模修 的英文怎麼說

中文拼音 [móxiū]
模修 英文
die repair
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 修 : Ⅰ動詞1 （修飾） embellish; decorate 2 （修理; 整治） repair; mend; overhaul 3 （寫; 編寫） write;...
  1. It was built after a european model.

    它是模仿一種歐洲的樣式修建的。
  2. This thesis firstly introduces new demands of aerial product logistics support under high - tech war and some defects of traditional logistics support, and puts forward a kind of system model of aerial product logistics support following data - sharing of cals, and emphasizes detm. secondly it sets forth application of step and xml in the ietm, researchs conversion of xml schema and relation schema, and simply researchs mapping of xml and express. afterword, a based - xml framework of info - transfer between different platform are presented, according to this framework, the author establish a archetypal system of helicopter information query system based xml and dbms

    本文首先介紹了現代高科技戰爭條件下對航空產品維修保障的新要求，概述了傳統的後勤保障技術的不足，遵循cals的數據共享的理念，提出了航空產品維修保障系統模型，重點研究了互動式電子技術手冊；接著分析了step標準和xml技術在製作互動式電子技術手冊中的應用，重點研究了肌模式和關系模式之間的相互轉換，初步研究了xml和express語言之間的映射關系；然後，提出了基於xml的一種解決航空產品信息跨平臺傳遞的解決方案，給出了該方案的具體實現流程和詳細的通訊協議，並開發了基於xul和數據庫的某型號直升飛機的信息查詢原型系統。
  3. Also, this paper studies the amendable methods of dynamic numeration model, and bring forward that optimized method can revise finite element model, while validating the construed results of structural mode is almost equal to true values

    本文研究了各種動力計算模型的修正方法，針對有限元程序，提出了用優化的方法實現結構動力有限元模型的修改，通過算例驗證，結構模態分析結果更接近於實測值。
  4. At the same time, the section studies a new amendable method on drawing - up the dynamic extension forms of the motion input - output forms, it discusses the defer problem of input - output analysis too. meanwhile, it points out the fact that motional inut - ouput is a motional problem. however, the authentic economical running which recreates constantly is continual and dynamical, that is to say, it have to think about investing

    本章還從靜態投入產出模型入手，研究了利用動態投入產出模型編制投入產出表的一種新修正方法，討論了投入產出分析中時滯問題，並指出，靜態投入產出模型是一個靜態問題，而現實生活中的經濟運行是連續性的，動態的，不斷擴大再生產，也就是需要考慮投資的問題，文中還討論了規劃問題和預測問題的前提條件。
  5. An amendatory interior ballistic model taking into consideration motions of the gun

    計及火炮運動的內彈道修正模型
  6. In this paper, a new amendatory shear mechanism of beams and columns based on the " truss + arch " mechanical model is put forward

    在本文中修正的提出了建立在桁架+拱力學模型基礎上的抗剪理論。
  7. The model of the itr between a1n and cu is built by using the acoustic mismatch model, amm and diffuse mismatch model, dmm. because there is a limit of roughness and temperature in amm and dmm, the data of the theory model that is directly built by amm and dmm is far from the experimental data. accordingly, with dmm and traditionary methods, the mathematics model is posed by contrast and analyses of the experiment data

    由於聲失配理論和散聲失配理論對溫度和粗糙度有很嚴格的要求，所以直接建模所得的理論數據與實驗數據有很大的差距，本文採用聲失配理論與傳統研究方法相結合，通過與實驗數據的分析擬合，提出了修正的數學模型，預測誤差有了大幅度的提高。
  8. The system can display in 3d the robots with higher quality graphics on pc by adopting the solid model technology, and modify the model of robots according to the size given by users, so that the parametric modeling is realized under interactive mode. it realizes the graphics simulation of robots in kinematics in both articulatory space and cartesian space, and it also realizes the animated simulation of trajectory of linear interpolation in point - to - point mode. the movement of robots can be realized by graphics teaching or programming

    該系統採用實體造型，能在微機上顯示較高質量的機器人的三維圖形，可以按照用戶給出的尺寸修改模型，在交互方式下，實現機器人的參數化造型；系統能夠在關節空間和笛卡爾空間中進行運動學的圖形模擬，能進行點到點直線插補軌跡的動畫顯示，機器人的動作可以示教再現，也可以由程序設定。
  9. The essential aspect of the mathematic model for inductor is the description of the hysteresis loops of the magnetic core material. the jiles - atherton ferromagnetic theory combined with the experience formula proposed by h. g. brachtendorf, c. eck and r. laur, was applied in this case. the model is more flexible than jiles - atherton ’ s, especially in the circuit model convert

