模抑制 的英文怎麼說

中文拼音 [móyìzhì]
模抑制 英文
mode suppression
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 抑 : Ⅰ動詞（向下按; 壓制） restrain; repress; curb Ⅱ連詞[書面語]1 （表示抉擇） or 2 （表示轉折） but3 ...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 抑制 : 1 （控制） restrain; control; check; hold up; curb; stop; repress; bridle; choke; prehension; sup...
  1. Common code rejection ratio cmrr

    共模抑制比
  2. Common code rejection ratio

    共模抑制比
  3. Cmrr is the most important feature of instrumentation amplifier

    共模抑制比是它的最重要指標。
  4. The simulation result shows that, the cmrr of current - mode instrumentation amplifier be able to reach 97db, and the psrr to 85db

    儀表放大器的模擬結果表明，在沒有激光調阻技術支持下，本文設計的電流模儀表放大器的共模抑制比能夠達到97db ，電源抑制比能夠達到85db 。
  5. Then we deduce the couple - mode equations that describe the mode coupling behaviors in this kind of gratings. based on this, we study the photosensitive inner cladding ' s influence on the core - mode - core - mode coupling and the core - mode - cladding - mode coupling in this kind of grating. a fiber bragg grating was experimentally fabricated with this kind of photosensitive fiber

    然後以第二章給出的耦合模理論為基礎，結合用帶光敏內包層的包層模抑制光纖的結構特性，推導出用這種光纖製作的光纖布拉格光柵的耦合系數和耦合模方程。
  6. A series of lasers with about 0. 8nm spacing have been achieved. the smsr is higher than 54db

    獲得了一系列波長間隔約為0 . 8nm ，邊模抑制比大於54db的激光輸出。
  7. The side mode suppression ratio about 39db is realized. 5. a tunable cladding - pumped yb3 + - doped fiber laser system is reported

    55 m可調諧光纖光柵外腔半導體激光器，得到調諧范圍為7nm 、邊模抑制比達39db的激光輸出。
  8. Generation of tunable dual - wavelength optical short pulse using a self - seeding scheme with enhanced sidemode suppression ratio

    以自激注入鎖定方式生成邊模抑制比高的可調諧雙波長超短光脈沖
  9. Owing to weak output signals integrated amplifier is designed, which is characteristics of shorter wires, higher input impedance, higher common mode rejection ratio and series mode rejection ratio, smaller zero shift and temperature shift

    由於輸出信號微弱，採用短線路傳輸，高輸入阻抗，共模抑制比和串模抑制比高，溫漂和零漂小的集成運放電路。
  10. Altogether mold rejection ratio : 80db

    共模抑制比： 80db
  11. The total mold represses a ratio

    共模抑制比： 80db
  12. Cmrr common mode rejection ratio

    共模抑制比
  13. Common mode rejection ratio

    共模抑制比
  14. Common - mode rejection ratio

    共模抑制比
  15. Series - mode rejection ratio

    串模抑制比
  16. Side mode suppression ratio

    邊模抑制比
  17. In this paper the measurement of conductive emi emission is discussed, and the design of cm / dm discrimination network is also presented, further, the performance of insertion loss ( il ) and common - mode rejection ( cmr ) is researched, together with the test approach and experiment results

    摘要分析了傳導性電磁干擾信號的測量方法，提出基於共模差模（ cm / dm ）信號的識別網路設計，進一步研究了模態識別網路的插入損耗（ il ）及共模抑制比（ cmr ）等重要性能，並給出模態識別網路的性能實驗設計與分析方法。
  18. ( 3 ) with the increase of the injected current, the lasing wavelength of fgesl appears fluctuation, the side mode suppression ratio ( smsr ) increases accompanied by an oscillation, and the p - i curve distorts slightly

    Fgesl的激射波長隨ld的注入電流的增大而發生波動;邊模抑制比（ smsr ）隨注入電流的增大總體上呈現上升趨勢，但其變化過程並不平滑而是有較大的波動; fgesl的p一i曲線有微小的扭曲。
  19. To put it into practice, the influences of the parasitic capacitances have to be further investigated using a simplified equivalent circuit

    對于本課題組提出的反相共模抑制技術，使用一個簡化的等效電路，本文進一步研究了寄生電容在其中的影響。
  20. Series - mode rejection

    串模抑制
分享友人
分享到 Line

分享到臉書