槽值 的英文怎麼說

中文拼音 [cáozhí]
槽值 英文
slot value
  • 槽 : 名詞1 （盛牲口飼料或飲料等液體的器具） trough; manger （for water animal feed wine vat） 2 （兩邊...
  1. By using the software deform3d, a numerical simulation of the double - sided roll forming of discal parts in 24 different cases has been carried out and the influences of the roller geometry, workpiece geometry and process parameters on the groove shape have been obtained

    摘要利用商品化軟體deform3d ，對盤型件雙面輾壓成形過程進行了24種不同工況的數值模擬，獲得了輾壓溝槽的形態特徵以及工具參數、工件參數和工藝參數對溝槽形態的影響。
  2. To select a cylindrical plane cathode ; to design proper focus electrodes in order to control the formation of beam in methods of solving equations, electrobath and simulation aided by computer. to correct effects of anode hole and work out curves of designing guns ; to discuss plasma cathode guns at last

    選用圓形平面陰極;設計恰當的聚束極形狀以控制電子束的成形，並使用解析法、電解槽法和數值方法三種方法進行設計;考慮陽孔效應對電子束傳輸的影響，修正陽孔效應，給出電子槍設計曲線;最後討論一下等離子體陰極電子槍。
  3. Four tem - horn antennas have been made. using these antennas two - element rain gutter tem - horn array, two - element stacked tem - horn array, four - element rain gutter tem - horn array and four - element stacked tem - horn array are been mades up of. the results of experiment accord with theory and numerical stimulation

    最後，對tem喇叭天線陣列進行了原理性實驗研究，設計了帶地板結構的半tem喇叭天線，組成二元槽狀陣列、二元疊狀陣列、四元槽狀陣列、四元疊狀陣列等，應用小信號測試，得到的結果與理論和數值模擬相一致。
  4. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為： （ 1 ） 、這次冷渦在其發生發展過程中，其移動路徑是沿經圈直線南壓，攜帶的冷空氣勢力較強，形成槽后較強的垂直運動； （ 2 ） 、西太平洋副熱帶高壓偏北位置與東北冷渦南壓形成的急流軸，把源源不斷的西南暖濕氣流輸送到遼西地區，也就是急流軸的左前方位置，為這次暴雨的產生提供了充足的水汽來源； （ 3 ） 、低空急流不但為暴雨輸送水汽，其造成的較強的垂直環流也是產生強降水的一個主要原因； （ 4 ） 、 mm5模式以四維同化資料作為初始場，最大限度地避免了觀測誤差可能造成的積分不穩定，提高了模擬結果的參考價值。
  5. Abstract : the qiantang estuary with violent hydrodynamic conditions is well known for its tidal bore. the regulation of the estuary in the past, especially the progress since the founding of new china are reviewed. the principles of the regulation and planning of the qiantang estuary formulated in 1960s are expounded, i. e., to narrow the river to reduce the tidal prism, and to increase the ratio of the river flow to tidal discharge. the experience of estuary regulation / reclamation is summarized, especially the engineering measures to protect the groin head and to use polder dykes as sea defense works. finally, the effect is analyzed of the large - scale constraction / reclamation in the estuary on the tides, flooding high water level, estuary bed and the northern deep waterway in the hangzhou bay

    文摘:以涌潮聞名的錢塘江河口，動力強勁，破壞力極大.回顧錢塘江河口歷代治理情況，重點記述1949年以來治理工作的進展，論述60年代提出的錢塘江河口治理規劃的指導思想，即縮窄江道，減少進潮量，增大山潮水比值的整治原則.總結整治規劃實施過程中治江圍塗經驗，特別是「以圍代壩」和丁壩壩頭保護等工程措施.分析錢塘江河口大規模治江圍塗后對錢塘江河口潮汐、洪水位、河床以及杭州灣北岸深槽的影響
  6. Wet and dry numerical simulation tests for explosive cyclone over western pacific were performed. by contrast the results show that : tropopause and constant temperature surface were raised by latent heat release in upper level and disturbance trough was produced because air flow ascended and became cold. owing to this process adaption, inertial instability emergenced

    對氣旋強烈爆發的過程進行干濕對比數值模擬試驗，得出：潛熱釋放使對流層項和等溫面抬高，氣流在高層的上升冷卻形成擾動槽，其適應過程使高層出現慣性不穩定。
  7. Dean, r. g. and dalrymple, r. a. ( 1984 ), water wave mechanics for engineers and scientists, prentice - hall inc, englewood cliffs, new jersey

    王豪偉、黃清哲和吳京（ 2004 ） ，三維數值黏性波浪水槽之模擬，第二十六屆海洋工程研討會議論文集， 101 - 108頁。
  8. This paper has benefited in from close trade ' s experiences and combined with the trait of this aqueduct bridge to bring forward the method of classification evaluation, which was successfully used in the evaluation of this aqueduct bridge

    本文借鑒相近行業經驗，結合渡槽特點，提出了分級評估的方法。並成功地運用於該渡槽的評估。對同類型的工程進行評估，有著重要的參考價值。
  9. Study of a flood channel or flood - dominated channel of estuary is not only an important content in estuarine dynamic geomorphology and dynamic sediment, but also is a practical problem nearly related to the selection of harbor sites, regulation of sea - entering waterway, bank revetment and land reclamation, and even the comprehensive exploitation of estuaries

