極限抗力 的英文怎麼說

中文拼音 [jíxiànkànglì]
極限抗力 英文
ultimate resistance strength
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 極限 : 1 （最高的限度） the limit; the maximum; the ultimate limit; limitation; extremity; tipping point...
  1. Elastic theory and plastic theory are adopted in the analysis of the two section composite beam. elastic theory suggests, on the condition of the same steel beam section size, the composite beam for the floorslab is suited lower flanges convertion section stiffness cuts down by 75. 1 %, elastic limit bending resistant capability cuts down by 47. 9 %, than the composite beam for the floorslab is suited on the top flange. it s conversion section stiffness is lifted 8. 0 %, elastic limit bending resistant capability is lifted 0. 20 %, than the steel beam

    彈性理論分析的結果表明，在鋼梁截面大小相同的條件下，樓板位於鋼梁下翼緣的組合梁和樓板位於鋼樑上翼緣的組合梁相比，其換算截面剛度降低75 . 1 ，梁的彈性極限抗彎承載力降低47 . 9 ，樓板位於鋼梁下翼緣的組合梁和純鋼梁相比，其換算截面剛度提高8 . 0 ，梁的彈性極限抗彎承載力提高0 . 2 。
  2. Petroleum and related products - determination of the extreme - pressure and anti - wear properties of fluids - four ball method european conditions iso 20623 : 2003 ; german version en iso 20623 : 2003

    石油和相關產品.液體的極限壓力和抗磨性能的測定.四
  3. A new algorithm of ultimate uplift resistance of horizontal anchor plates

    水平錨板極限抗拔力的一種演算法
  4. 3. the crane load and fatigue strength are regarded as stochastic process, the fatigue dynamic reliability based on limit stress model and fatigue dynamic reliability based on accumulation damage model are established on the base of statistic analysis the fatigue load and resistance

    3 、在對疲勞荷載與抗力統計分析的基礎上，視吊車荷載與疲勞強度為隨機過程，建立了基於極限應力模式的疲勞動態可靠性分析模型及基於累積損傷模型的疲勞動態可靠性分析模型。
  5. Typical breakout failure of suction anchor and computation

    負壓錨抗拔失效形式和極限抗拔力計算方法
  6. On the basis of relative researches in the world, according to the study status of steel - concrete composite slab, which would be widely used in modern bridge, modified equivalent inflexibility of steel - concrete composite slab was deduced by use of conversion section principle in this paper ; based in this, this paper put forwards the theory of ultimate flexural capacity of steel - concrete composite slab in consideration of slip effect, and introduces the practical simplified method for calculating flexural deformation of steel - concrete composite slab in consideration of the effect of steel studs and welded wire, and conclude that the methods in this paper is veracious and reliable, comparing with the traditional calculating mode ; morever, this paper put forwards the calculating theory and program of the effect analysis of creep and shrinkage to steel - concrete composite slab, using conversion elastic modulus principle, and testifies that the theory is right and the program is reliable and practical

    本文在國內外研究成果的基礎上，針對壓型鋼板與混凝土組合板結構在現代橋梁建設中廣泛應用前景和研究現狀，利用換算截面法導出了壓型鋼板與混凝土組合板結構的修正等效慣性矩；在此基礎上，又推出了考慮壓型鋼板與混凝土之間的相對粘結滑移影響的壓型鋼板與混凝土組合板結構極限抗彎承載能力計算理論，並介紹了考慮栓釘、聯結件影響的壓型鋼板與混凝土組合板結構簡化實用撓曲變形計算公式，而且通過與傳統計算理論的分析比較，表明本文提出的計算理論公式的準確可靠性；此外，採用換算彈性模量比法著重提出了壓型鋼板與混凝土組合板結構的徐變、收縮效應分析的計算理論和程序，並通過實例分析計算證明了理論的正確性、程序的可靠性和實用性。
  7. The paper presents a new comparative method. that is to make the different strengthened forms by externally bonded with different materials reach the same ultimate flexural capacity, and contrast with each load - deflection and moment - curvature curve, which are calculated by paper ' s program. mean

    本文引入新的對比方法，即不同材料的加固在最終均達到同樣的極限抗彎承載力時，比較其各自的彎矩一曲率和荷載一撓度變化情況，並自行編製程序進行計算。
  8. Therefore, the method of gluing steel plates improves not only the extreme capability of bending, but also enhances the crack resistance and the rigidity of beams, raises the capability of resistance to deflection

    因此，粘鋼法加固不僅有效提高鋼筋混凝土梁的極限抗彎承載力，而且提高原梁的開裂彎矩及構件剛度，增加了原梁抵抗變形的能力。
  9. A simplified formula for the shear capacity of rc simply supported beam which strengthened with the cmmr is proposed in this paper. 3 、 the shear capacity of rc beam strengthened with cmmr is studied. though the test of fourteen simply supported reinforced concrete beams and five overhanging reinforced concrete beams with cmmr, it analyses the effects of shear - span ratio, web reinforcement ratio of cmmr, style of loading, preloading on strengthening, and compares them with rc beams using ordinary stirrup

