極間電壓 的英文怎麼說

中文拼音 [jiāndiàn]
極間電壓 英文
electrode voltage
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • : 間Ⅰ名詞1 (中間) between; among 2 (一定的空間或時間里) with a definite time or space 3 (一間...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 壓構詞成分。
  • 電壓 : voltage; electric tension; electric voltage
  1. This article introduces briefly the process of design and characteristic of structure of db930 tube and discusses the main problems of technology and technique which was met during the manufacture and the measures having been adopted are emphatically. it discusses the solve measures in following six aspects : the filament current is too large, carbon deposits during the carbonizing of cathode, the capacitance between the first grid and the second grid is too large, transpiring happens inside the tube, the insulation resistance between the electrodes is too lower when the filament is on and the ability of bearing high voltage is too lower

    本文簡略地介紹了db930的設計過程及其結構特點,重點論述了在試制過程中遇到的主要工藝技術問題及解決問題的措施,圍繞解決燈絲流大、陰碳化時積碳、一柵和二柵之容大、管內蒸散、熱態時絕緣低、耐高的能力差等六個方面的問題進行了論述。
  2. Schottky barrier diode is a kind of majority carrier device, using the contact barrier formed between metal and semiconductor to work. it has the advantages of low turn - on voltage and high response frequency, compared with pn junction diodes

    肖特基二體是利用金屬與半導體之接觸勢壘進行工作的一種多數載流子器件,與普通的pn結二體相比,它具有正向導通低,響應速度快等優良特性。
  3. On the basis of the analysis and compare, we designed the least length of s - bend y - branch to decrease the transmission loss when the space between the outport is 250jjm. we also analyzed thoroughly dependence of half - wave voltage and bandwidth on the width, the length of modulator ' s electrodes and the gap between two electrodes

    對于調制器的本文也進行較為深入的研究,探討了寬度、長度、距對半波的影響,並據此對單y相位調制器的結構進行了優化設計。
  4. Space charge properties of frp rod materials are influenced by temperature, field strength and high voltage application duration

    結果表明,在高直流場作用下,芯棒材料內部積累的空荷的性和密度受到溫度、場強度和場作用時等因素的影響。
  5. A novel low mechanical hysteretic ceramic capacitive pressure transducer has been made, by using of ceramic sealing technology ; integrate circuit ( ic ) technology and thick film plane fixing circuit technology. this transducer is made of a deformable ceramic diaphragm and a ceramic base plate, between which has an air cavum. a coaxial gold electrode was fired onto the diaphragm and the base plate

    本文利用新型陶瓷技術、集成路技術和厚膜平面安裝路技術,採用零力學滯后的陶瓷和陶瓷密封材料進行設計製造了一種非充液乾式的容式力傳感器,該力傳感器由較厚的陶瓷基體和較薄的陶瓷膜片構成,中形成一空氣介質腔,在基座和膜片之內置同軸的雙,組成兩個容,當膜片承受力時發生位移,使容量產生變化,經後置處理路直接轉換為可輸出的直流信號。
  6. 9 dakai zhu, melhem r, childers b r. scheduling with dynamic voltage speed adjustment using slack reclamation in multi - processor real - time systems. ieee trans. parallel distributed systems, 2003, 14 : 686 - 700

    動態調節是體系結構層的低功耗技術,由於系統運行的能量消耗與運行成平方關系,在運行期動態改變系統可以大的降低系統的功耗。
  7. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面流作用於有限長鐵芯上的模型,引用了氣隙磁場一維解,研究了單層繞組磁場,奇數半填槽雙層繞組在採用整距和短距時磁場的分析、比較,簡單介紹了二維解; ( 2 )用有限元軟體ansoft對大圓環直線感應機空載氣隙磁場進行了靜態分析,並分析了結果; ( 3 )用軟體進行了額定下的瞬態分析,得到了轉矩,位移,轉速隨時變化曲線圖,利用單性霍爾元件測定轉速並與軟體計算結果進行了比較,採用等效路法計算了堵轉時的最大磁力並做實驗進行了驗證,由實驗測得了三相流波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。
  8. Apical shapes were formed through electropolishing in the 1 - m naoh water solution at 2 volts with reciprocating the electrode array

    尖端的形狀通過解拋光法構成, 2伏的陣列和1m氫氧化鈉溶液之互換。
  9. Under high air pressure, a critical problem for the normal discharge is whether enough pre - ionization can be achieved in the laser media or not. however, the cycling pumping oil steam emerging during the flow of the gas mixture and the vapor infiltrating from outside have a strong absorption of the infrared light or a role of counteracting the excitation