    本文採用了由h . g . brachtendorf 、 c . eck 、 r . laur提出的經驗公式與jiles - atherton鐵磁磁滯理論相結合的修改新數學模型，並將該模型轉換為等效電路模型模擬磁滯特性，實驗結果表明，該模型比jiles - atherton模型靈活，利於轉換為宏觀電路模型。
  10. This paper mainly aims at the characteristics of the hardware and software structure of the parallel computer on satellite, and has fulfilled researches of fault tolerant technique in three aspects of control theories and engineering : the first research of the system level fault - tolerant module is based on the system structure of the parallel computer on satellite, a kind of cold backup module and a kind of hot backup module for multiprocessor computer have been put forward. then the research of software fault tolerant technique which is based on the operate system named rtems has been carried, the mission level fault - tolerate arithmetic and the system level fault - tolerate mechanism and strategies based on the check point technique have been put forward, at the same time the self - repair technique of software which has used the technique of system re - inject has been studied. finally the technique of components level fault - tolerant based on fpga has been studied, a kind of two level fault - tolerant project which aims at the fault - tolerant module of the parallel computer on satellite has been put forward, and the augmentative of circuit that project design realization need is little, this project can avoid any breakdown of any part logic circuit of the fpga

    本課題主要針對星載并行計算機體系結構及軟體結構的特點，從如下三個方面進行了容錯控制理論研究和實踐工作:首先進行了基於星載多cpu并行計算機體系結構的系統級容錯模型研究，提出了一種多cpu冷備份容錯模型和一種多cpu熱備份容錯模型;然後進行了基於rtems操作系統的軟體容錯技術研究，提出了任務級容錯調度演算法以及基於檢查點技術的系統級容錯恢復機制和策略，同時研究了利用系統重注入進行軟體在線自修復的容錯技術;最後研究了基於fpga的部件級容錯技術，提出了對容錯模塊這一星載并行計算機關鍵部件的兩級容錯方案，實現該方案所需增加的電路少，可避免板級晶元以及fpga晶元內部任何邏輯發生單點故障。
  11. Applying the information extracted from numerous hydrographic data of field trials collected by h / hcs - 017, the first set of multi - beam swath bathymeter developed in china, a series of mosaic techniques have been carefully studied in this thesis, including digital terrain model building, statistical error analyzing, hydrographic data mosaicking as well as tides correction and projection of the earth coordinates. finally, standard digital sea - charts and three dimensional seafloor images are successfully developed that are consistent with hydrographic surveying principles

    本文利用我國第一臺h hcs ? 017型條帶測深儀的測量數據進行拼圖技術的研究，主要研究的內容有：利用分帶原理對深度數據進行潮汐修正，得到瞬時海面的深度數據；對測深數據進行誤差分析處理，去除野值；將多波束數據進行坐標變換及投影轉換后構建數字地理模型，進而根據海道測量規范繪制標準海圖。
  12. Socket to do bios programming simulate modify

    Socket來做bios的撰寫模擬修改
  13. 32pin rom socket to do bios programming simulate modify

    Socket來做bios的撰寫模擬修改
  14. The last major renovation of the building probably took place during the guangzu reign 1875 - 1908 of qing dynasty as indicated by the engraved characters on the stone tablet above the main entrance. most of the original structure and features of the building remain intact

    據祠堂正門石額所載，清光緒年間（一八七五至一九八年）曾進行大規模修葺，但仍基本保持原來的結構和特色。
  15. It underwent a number of large - scale renovations, with the latest undertaken in 1942, during the japanese occupation, by a japanese engineer, siechi fujimura, who designed to construct a dominant central tower to link the two original buildings ; the roofs were also modified to add in more japanese flavour, thus diminishing the strong european style of the mansion

    建築物曾經歷多次大規模修繕，最後一次工程在一九四二年日治期間進行。日軍占領香港期間，把禮賓府用作司令部，並委派日本工程師藤村正一設計一座高塔樓，加建於原有兩座建築之間，把兩座建築物連接起來；在屋頂加上日式瓦片，淡化建築物的歐陸風味。
  16. The company is capable of developing, designing and manufacturing mould, convenient mould testing and repairing as well as professional color matching staffs, largely shortened the processing cycle

    自行模具開發設計和製造，試模修模方便，經驗豐富的配色專業人員，大大縮短了加工周期。
  17. The geographic software of 3d views are comparatively more in software kingdom, but most of them use the structured methods, it can only through the large scope modified to achieve the system ' s request when the programming is error or the system need to be upgrade

    處理地質三維可視化的軟體比較多，然而他們使用的是面向結構化的編程方法，當程序出錯、或者是系統需要升級換代時，只能通過大規模修改程序的方法使系統性能達到用戶新的需求。
  18. In practice, the predication of the trimming line, which is the reference of trim die design, was decided by trial - and - error procedures. it is not only time - consuming but also expensive. based on the fea, this paper discusses the simulation of the flanging process of large and complex sheet metal parts

    在以往的生產實際中，作為設計修邊模依據的修邊線的確定都是靠不斷地試模、修模來決定的，這樣不僅影響整個產品的開發周期，而且還造成大量的人力和物力的浪費。
  19. In 1991, the market was stylishly refurbished and now features a variety of retail outlets. the market is open 10am - 7pm daily

    經過大規模修建后，昔日的上環街市已於1991年修葺改建為西港城購物中心。
  20. The great wall was renovated from time to time after the qin dynasty. a major renovation started with the founding of the ming dynasty in 1368, and took 200 years to complete

    秦以後的一些朝代對長城也曾屢加修建，最後一次大規模修築始於明代建國之初的一三六八年，全部工程歷時二百年才完成。
分享友人
分享到 Line

分享到臉書