概率分佈分析器 的英文怎麼說

中文拼音 [gàilǜfēnbùfēnxīqì]
概率分佈分析器 英文
probability distribution analyzer
  • 概 : Ⅰ名詞1 （大略） general outline 2 （神氣） manner of carrying and conducting oneself; deportment ...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 概率 : [數學] probability; chance概率論 probability theory; theory of chances; 概率曲線 probability curv...
  1. This thesis present the systematic studies on firing accuracy and firing accuracy tactical & technical requirement reasoning for gunnery system. the main contents of the paper are as follows. ( 1 ) definitions and probability distribution expressions for error of fire, error of firing data and error of dispersion are given summarily. methods to compose error of initial firing data and error of dispersion are discussed

    本文對遠程炮武器系統射擊精度及射擊精度戰術技術指標論證等方面問題進行了深入、系統的分析研究，本文研究工作的主要內容有： （ 1 ）概要地討論了射擊誤差、諸元誤差、散布誤差的定義及其概率分佈，諸元誤差、散布誤差及射擊誤差的合成，分析了射擊精度的各種表示法，闡述了火炮武器系統準確度、密集度和首發命中概率的估算方法。
  2. This dissertation is the expanding of the military project of ‘ 95 ’ advance research, a novel multi - modulation technique designing radar signal waveform is introduced on the links with the project of the national natural science fundation of china ( nsfc ), named " produce and process the multi - modulation signal of the sensor with strong detectability and identifiability ". based on the analysis of the equal - probability - distributing fsk / psk multi - modulation signal, we construct a new pseudo - random fsk / psk multi - modulation signal and we design and simulink on the computer the partly - matched processing signal of this signal. the purpose of the design is to construct a processing signal to combine with the pseudo - random fsk / psk multi - modulation signal, so that we could get a strong response of the target

    本論文是『九五』軍事預研項目「低截獲概率雷達波形研究」的擴展與深入，同時結合國家自然科學基金項目「強探測強識別傳感器新型復合調制信號產生及處理」展開。在分析等概率分佈的fsk / psk復合調制信號的基礎上，構造了一種新的偽隨機fsk / psk復合調制信號及其非完全匹配處理的設計及模擬。設計的目的是能對偽隨機fsk / psk復合調制信號進行處理的處理信號，以期獲得對所探測目標信息的強探測。
  3. ( 2 ). according to the system indices and requirements together with the technology characteristic, it researches the capture possibility of apt capturing system. then it introduces the common scan methods, such as raster, spiral, raster spiral, rose and lissajo. ( 3 ). it makes a detailed simulation analysis of the raster and spiral scan, analyze the connection between capture probability, capture time, system index at different capture resolution angle, capture range, vibration angle extent and terminal location distributing mean square deviation

    其中對幾個關鍵部分進行了詳細分析:計算了目標角反射器的激光雷達散射截面（ lrcs ）值，研究了qd與ccd對目標位置角度的計算方法和空間解析度; （ 2 ）根據系統指標和要求並結合現有國內技術特點研究了apt捕獲系統掃描的捕獲概率問題，然後分析了幾種常見的掃描方式:矩形（ raster ）掃描、螺旋（ spiral ）掃描，矩形螺旋（ rasterspiral ）掃描，玫瑰形（ rose ）掃描以及李薩如形（ lissajo ）掃描; （ 3 ）對分行掃描和螺旋掃描進行了詳細的模擬分析，分析了它們在不同捕獲分辨角、捕獲范圍、振動角振幅和終端位置分佈均方差時的捕獲概率、捕獲時間與系統常數之間的關系。
  4. Random failures of generator, transformer, transmission line, protection system and topology of both power station and power network are constructed

    根據元件故障的概率分佈，建立靜態安全分析中發電機、變壓器、輸電線路、保護系統的隨機故障模型。
  5. In the sense of mean squares, maximum likelihood estimator, best linear unbiased estimator, taest linear invariant estimator, and good linear estimator are contracted. fourth, proposed and researched the reliability analysis method under the zero - failure data and doof data. based on the part beta distribution as the prior distribution of failure probability p, = p ( t < r, }, hierarchical bayesian estimate method was discussed, obtain the reliability analysis method under the zero - failure data and the doof data

    第四，提出並研究了無失效數據類型和doof數據類型下電連接器的可靠性分析方法，提出了以不完全beta分佈為一級先驗分佈，超參數為[ 0 ， 1 ]上的均勻分佈作為失效概率先驗分佈的多層bayes方法，結合加權最小二乘法解決了產品在無失效數據和doof數據下的可靠性分析問題。
  6. The main work can be summed up as follows : firstly, we studied the thermal - field properties of vcsels, and analyzed the influences of current spreading, material parameters and operating conditions on the temperature distributions. secondly, we began with the electrode voltage and calculated the equipotential s distributions, compared the distributions of voltages and current densities in different depths of vcsels, and then studied the influences of the oxide - confining region with different position or thickness, and the different sizes of the gain - guided aperture and emitting window on the distributions of the injected current density, carrier concentration and temperature in the active region. thirdly, we realized the coupling of electricity, optical and thermal - fields, worked out the threshold voltage, calculated the distributions of the injected current density, carrier concentration and temperature under different offset voltages, and analyzed the impacts of temperature profile and carrier density on the refractive index, fermi levels and optical - field

