楊氏模量 的英文怎麼說

中文拼音 [yángshìmóliáng]
楊氏模量 英文
young modulus
  • 楊 : 名詞1. （楊樹） poplar 2. （姓氏） a surname
  • 氏 : 氏名詞1 （姓） family name; surname 2 （放在已婚婦女的姓后 通常在父姓前再加夫姓 作為稱呼） née : ...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  1. The yang modulus for meauring metal with a centimillimetre

    移測顯微鏡在測量金屬楊氏模量中的應用
  2. Method to measure wire young ' s modulus by magnetic induction method

    用磁感應法測量金屬絲楊氏模量的方法
  3. And simulation analysis was made on the influences of the young ' s modules in the two main directions upon the hole - edge stress

    並對兩個主方向的楊氏模量的變化對孔邊應力的影響進行模擬分析。
  4. The tested materials include ( 100 ) silicon wafer, ( 110 ) silicon wafer, poly - silicon thin film, dry oxidized silicon dioxide thin film, wet oxidized silicon dioxide thin film, lto thin film, standard lpcvd silicon nitride film, low stress lpcvd silicon nitride film, alumni nitride film, zinc oxide film etc. in the nanoindentation experiment of the single crystal silicon, two different mechanical phases are observed at different indentation depth

    用納米壓入法對（ 100 ）單晶硅及（ 110 ）單晶硅、多晶硅薄膜、干氧薄膜、濕氧薄膜、 lto薄膜、標準氮化硅薄膜、低應力氮化硅薄膜、氮化鋁薄膜、氧化鋅薄膜等重要材料的楊氏模量和納米硬度進行了系統地測量。報道了單晶硅在壓入過程中觀測到的兩個力學相的變化。
  5. The result of md simulation means that : ( 1 ) the microstructure in the amorphous carbon has no obvious change, the slippage which is parallel to the fiber axes in the graphite slices of the pyc interphase was found ; ( 2 ) bulk moduli of every part of interphase diminished, young ' s moduli in all three direction of amorphous carbon diminished, young ' s moduli of the graphite slices in the direction of parallel to the fiber radial decreased, and ones in the direction of parallel to the fiber axes increased

    分子動力學模擬結果表明， （ 1 ）界面相內部無定形碳部分微結構無明顯變化，石墨片層部分沿纖維軸向滑移； （ 2 ）界面相模量發生變化，界面相區域各部分的體積彈性模量降低，無定形碳部分及石墨片層部分垂直於纖維軸向的楊氏模量降低，平行於纖維軸向的楊氏模量升高。
  6. Standard test method for sonic velocity in manufactured carbon and graphite materials for use in obtaining an approximate young ' s modulus

    為獲得近似楊氏模量測量加工的炭精及石墨材料中音速的標準試驗方法
  7. Standard test method for dynamic young ' s modulus, shear modulus, and poisson ' s ratio by impulse excitation of vibration

    利用振動的脈沖激勵測定動態楊氏模量剪切模數和泊松比的標準試驗方法
  8. Standard test method for dynamic young ' s modulus, shear modulus, and poisson ' s ratio for advanced ceramics by impulse excitation of vibration

    用振動脈沖激勵法的高級陶瓷動態楊氏模量剪切模量和泊松比的標準試驗方法
  9. Based on the principle of michelson interference a new integrative experiment apparatus to measure linear expansion coefficient and yang ' s modulus of metals is designed and manufactured primarily

    摘要在邁克耳孫干涉原理的兩條干涉光路中，分別設置可以精確測量金屬絲的拉伸長度和金屬棒熱膨脹伸長量的裝置，從而設計出一種可以分別測量金屬楊氏模量和線脹系數的新型綜合實驗儀器。
  10. Yong ' s module and quality were taken into account for the calculating of branch distortion, and physical model was constructed to simulate the real configuration of the trees in the affect of gravity and wind

    為模擬樹在重力及風中的形態，根據材料力學建立了枝條的受力計算模型，將楊氏模量、質量等因素考慮在枝條形變的過程中，取得較好效果。
  11. Test method for young ' s modulus, tangent modulus, and chord modulus

    楊氏模量正切模量和翼弦模量測試方法
  12. An application of vibration reed to intelligent measurement system of young ' s modulus

    舌簧片振動法在楊氏模量智能測量系統中的應用
  13. The presence of microwave or ultrasonic wave, the inter - and intra - molecular complexation of cellulose molecules through hydrogen bonding is weakened, and the complexed polymer of cellulose and nylon formed in situ. the yield strength and young ' s modulus of the ramie / nylon / lldpe composites are increased from 9. 68 mpa, 260 mpa to 15. 7 mpa and 722 mpa respectively

    經微波輻照或超聲波處理后，苎麻纖維素氫鍵被削弱，與尼龍形成氫鍵復合物，增強了苎麻尼龍電子束輻照lldpe復合材料體系的相容性，屈服強度、楊氏模量從9 . 68mpa 、 260mpa提高到15 . 7mpa 、 722mpa 。
  14. The results indicated that the physical properties of these materials were mainly dependent on the content of ni3al and increased obviously when 40vol % ni3al was contained since a net structure between ni3al phase and tic grains were formed under the circumstances

    顯微結構觀察發現，在40vol ni _ 3al的組成上， ni _ 3al相與tic顆粒成為一種相互穿插的空間網路結構，使其楊氏模量、泊松比、熱膨脹率都表現出明顯的上升現象。
  15. Test method for sonic velocity in manufactured carbon and graphite materials for use in obtaining an approximate young s modulus

    獲取近似楊氏模量用人造碳和石墨材料中聲速的試驗方法
  16. Application of moving and measuring microscope in measuring young ' s modulus of elasticity on metal

    螺旋測微計在測量金屬楊氏模量中的應用
  17. Abstract : the effects of young ' s modulus on the wave velocity, on the potential energy and kinetic energy in arbitrarily volume in the maocinery longitudinal and on the vibration phase among incidance ware, reflex wave and transmission wave at the boundary surface of two kinds of medium are discusseed

    文摘:本文就楊氏模量在機械縱波中的波速、任意體積內的勢能和動能及在兩種介質界面處入射波、反射波、透射波的振動周相關系中的作用作了闡述。
  18. The young ' s modulus, shear modulus and bending strength of single crystal silicon are characterized by the balance approach, too. a simplified relative uncertainty transfer equation is obtained by introducing the appropriate non - dimensional factor into the expression, thus providing more convenience to the practical evaluation of the resultant uncertainty

    理論上引入適當的無量綱因子，簡化函數的表達，給出了天平法測量楊氏模量和剪切模量相對誤差傳遞函數的解析表達式，並在此基礎上討論了天平法測量楊氏模量和剪切模量中相應誤差的影響。
  19. Get yang ' s module by coupled vibration of free pole

    懸絲耦合振動法測楊氏模量
  20. Deducing the new formaulas of two isotropic materials composite yong ' s modulus from bending model

    用彎曲模型推導二組元復合材料楊氏模量新公式
分享友人
分享到 Line

分享到臉書