    3 、根據本文進行了的14根混凝土簡支梁和5根混凝土伸臂梁的水泥復合砂漿鋼筋網抗剪加固試驗，分析了剪跨比、鋼筋網配筋率、加固形式以及持荷狀態等因數對整個構件極限抗剪承載力的影響，並與混凝土梁進行了比較。
  10. Ultimate pullout capacity

    極限抗拔力
  11. On one hand, the stress in mass concrete is caused because of the difference between internal temperature and external one. on the other hand, with the concrete solidifying, the tensile stress will appear due to concrete ' s shrinkage restrained by base rock

    大體積混凝土一方面由於內外溫差而產生應力，另一方面，由於混凝土的凝固，收縮變形受到約束，混凝土會產生拉應力，一旦溫差引起的應力和收縮變形引起的應力超過同齡期混凝土的極限抗拉強度，混凝土就會產生裂縫。
  12. The pseudo - dynamic test gives the model ' s earthquake response, failure characteristic and special seismic property, unveil the structure ' s failure procedure of " low density setin block ' s break - slab rib ' s break - end post ' s concrete craze - end post ' s steel bar yielding ", providing full and accurate experimental information to establish the seismic design method. the slab ' s crack discrimination condition is prescribe. the extreme shear strength bearing moment, shear and pressure synchronously shows the bearing capacity components and change in slab ' s failure process

    提出了密肋復合墻體開裂的判別條件；對于墻體在彎剪壓耦合作用下的極限抗剪承載力性能，分析了其構成因素及其隨破壞過程的變化規律；在試驗研究和數值分析的基礎上，提出密肋復合墻體抗剪和抗彎承載力表達式，並對典型墻體多遇地震作用下的承載力可靠指標進行了驗算；對影響墻體抗剪能力的各種因素進行了顯著性分析。
  13. The sx thermal stress of concrete compared with splitting tensile strength couldn ’ t reach the limiting tensile strength, so didn ’ t create damage

    與混凝土的劈裂抗拉強度相比較，混凝土的sx溫度應力沒達到極限抗拉強度，使混凝土產生損傷。
  14. Based on the experimental study of shear performance of prestressing shearwall, this paper analyses the limit of the shear performance of sheawall added the prestress, and discusses the shearing bear capacity in shear breakage

    通過對預應力剪力墻的抗剪性能試驗研究，分析施加預應力對剪力墻結構的極限抗剪能力提高程度以及在剪壓破壞形式下抗剪承載力的提高程度。
  15. The numerical results show that the lateral ground displacement is one of factors that cause pile failures in liquefied ground. at the soft - hard interface, pile may overbear the ultimate moment which leads to bending and shearing failures. therefore, except the effect of large inertial loads from superstructure, the influence of the lateral ground displacement on pile foundation cannot be neglected in a seismic design of pile foundation in lateral spreading ground

    計算結果表明地基的側向位移是與液化有關的樁基震害的主要原因之一，在軟硬交界處樁可能承受了超出樁本身極限抗彎能力的彎矩，容易發生彎剪破壞，在有液化側擴地基中樁基的設計不能僅考慮上部結構震動的影響，地基的水平側向位移對樁基的影響不容忽視。
  16. Meanwhile, the results of program show that, under secondary load, the bonding - reinforced beams " yield - moment would decrease as the original load increase, but the original load would n ' t remarkably influence the ultimate flexural capacity

    同時，程序計算結果表明，加固梁在二次受力的作用下，屈服彎矩隨著初始荷載的增加而減小，但極限抗彎承載力受初始荷載影響較小。
  17. 2. the effect of frp reinforcement ratio on the ultimate moment of frp reinforced concrete beam is studied, the conclusion is that the ultimate moment increases with the increase of the reinforcement ratio for frp reinforced concrete beam in a certain range of reinforcement ratio

    結果表明，對纖維增強塑料筋混凝土梁，在配筋率的一定范圍內，配筋率越大，受壓區面積越大，極限抗彎承載力越高。
  18. Testing of wood ; determination of ultimate tensile stress parallel to grain

    木材試驗.與木料紋理平行的極限抗拉應力的測定
  19. Ultimate tensile stress

    極限抗拉應力
  20. In theory research based on truss theory, the effective length of the cfrp sheet and ultimate capacity of paste layer is introduced, then the calculation procedure of the ultimate shear capacity of rc t - section beams strengthened with cfrp laminates is put forward, so did the reinforcement design method of normal service phase

    基於桁架理論，引用有效粘貼長度的概念，以粘貼層所能承受的極限抗力為計算控制參數，提出了碳纖維布對鋼筋混凝土t梁極限承載力及正常使用階段的加固計算方法。
分享友人
分享到 Line

分享到臉書