標定功率 的英文怎麼說
中文拼音 [biāodìnggōnglǜ]
標定功率
英文
nominal power- 標 : Ⅰ名詞1 [書面語] (樹梢) treetop; the tip of a tree2 (枝節或表面) symptom; outside appearance; ...
- 定 : Ⅰ形容詞1 (平靜; 穩定) calm; stable 2 (已經確定的; 不改變的) fixed; settled; established Ⅱ動詞...
- 功 : 名詞1 (功勞) exploit; merit; meritorious service [deed]: 戰功 military exploits; 立功 render me...
- 率 : 率名詞(比值) rate; ratio; proportion
- 標定 : demarcate; calibration; calibrating; standardization; pointing
-
Luminaires that conform to the safety standard should bear proper markings of rated voltage, rated frequency, rated power, number and type of lamp bulbs, model number, mark of origin ( manufacturer nametrade mark ) and symbol for suitability or non - suitability for direct mounting on combustible surfaces where applicable
符合安全標準的燈飾須有適當的標記,包括額定電壓、額定頻率、額定功率、燈泡的數目和類別、型號、原產地標志(製造商名稱或商標) 、是否適宜於直接安裝在可燃物質表面的標志等資料。The adoption of opm will undoubtedly embody the development opportunity of a company, thus making the result of valuation more reasonable, which is helpful to catch the m & a opportunity and improve the success possibility
期權定價技術的應用,無疑會使企業發展機遇這一要素能在目標企業價值中得以充分體現,從而使評估值進一步趨向合理,這有助於企業把握有利的並購機會,提高並購成功率。According to the minimum detectable power required by the spaceborne laser altimeter for 200km maximum range and the analysis result of the effect between the maximum range and the equation ' s each parameter, the specifications for noncooperative regulable attenuation setting were fixed on
根據月球探測激光高度計實現200km所需的最小可探測功率,各影響因子與最大測程關系的分析,確定非合作目標可調衰減法裝置的技術指標。Based on the analysis of the effect on the maximum range of the equation ' s each parameter and the traditional method of extinction ratio, the noncooperative regulable attenuation - measure the minimum detectable power of laser altimeter on the condition of constant miss probability by attenuating the laser power transmitting to the diffuse reflected simulant target - was put forward
在傳統的消光系數法基礎上,根據對月測距方程各系數的影響權重分析,提出了非合作目標可調衰減法,即:通過對漫反射模擬目標,衰減出射激光功率,在一定的漏警概率條件下測量激光高度計的最小可探測功率。Industrial fans - determination of fan sound power levels under standardized laboratory conditions - reverberant room method
工業風扇.標準實驗室條件下風扇聲功率級的測定.混響室法Industrial fans - determination of fan sound power levels under standardized laboratory conditions - part 2 : reverberant room method
工業用風扇.標準化實驗室條件下風扇聲功率級的測定.第2部分:混響室法The conventional sphere model of earth and circle model of orbit are discarded, and the ellipsoid model and the ellipse model are selected for further research, which achieves a method to determine the target position through the antenna pointing direction. and the spaceborne sar system design and simulation software is brought forth. this software accomplishes sar system coefficients design for antenna area, pulse repetition frequency, signal bandwidth, downlink data rate, radar transmitter power and satellite platform yaw steering
本文從星載雷達的星地幾何關系入手,舍棄傳統星載合成孔徑雷達研究中的球地球模型和圓軌道模型,研究了在地球橢球模型和橢圓軌道模型下由雷達天線確定目標坐標的方法,並在此基礎上研製了星載合成孔徑雷達系統設計與模擬軟體,完成雷達系統天線尺寸、脈沖重復頻率、信號帶寬、雷達信號數據率、雷達發射功率、衛星平臺的偏航牽引等幾個方面的系統參數設計以及雷達多普勒特性、雷達系統模糊、雷達定位及精度的分析,最後完成雷達回波信號的模擬。Standard test method for determining a - weighted sound power level of vacuum cleaners
測定真空吸塵器a -加重聲音功率級的標準試驗方法When blanket jamming is used, the more the ratio between the power of jamming and the power of signal, the less detection probability of the radar is. the effect of distributed jamming mainly depends on the total power. after distributed, the randomicity of distance and phase of jamming source bring difficulties to analysis