    在高氣條件下能否正常放,關鍵問題是主的激光介質能否獲得足夠的預離;而混合氣流動過程中出現的循環泵油蒸汽,及從外界滲透的水蒸汽等都對紅外光有相當強的吸收作用或消激發作用。
  10. The voltage of lithium - intercalation reaction, impedance and structural stability of intercalation - type cathode material were analysed and calculated. theoritical results show that the reaction voltage depends on the content of lithium and the bond energy, and that the key ways to lower the electrode impedance are to increase the electronic conductivity of the electrode and the diffusion coefficient of lithium ion in the host and to decrease the size of powder. in addition, the thermal stability of lithium - insertion structure can be improved by using crystallographic co - lattice theory and doping treatment

    本文從嵌入式陰材料的嵌鋰反應的、阻抗及結構穩定性的分析和理論計算著手,得到了取決于基體中各種離子的鍵能及鋰含量、降低阻抗的關鍵是提高子型導性和li ~ +在基體中的擴散系數及減小粉末粒度的理論依據及其利用晶體的共格原理和摻雜改性的方式來提高材料嵌鋰結構的熱穩定性的設計思路。
  11. Protective network can control the voltage between actuators to protect deformable mirrors

    保護網路通過控制極間電壓,保護變形鏡。
  12. When the flue gas and dust past through electrical fields, they caused impact with positive and negative ion and electron between electrical electrodes to charge electric. the charged particles move and are accumulated to difficult electrical electrode due to effect of electric field force. through rapping method, the dust leaves electric electrodes and drop into the collection hopper, and the remove the dust by transportation system

    是一種煙氣凈化設備,它的工作原理是:煙氣中灰塵塵粒通過高場時,與的正負離子和子發生碰撞而荷或在離子擴散運動中荷,帶上子和離子的塵粒在場力的作用下向異性運動並積附在異性上,通過振打等方式使上的灰塵落入收集灰斗中,使通過除塵器的煙氣得到凈化,達到保護大氣,保護環境的目的。
  13. This paper gives a method to measure the conductivity base on choosing frequency. after adding to the electrode with two ac square waves of appropriate frequencies, we can measure the output dc voltage of the circuit

    本論文提出了一種選頻導率測量方法,選擇兩個合適頻率的交流方波施加於,測出路輸出直流,通過解方程組求出時常數,然後求得溶液阻,進而得到溶液導率。
  14. The signal sampling circuit fulfill the tasks of sampling signal and changing the double polarities signal to the single polarity signal ; the drive circuit receives the pwm signals from dsp and pass the signals to ipm through optical - couple devices ; the protective circuit safeguard the system against high current, high voltage, low voltage and high temperature on the ipm model

    其中信號處理路主要完成採集輸出流和中直流環節信號,並對採集到的流信號進行性變換處理的功能;驅動路接收dsp輸出的高頻驅動信號,通過耦合器件直接驅動ipm模塊;保護路利用採集到氣信號對整個系統實施保護,包括過流、過、欠、 ipm模塊過熱等。
  15. It was tested on static characteristic parameter, including the interelectrode capacitance, voltage resistance and others. the test data are almost same as those of th558. the design goal was achieved on static parameter

    對樣管的容、耐和靜態特性參數進行了測試,測試結果與th558樣管基本一致,靜態參數達到研製目標。
  16. The samples were poled at different temperature and voltage and maintained different time at poling voltage

    結果表明,材料的最佳化溫度應為70 ,應為4kv mm ,化時為15分鐘。
  17. The lead zirconate titanate ( pzt ) / polymer composite presented large tan5 and dynamic modulus when the composites were exposed to higher polarization voltage and longer polarization time, because of the uniform dispersion of ceramic in polymer matrix and the strong interaction between grain and polymer. the morphology of the composites, namely the degree of the grains dispersion in polymer, can be observed through scanning electric microscope ( sem )

    顆粒結構性高的陶瓷,其復合體系內耗大;在高、長化時下,陶瓷顆粒在聚合物中分散比較均勻,與聚合物接觸面大,相互作用強;在外力作用時,體系tanb 、 g , , g ?呈現大的值。
  18. Voltage across poles

    極間電壓
  19. A serial port interface can be used to take control of the power supply, to set g1, g2 and g3 voltages, to select the xrii field, or to measure back the real electrode voltages ( see chapter4 )

    一個串列埠接點可被用來控制源,設定g1 , g2和g3,選擇x線影像增強器視野,或延遲測量實際極間電壓(看第4章) 。
  20. Picks up various compositions, adopts different poling voltage, poling temperature and maintained different time at poling voltage, and makes sure the best poled craftwork system by measuring the samples ' piezoelectric properties

    摘要選取部分樣品,採用不同的化溫度和保溫時,測試其性能,確定最佳的化工藝制度。
分享友人