    具體工作可以概括如下：首先，研究了vcsel的熱場特性，分析了電流擴展，材料參數和工作條件對于溫度分佈的影響；其次，從電極電壓入手，計算出激光器中的等勢線分佈，並對不同深度處的電壓和電流分佈進行比較，研究了高阻區的不同位置和不同厚度、限制層和出射窗口半徑的大小對電流密度、載流子濃度和溫度分佈的影響；再次，實現了電、光、熱耦合，求出了閾值電壓，計算了不同偏置電壓下的電流密度分佈、載流子濃度分佈和熱場分佈，分析了溫度和載流子濃度變化對折射率、費米能級和光場的影響；最後，給出了考慮n - dbr和雙氧化限制層時激光器中的等勢線分佈，分析了n - dbr和雙氧化限制層對vcsel電流密度、載流子濃度、溫度和光場分佈的影響。
  7. This new technology changes from the traditional method by which the induced and compressor wheel separately are designed and produced to a new one by which the one - piece compressor is designed. on the basis of this new technology and the optimum blade profile, the performance of both the compressor and the turbocharger is largely improved. through the heating power calculation of the compressor, the analysis of the surge and the block of the compressor, the test - bed performance test of the turbocharger, the matching test of turbocharger and diesel engine, the propulsion test of the turbocharger on plateau condition, it is proved that the newly - designed compressor not only has high efficiency, but also improves the flow distribution in the high efficiency area so that the propulsion line can run through the high efficiency area

    主要內容包括：提出一種全新的壓氣機葉輪技術和概念，這種技術將傳統的導風輪和壓氣機分開設計、單獨加工改為整體設計、整體加工的單體葉輪；從增壓器與柴油機配機計算所得出的基本參數出發，通過對壓氣機進行熱力計算，確定壓氣機的基本結構參數；再對葉型以及葉輪輪廓與葉輪罩殼的配合間隙進行優化，對新設計的壓氣機進行喘振和堵塞分析；通過增壓器平臺性能試驗，驗證了新設計的壓氣機的性能水平得到了較大的提高，達到了提高增壓器的整體性能水平的目的；通過增壓器與柴油機配機試驗、以及增壓器用於高原條件下的牽引試驗，驗證了新設計的壓氣機不但具有高效率，還改善了高效率區的流量分佈，使牽引特性線貫穿高效率區。
  8. Abstract : according to the probability fracture mechanics, distribution characters of some parameters related presure vessel and allowance failure probability are discussed in the paper, and then the probability calculation method of pressure vessel is analyzed in thd case of the two kinds of distribution of material strength. finally, one of the complete assessment methods, failure probability of pressure vessel, is introduced

    文摘:應用概率斷裂力學的觀點，討論了壓力容器各有關參數的分佈特點及允許的失效概率，分析了材料韌性為兩種不同分佈時壓力容器可靠性計算方法，說明了進行壓力容器失效概率分析是全面評價壓力容器的方法之一。
  9. The gas - particles two - phase flows in the horizontal pipe and u - beam separator were also studied in this thesis. electrical capacitance tomography ( ect ) is a new method to measure the volume distribution of solids. it is not affected by the opacity of particles

    實驗測量上，本文採用電容層析成象技術測量了旋風分離器內部顆粒的濃度分佈，分析了顆粒在分離器錐體部分的濃度分佈規律、概率及頻譜特性。
  10. We then consider the n policy m / g / 1 queueing model with two priorities. by using the supplementary variable method to analyze the state probability equations, we derive the generating function of queueing length distribution and the mean queue length in the buffer of the communications network. and through further discussing for the queue with various priorities, we derive the generating function of queueing length distribution and the stationary queueing length in queue models with various priorities

    其次研究帶有兩個優先權的n策略m g 1排隊模型，利用補充變量法對狀態概率方程組進行分析，得出了此排隊系統隊長分佈母函數及通信網緩沖器中的平均隊長，並對不同優先權隊列的進一步討論，得出了不同優先權隊列的隊長分佈母函數及穩態隊長。
  11. In designing or selecting a topology for a parallel processing system, one fundamental consideration is system - level fault tolerance. in order to improve the fault tolerance, the paper analyses from the two following sides : one is by adding the less links related to the original networks, modifying the topology of the original one, we get higher fault tolerance of the new network ; the other is under the same topology network, ignoring the likelihood of one processor and ail its neighbors failing at the same time, or considering the distribution of the faulty nodes, that is studying the fault tolerance under the conditional connectivity or cluster - fault - lolerance

    本文以提高網路的容錯度為目的，從兩個方面分析互連網路的容錯性質：一是在原網路基礎上增加少量連接，使新型網路具有更高的連通度（容錯度為連通度減1 ） ；二是在給定互連網路拓撲結構下，考慮故障處理器發生的概率和故障處理器的分佈狀況，在其中的某一具體條件下，即在條件連通度和簇容錯下分析互連網路的容錯性能，從而得到更高的網路容錯度。
  12. Finally, in order to resolve the problem that energies of nodes near the sink deplete too fast, the influence of redundant sensor nodes distribution is researched. layered network architecture based on regular hexagonal cells is introduced. taking cells as the minimum working units instead of sensor nodes, optimal distribution of redundant nodes is investigated so that network lifetime can be prolonged as much as possible

    介紹了基於正六邊形網格的分層網路結構;以網格作為網路的最小工作單元，研究了如何分配無線傳感器網路的冗餘節點來延長網路壽命;通過對網路壽命的分析，獲得了由各層網格的冗餘節點倍數向量rn 、 1 - n層節點倍增值rt和分配剩餘冗餘節點的概率密度函數f （ k ）共同構成的網路冗餘節點最優分佈條件。
分享友人
分享到 Line

分享到臉書