對壓制式干擾來講,干信比越大,雷達的發現目標的概率就越小,由於分散式干擾的干擾效能在於其合成功率,在分散式干擾單元分佈之後,各個干擾源與被干擾對象之間的距離的不確定性,帶來了干擾信號相位的不確定性,增加了分析干擾效能的復雜度。As the application of rake receivers with multitaps is widely used in cellularcdma systems for exploiting path diversity, the closed - loop power control schemesshould make use of the multitap rake receivers for tracking the power variation dueto path loss, slow fading, and fast fading
同時,本文給出的自適應變步長閉環功率控制演算法利用rake接收機跟蹤通道的變化,與傳統的固定步長閉環功率控制相比獲得了較小的ebi0標準差。Here a number of factors must be taken into consideration, such as the environmental standard of the area where the engine room is located, the fender structure of the engine room as well as the engine type, power level and the cooling air volume, etc. the core of the overall control is the concept of " equal sound insulation ", which means to apply a closed fender structure to isolate the engine unit from outside parts so as to cut the outward sound radiation
經過多年來與環保部門的合作,對油機房進行消噪聲處理,積累了一些治理經驗,主要是必須根據具體的機房項目來確定相應的控制方案,這其中應考慮機房所在區域的環境標準,機房圍護結構形式及油機機型、功率、冷卻風量等因素。綜合控制的核心是等隔聲概念,即用一封閉的圍護結構將機組與外界隔離開來,減少聲源對外的聲輻射。Based on the six - port relative power theory that for a given load the relative power ratios of different ports are left unchanged with the input power to the six - port varied, characteristic parameters of detectors can be obtained through the least - square method
根據六埠相對功率理論即對某一負載各埠相對功率比值不隨輸入功率變化,由最小二乘法得到檢波器的特徵參數,結合四標準法,確定六埠網路的系統常數。In chapter three, the all sub - circuits including uvlo, current bias, ldo, oscillator, green mode, slop compensation, power limiting, pwm, ovp, blanking time generator, logic controller are designed and simulated. as a result, all of the sub - circuits are satisfied the requirements
本文第三章對集成電路內各個模塊包括欠壓保護、電流偏置、 ldo 、振蕩器、綠色模式、斜坡補償、功率限制、脈寬調制、過壓保護、前沿消隱、邏輯控制電路等進行了設計與模擬,且達到了預定的設計目標。Thereby this paper puts forward four ways to reduce no, emissions : reduction of the highest combustion temperature, fuel emulsification, exhaust gas recirculation and selective catalytic reduction. according to the marpol convention, no, emissions are defined as per engine power of nox mass flow rate
Marpol公約附則規定的no _ x的排放標準為柴油機單位制動功率排氣中no _ x的質量流量(單位: g kw ? h ) ,因此要想對被測試的柴油機的no _ x排放進行判定,必須得到排氣中no _ x的質量流量和柴油機的制動功率。He finds the pitch range after calculated the three important parameters through the bladed for windows software, then presents an optimized control strategy that regulate the pitch angle in terms of the wind speed. it must control the output power because the variational output power brings the variational loads. he confirms and optimizes the control strategy that the output power is the control target, the output power is divided into three parts
將功率作為系統控制的目標,將功率分成三段進行控制,在低風速區,載荷是有限的,以功率最大化作為控制目標;在額定風速附近,由於處在升力曲線斜率的變化點,功率變化較大,應盡快調整槳距角進入失速區工作,減少載荷的波動,該額定風速區的上下工作點要通過現場試驗的手段來確定;在額定風速以上,使功率維持在額定輸出,減少功率波動,並通過bladed軟體的模擬計算對控制策略進行了驗證。Note : rated voltage = power rating resistance value or max. working voltage, whichever is lower
注:額定電壓=額定功率標稱電阻值或最大工作電壓中的較小值。Maximum rated power and the number of bulbs n x max. . w, n being the number of bulbs
燈飾常見的標記解釋如下:燈泡最高額定功率及數目The auto power calibration and the power control of the broadband radar signal source
寬帶雷達信號源自動功率定標與功率控制Sound system equipment - objective rating of speech intelligibility by speech transmission index
音響系統設備.用語音傳輸系數測定語音清晰度的目標額定功率Sound system equipment - part 16 : objective rating of speech intelligibility by speech transmission index
聲系統設備.第16部分:用語音傳輸系數測定語音清晰度的目標額定功率分享友人