標準粘度測量 的英文怎麼說

中文拼音 [biāozhǔnniándùcèliáng]
標準粘度測量 英文
standard visicosity measure
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 準 : Ⅰ名詞1 （標準） standard; guideline; criterion; norm 2 （目標） aim; target Ⅱ動詞1 （依據; 依照）...
  • 粘 : 粘動詞（粘附） glue; stick; paste; adhere to; bond
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 標準 : （衡量事物的準則; 榜樣; 規范） standard; criterion; benchmark; pip; rule; ètalon （衡器）; merits
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Standard test method for consistency of paints measuring krebs unit viscosity using a stormer - type viscometer

    採用stormer -型粘度計測量krebs單位用的塗料粘稠度的標準試驗方法
  2. Standard test method for adhesion strength and mechanical failure modes of ceramic coatings by quantitative single point scratch testing

    用定量單點劃痕試驗測定陶瓷塗層粘結強度和機械損壞類型的標準試驗方法
  3. Standard test method for bond strength of adhesive systems used with concrete as measured by direct tension

    用直接拉力測量與混凝土一起使用的膠粘系統的粘合強度的標準試驗方法
  4. Standard test method for measurement of average viscometric degree of polymerization of new and aged electrical papers and boards

    新的和老化的電絕緣紙和紙板聚合作用的平均粘滯程度的測量的標準試驗方法
  5. Standard test method for measuring apparent viscosity at high - temperature and high - shear rate by multicell capillary viscometer

    用多孔毛細管粘度計在高溫高剪切率下測量表觀粘度的標準試驗方法
  6. Standard test method to measure viscosity by tapered bearing simulator at high temperature and high shear rate

    在高溫和高剪切率下用錐形承載模擬器測量粘度的標準試驗方法
  7. Standard test method for measuring solution viscosity of polymers with a differential viscometer

    差示粘度計測量高聚物溶液粘度的標準試驗方法
  8. The temperature pressure measuring instruments of the standard programme can be used anywhere where liquid or gaseous materials to be measured do not attack copper alloys, do not crystallise and are not highly viscous

    溫度壓力計標準程序的溫度-壓力測量儀可以用於任何液體氣體介質測量，但介質不能腐蝕銅合金結晶或高粘稠。
  9. Standard visicosity measure

    標準粘度測量
  10. Viscometry ; determination of viscosities and flow curves using standard design rotary viscometers with a standard geometry measuring system

    粘度測量法.用帶標準幾何測量系統的標準結構旋轉粘度
  11. 1. experiments on uniaxial tensile of cfrp and gfrp are carried out, in which the tensile strength, young ' s modulus and ultimate deflection of frp are measured. the influence on tensile behavior caused by different adhesives is analyzed, and the standardization problem on tensile test methods is discussed

    設計了加載裝置和測量應變裝置，測試6種不同纖維片材和粘結劑組合的抗拉強度、彈性模量、極限應變，並分析不同粘結劑對纖維片材拉伸性能的影響，最後對纖維片材拉伸試驗的標準化問題進行了簡單的探討。
  12. Based on the data of vertical and horizontal displacements from a certain construction site in cixi city of zhejiang province, the validity of controlling earth - extrusion effects in saturated soft clay ground caused by statically piling was quantitatively analyzed and compared with different technical measures, including reduction of piling rate and installation of stress - relax holes

    摘要根據在浙江省慈溪市某靜壓法沈樁施工現場所監測的地基土位移數據，定量分析比較了控制施工進度、設置應力釋放和排水深孔等工程技術措施對減輕飽和軟粘土地基沈樁擠土效應的有效性，並初步提出了現場地基土位移及其變化速率的監控標準。
  13. Alkaline zinc - manganese battery is widely used all over the world it has good performance of storage ， low cost ， stable discharge and convenience of carrying the sealing of the battery is a crucial factor to the performance of the battery due to the disadvantages of present sealants ， leakage of electrolyte often happens what ’ s more ， the sealing capability affects the performance of the battery the way to raise the sealing capability is to search for a good additive ， which can improve the sealing capability through adding according to chemical principles ， this article picks out ptfe and nylon66 as additive adding ptfe or nylon66 into the pitch can improve the sealing capability of the pitch at the same time ， the temperature ， the time ， the amount of addictive ， the way to drop temperature and the time of churning all should be considered by testing the constitutions ， softening point ， moving degree and length of needle of various pitch samples ， we can compare the properties of different sealants can be studied by using of x - ray, the constitutions of the pitch can be indicated which can help us to explain these changes this article includes ： testing the constitutions ， soften point ， moving viscosity and needle penetration of various pitches ； raising the sealing capability by adding ptfe nylon66 into the pitches ； testing the constitutions ， soften point ， moving viscosity and needle penetration of raised samples ； analyzing and discussing the basic principles of this method it is showed that soften point ， moving viscosity and needle penetration of pitches are increased by adding ptfe nylon66 and the discharge time ， initial voltage ， capacity of battery with pitch raised by nylon66 are good and get to the requirement of gb t7 1 1 2 in a11 the method proposed in this article is available in practical industry use

    通過測定改進瀝青的軟化點、運動粘度和針入度等指標參數來比較不同的添加劑及不同的添加條件對瀝青封口性能的影響。本論文的主要研究結果為：系統測試了多種瀝青樣品的組成、軟化點、運動粘度、針入度；對市售瀝青分別添加聚四氟乙烯乳液、有機硅樹脂和尼龍66進行改進，制備了改進產品；對改進瀝青的組成、軟化點、運動粘度、針入度進行了測試和比較；使用改進瀝青組裝成電池並對電池進行恆電流放電測試、短路電流測試和電池漏氣、漏液性能的測試；對瀝青改進的原理進行了分析和討論。實驗結果表明：在瀝青中添加尼龍66和聚四氟乙烯乳液對瀝青的封口性能有明顯的提高；通過對工藝條件的不斷改進，目前的工藝條件已完全可以用於實際生產操作；以添加尼龍66改進的瀝青為封口劑組裝成的電池完全滿足堿錳電池生產的需要，且電池電容量、短路電流等指標均達到gb t7112標準要求；本文提出的改進方案，通過驗證是一種效果好、實用性強的方法。
  14. Standard test method for measuring viscosity at high shear rate and high temperature by tapered bearing simulator

    用錐形承載模擬器在高剪切率和高溫下測量粘度的標準試驗方法
  15. Standard test method for low - temperature viscosity of lubricants measured by brookfield viscometer

    用brookfield粘度計測量潤滑劑低溫粘度的標準試驗方法
  16. Standard test method for measurement of masonry flexural bond strength

    測量磚石工程彎曲粘結強度的標準試驗方法
  17. Astm d 789 - 98 provides an official, standardized procedure for testing polyamide or nylon molding powders

    98標準提供了一個測量聚酰胺/尼龍鑄造模粉粘度的標準方法。
  18. Standard test method for measuring the viscosity of mold powders above their melting point using a rotational viscometer

    利用旋轉米度計測量模製粉末熔點以上粘度的標準試驗方法
  19. Standard test methods for in situ measurement of masonry mortar joint shear strength index

    圬工灰漿粘接剪切強度指數現場測量的標準試驗方法
分享友人
分享到 Line

分享到臉書