構架斜撐 的英文怎麼說

中文拼音 [gòujiàxiéchēng]
構架斜撐 英文
gallows bracket
  • : Ⅰ動詞1 (構造; 組合) construct; form; compose 2 (結成) fabricate; make up 3 (建造; 架屋) bui...
  • : Ⅰ名詞1 (用來放置東西或支撐物體等的東西; 架子) frame; rack; shelf; stand 2 (毆打; 爭吵) fight;...
  • : 形容詞(跟平面或直線既不平行也不垂直的) oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • : Ⅰ動詞1 (抵住; 托住) prop up; support 2 (用篙使船行進) push or move with a pole 3 (支持) mai...
  • 構架 : carcass; panel work; frame; buck; blind; reinforcement; thripple; backbone; framework; truss; fra...
  1. Scaffolds should only be sheeted in where the scaffold structure ( including ties and / or raking shores ) has been specifically designed to accommodate the additional wind loads that this imposes

    只是在腳手(包括橫拉和/或)經特別設計能夠承受額外的風力負荷的情況下,才可以封閉腳手
  2. Under the horizontal earthquake action and wind force, aim at " the pure frame structure with rectangle columns ", " the pure frame structure with special - shaped columns ", " the frame - truss structure with special - shaped columns " and " frame - shear wall structure with special - shaped columns ", earthquake action analysis was done by the spacial finite element method through the changes structural parameter. analyzing systematically " structure vibration mode ", " vibration period ", " structure lateral rigidity ", " seismic action force ", " seismic response force ", " floor seismic shear force ", " lateral horizontal displacement of structure " and " members internal force ". results indicate : ( 1 ) based on equal area, the special - shaped columns replaced the rectangle columns, the structural lateral rigidity enlarges, the lateral displacement minishes obviously, the earthquake response increase slightly, the biggest increasing amount of frame columns axis - compress ratio is smaller than 0. 08. the whole aseismic performance of structure has improved ; ( 2 ) when the section ' s length and section ' s thickness ratio of special - shaped columns is smaller than 3. 6, the structure benefits to resist seismic action ; ( 3 ) the angle of horizontal seismic action with the whole coordinate is 0 degree, structure earthquake response is bigger, belonging to a control factor of structure aseismic design ; ( 4 ) the frame - truss structure with special - shaped columns and the " a " - brace has the biggest lateral rigidity ; ( 5 ) the frame - shear wall structure with special - shaped columns have bigger lateral rigidity and smaller displacement, members internal force enlarged just rightly, have much superiority of resisting seismic action ; ( 6 ) in the higher seismic fortification criterion region ( 8 degree of seismic fortification intensity ), aseismic disadvantageous building site ( iii type site ), adopting special - shaped columns structure system, should reduce possibly the building ' s self - weight in order to reduce the earthquake response ; ( 7 ) the response spectrum method of computing seismic response and the time - history analysis method have similar analysis result

    西安理工大學碩士學位論文在水平地震作用下,並考慮風荷載組合,分別對「矩形柱純框」 、 「異型柱純框」 、 「異型柱框一析」及「異型柱框-剪結」等四種結體系,通過改變結參數,運用空間有限元方法,進行地震作用計算。系統地分析研究「結振型」 、 「振動周期」 、 「結側向剛度」 、 「結地震反應力」 、 「樓層地震剪力」 、 「結側向位移」 、 「層間位移角」 ,以及「件內力」 。結果表明:在等面積原則下,異型柱代換矩形柱后,結剛度增大,側向位移明顯減小,地震反應力略有增加,框柱軸壓比最大增幅小於8 % ,結整體抗震性能有所提高;當異型柱肢長肢厚比小於等於3 . 6時,結有利於抗震;水平地震作用力與整體坐標夾角為0度時,結地震作用效應較大,屬結設計的控制因素之一;異型柱框一析採用「人」字,側向剛度大於「八」字和「人一八」字混合;異型柱框一剪結側向剛度大、位移小,件內力增大適中,是一種抗震性能優越的結體系:在抗震設防烈度較高地區( 8度)和抗震不利的建築場地( m類場地) ,採用異型柱結體系時,應盡可能減輕結自重,降低地震作用力;分別採用「振型分解反應譜」法和「時程分析」法進行地震作用計算,兩種方法所得結果基本一致。
  3. Moreover, the influence of parameters, such as bracing stiffness, yielding displacement of the dissipater and different distribution of dissipating braces on the suppressive effectiveness of structure vibration is studied and some referential suggestion is presented for the design of passive energy dissipation system

    此外,本文還對耗能支減震參數(剛度、耗能器屈服位移)的改變以及耗能支的不同布置方式對結減震效果的影響進行了分析,為摩擦耗能支的設計提供一些參考性建議。
分享友人