    河口漲潮槽的研究不僅是河口動力地貌學和河口動力沉積學研究的重要內容和前沿課題，而且對港口選址、通海航道治理、護岸圍墾以及河口綜合開發利用都具有重要的研究和應用價值。
  10. The incident wave height h1 / 3 is in the range from 0. 1m to 0. 25m, and the peak period tp in the range from 1. 0s to 2. 0s. the ratio of s / h1 / 3, which refers to the subface level of wharf deck ( s ) to the incident wave height ( h1 / 3 ), is between - 0. 1 and 0. 7. three different shore connecting types : open - piled, permeable slope with armored 1ayer of dolosse b locks and impermeable slope with armored layer of concrete plate, are set in the experiment for the research on the effects of boundary condition with different shore connecting types on the wave impact

    本文的物理模型試驗在大連理工大學海岸和近海工程國家重點實驗室的大波流水槽中進行，試驗中選用的隨機波靶譜為改進的jonswap譜，入射波波高h _ （ 1 / 3 ）范圍為0 . 1m 0 . 25m ，譜峰周期t _ p范圍為1 . 0s 2 . 0s ，碼頭面板的相對凈空（碼頭面板底面距離靜水面的距離s與入射波波高h _ （ 1 / 3 ）的比值）范圍為- 0 . 1 0 . 7 ，其中s / h _ （ 1 / 3 ）為負值時表示碼頭面板底面位於靜水面以下。
  11. For the bldcm which has a general crest width of the back - emf waveform, two kinds of torque ripple conditions when drived by sine - wave current as well as by square - wave current are deduced based on the mathematical models. in addition, a comparison is carried out between these two conditions, which indicates that sinusoidal current driving is more favorable to minimizing the torque ripple when the crest width of the back - emf waveform is less than a certain value

    闡述了抑制齒槽轉矩措施對反電動勢波形的影響，利用無刷直流電機的數學模型推導並比較了任意平頂寬度梯形波反電動勢在正弦波和矩形波兩種電流驅動下的電磁轉矩脈動情況，得出在梯形波平頂寬度減小到一定數值后採用正弦電流驅動更有利於減小電磁轉矩脈動。
  12. To develop a cad system for cardan cross - groove sphere, the kinematics model of cardan cross - pin spindles and the kinetics model of cardan cross - groove sphere are set up. 3. by applying com / com + technology on the whole development process of a cad system for cardan cross - groove sphere, which is based on the kinematics model and the kinetics model, several practical com components are acquired

    以建立的十字軸式萬向聯軸器的運動學模型和十字環槽式萬向聯軸器的力學模型為基礎，採用基於組件的軟體開發方法，將com com +組件技術應用於十字環槽式萬向聯軸器計算機輔助設計的整個過程，設計出多個具備一定實用價值的com組件。
  13. Elasto - plastic numerical analysis of 3 - d slotted hole blastion

    三維切槽孔爆破的彈塑性數值分析
  14. Only the method for using backwater expression can predict the variation of water surface near the spur dike very well. numerical simulations of the flume experiment cases are carried out with the standard k - e turbulence model

    隨后採用標準k一e紊流數學模型，依據水槽試驗資料，數值模擬了繞壩和漫壩兩種情況下水流的流動過程。
  15. Based on the hydrodynamic energy transport model, the influence of variation of negative junction depth caused by concave depth on the characteristics of deep - sub - micron pmosfet has been studied. the results are explained by the interior physical mechanism and compared with that caused by the source / drain depth. research results indicate that with the increase of negative junction depth ( due to the increase of groove depth ), the threshold voltage increases, the sub - threshold characteristics and the drain current driving capability degrade, and the hot carrier immunity becomes better in deep - sub - micron pmosfet. the short - channel - effect suppression and hot - carrier - effect immunity are better, while the degradation of drain current driving ability is smaller than those with the increase of depth of negative junction caused by source / drain junction shallow. so the variation of concave depth is of great advantage to improve the characteristics of grooved - gate mosfet

    基於能量輸運模型對由凹槽深度改變引起的負結深的變化對深亞微米槽柵pmosfet性能的影響進行了分析，對所得結果從器件內部物理機制上進行了討論，最後與由漏源結深變化導致的負結深的改變對器件特性的影響進行了對比.研究結果表明隨著負結深（凹槽深度）的增大，槽柵器件的閾值電壓升高，亞閾斜率退化，漏極驅動能力減弱，器件短溝道效應的抑制更為有效，抗熱載流子性能的提高較大，且器件的漏極驅動能力的退化要比改變結深小.因此，改變槽深加大負結深更有利於器件性能的提高
  16. Therefore the optimized dredging length is about 10km

    據此，挖槽長度的優化值約為10km 。
  17. Results show that threshold voltage uniformity of mesfet fabricated in planar selectively implanted process is better than that of in recessed - gate process

    結果表明，採用平面工藝制備的gaasmesfet閾值電壓均勻性比採用挖槽工藝制備的gaasmesfet閾值電壓均勻性更好。
  18. In order to study the influence of different process on the threshold voltage uniformity, gaas mesfets are fabricated both in recessed - gate process and planar selectively implanted process

    分別對採用隔離注入挖槽工藝和平面選擇離子注入自隔離工藝制備的gaasmesfet閾值電壓均勻性進行了比較研究。
  19. Methods, making the value of the first available slot either 3 or 7

    方法，因此第一個可用的槽值為3或7 。
  20. The change of database field content will influence the slot in fact list

    數據庫欄位內容的變化將影響到事實模板中槽值的變化，大大方便了用戶對事實的輸入。
分享友人
分享到 Line

分享到臉書