    文中介紹了2個電站進水口排沙底孔的泥沙模型試驗情況，提出了一種新的「格柵式排沙廊道排沙底孔」的組合型式（簡稱格柵式排沙底孔） ，取得了理想的排沙效果，較好地解決了工程實際問題。
  5. Bulb plates, perforated gratings or flooring grids for working floors and walkways

    工作面地板鑿孔柵欄和通道用球頭扁鋼和地面格子板
  6. An opening covered with a grating

    格柵用格柵擋住的洞或孔
  7. 2assemble the grille ceiling in advance on the floor ; 3mount each grille ceiling assembled on the suspended hook of the iron wire

    3將預裝好的每份格柵天花裝在鐵線吊鉤上將跺鉤穿進主骨孔內
  8. Note 7 - remarks as to the origin may take the form of a boring number and sample number in conjunction with a job number, a geologic stratum, a petrologic horizon or a location description with respect to a permanent monument, a grid system or a station number and offset with respect to a stated centerline and a depth or elevation

    注7 -對于原狀樣的記號可以採用下面的形式，一個鉆孔編號和一個樣品編號聯合一個工作編號，一個地質地層，一個巖石層位或者一個考慮為永久界標的原地描述，一個柵格系統或者一個測站編號和考慮到規定的中心線和深度或海拔的偏移量
  9. This is related to certain physical limitations of the image sensors, such as finite cell area and finite aperture time

    這一點與圖像傳感器（如：有限柵格區和有限過孔時間）的一定的物理限制條件有關。
  10. Then the theoretical computing methods are presented, in which we emphasize particularly on the plane wave method ( pwm ) and the finite element method ( fem ). with the two methods mentioned above, important parameters such as bandgap, dispersion, leaky loss and so on are calculated, as well as the birefringence of two kinds of mf, which are in two different mechanisms. a new type of optical coupler based on dual - core bandgap microstructure fiber is presented

    主要研究內容如下: 1 、利用平面波展開方法和有限單元方法研究了微結構光纖的傳導特性，對三角形、蜂窩形柵格空氣孔包層結構的光子能帶進行了研究，在此基礎上闡述了光子晶體光纖的傳導機制，對折射率引導和光子帶隙引導微結構光纖的波導色散、泄漏損耗和有效模場面積進行了研究。
  11. Firstly, we study the photonic band structure of the pcf cladding with triangular and honeycomb air holes lattices. then the guided mechanisms of pcfs are demonstrated. the waveguide dispersion, leaky loss and effective modal area for both index - induce pcf and pbgf are presented

    首先對三角形、蜂窩形柵格空氣孔包層結構的光子能帶進行了研究，在此基礎上闡述了光子晶體光纖的傳導機制，對折射率引導和光子帶隙引導光子晶體光纖的波導色散、泄漏損耗和有效模場面積進行了研究。
  12. In addition, the influence of the hole structure on the mechanical characteristics of micro - grid material has been studied systematically so as to offer a guidance for the design of optimized structure of micro - grid materials for furnace construction

    另外，對微格柵孔型結構變化對砌體應力分佈的影響進行了系統研究，為微格柵砌體的優化設計提供了依據。
分享友人
分享到 Line

分享到臉書