模擬加速器 的英文怎麼說

中文拼音 [jiā]
模擬加速器 英文
analog accelerator
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 動詞1. (設計; 起草) draw up; draft 2. (打算; 想要) intend; plan 3. (模仿) imitate
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. Various sensors that are besotted in the 3d world through vrml can effectively sense all kinds of operators " behaviors ; java byte codes that are besotted in the interface between vrml and java through the " script " node can finish difficult tasks. so the alteration can be concluded as follows : operators touch parts of the shelf, and the java byte codes execute the relative function, finally results are reported to the operators. ( 3 ) through detailed studying the working function of the throttling experiment, i constructed a mathematical model of the experiment and simulated the model

    Vrml可以在瀏覽環境中為3d實驗臺型添多種感知,能夠良好地感知操作者的各種意圖;在vrml和java技術的介面中,可以利用java程序代碼來完成一些復雜的任務,從而實現了實驗的交互:實驗者感知實驗臺的各種儀,程序完成相應的任務,然後返回相應的結果; 3 )仔細研究了節流調實驗的液壓迴路原理,對實驗過程建立了相關數學型,進行分析並獲得了結果,實現了基於型驅動方法的虛實驗; 4 )實驗臺遠程訪問的實現。
  2. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上在冬夏兩季不同情況下,不同流對熱管空氣預熱壁面溫度的影響;然後對影響整個流場分佈的各種因素:包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值;最後提出在分流煙道轉彎處裝導流板,並裝導流板后的流場分佈,得到下級空氣預熱出口、熱管空氣預熱進口處的斷面度場分佈、濃度場分佈,以論證裝導流板能達到流場均勻化的作用。
  3. The driver model should imitate the behavior of a real driver as well as possible. for this purpose, the staring behavior was defined by taking into account the coalesce process about the drive side and take - off side of the friction clutch, the driving behavior was defined by taking into account the change of acceleration pedal position, arrester pedal position and clutch pedal position in the shifting process

    定義車輛起動特性時考慮了起步階段離合主從動部分的接合過程,定義行駛特性時考慮了行駛階段踏板和制動踏板的開度變化以及換檔過程中離合踏板和踏板的開度變化情況,真實地描述了一個駕駛員的特性,使得結果更接近於實際。
  4. This paper presents the logic circuit design of ccu for lx - 1164 cpu chip, for ccu, data and instructions are stored in separate data and instruction caches

    本人有幸在夏宏博士的指導下參這一工程,承擔lx ? 1164cpu的高緩存控制( ccu )的邏輯設計和功能
  5. Using matlab and its add - ons simulink, through establishing simulation maths model, the paper integrates open chain vector equation ( describing motion restriction ), numerical value simulation ( computing velocity and displacement while given acceleration ) and matrix algebra, etc. to accomplish dynamic simulation for the robot and verifies the results for kinematics of the robot using analysis method, and it establishes foundation for following study for the robot such as kinetics, control, etc

    利用matlab及其附軟體simulink ,通過建立數學型,綜合開環矢量方程(描述運動約束) 、數值(在度已知時計算度和位移) 、以及矩陣代數等來完成機人動態,對所研究的機人運動學分析結果進行驗證,結果基本一致,為機人的后續研究,如動力學,控制等奠定基礎。
  6. In this paper, we have studied the feasibility for the bpm of to be button electrode was used in the lia and the simulating has done for the use by pspice / orcad

    本文研究了鈕扣電極束位置探測應用於強流直線感應( lia )的可行性,並用pspice orcad電路軟體進行了計算。
  7. The control of beam halo - chaos becomes a critical problem in the development of high intensity accelerator. efforts to remove the halo by collimation have been largely unsuccessful since the halos almost always regenerate. the mechanisms of halos are complex, such as nonlinear resonances and chaotic behavior etc. considering this, professor fang jin - qing who works in china institute of atomic energy pointed out that the theory of chaos control can be used to control beam halos. he presented the method to control halos by using nonlinear functions, which means nonlinear function g is added to the right of ion radial self - edlctric force equation and some nonlinear function are selected to control beam halos in simulations. in paper [ 69 ], controllerg = - 0. 15sin ( rmax - am ) 2 was used and the halo intensity was decreased to 0. 1078, the halos are removed partly

    束暈?混沌的控制是新一代強流研製的關鍵問題,隨著強流離子束應用前景的日趨廣闊而日益成為研究的熱點。傳統機械限束因無法解決束暈的再生而收效甚微,因為束暈的形成有著其內在動力學機制?非線性共振以及混沌等。基於此,中國原子能科學院研究員方錦清將混沌控制的理論和方法開創性的運用於束暈?混沌的控制上,提出了控制束暈?混沌的非線性控制策略,即在粒子徑向所受束自生場力方程的右邊上非線性控制函數g :並選取一些非線性函數如等進行了控制的研究,將束暈強度控制在0 . 1078左右,取得了初步的控制效果。
  8. 5. according to the requirement of amt start up experiment, using dynamic link library to program for different kinds of data acquisition card and transferring data between pc and multi scm. in this way data can be acquired successfully and engine throttle 、 clutch locking speed and eddycurrent dynamometer torque were controlled by pc programs

    根據試驗要求,採用動態鏈接庫的方法對不同數據採集卡進行混合編程,順利地採集參數和控制發動機節氣門開度及離合結合度,利用上下位機多機通信,使上位機控制電渦流測功機,實現了載。
  9. Circuit modeling of yang accelerator ' s transmission lines

    水傳輸線及磁絕緣傳輸線的電路
  10. The rate of single event upset ( seu ) for space - based missions has been predicted by means of ground - based particle accelerator test and simulation calculation based on models of space radiation environment and the interaction of ions with the microelectronic device

    我們採用的方法是用地面重離子實驗和計算機空間輻射環境進行單粒子翻轉率預估計算。引發單粒子翻轉的空間高能帶電粒子環境包括銀河宇宙線,太陽宇宙線和地球輻射帶中的高能質子及重離子。
  11. The frequency and mode of the generated microwave are very pure. these results can provide a possible method for constructing a compact high - power microwave device. in addition, a virtual cathode oscillator with an axially extracted te11 mode based on the spark05 accelerator in our laboratory has also been investigated using the pic simulation code

    基於spark05電子束參數設計的軸向提取te11虛陰極振蕩,利用類似的設計思想,通過改變電壓的饋入方式和陰陽極結構,實現了中心陰極負脈沖電壓的激勵,同樣獲得了較好的粒子優化結果。
  12. The paper researched the model and simulation of pwr nuclear power plant and found the basis for the research and simulation of " ads ". the paper mainly include : 1. the modeling of main component of the pwr nuclear power plant main circuit system and established the suitable teaching system ' s physics - mathematics modeling for microcomputer simulation

    本文研究了壓水堆核電站系統的建問題,初步完成了pwr核電站物理運行的pc機教學演示平臺系統,同時為「驅動潔凈核能系統」 ( ads )的基礎研究成果演示與奠定基礎。
  13. There is a lack of analysis apparatus of magnet, the new system is only a opened loop control system, if we add the analysis part of the ion eletrostatic accelerator someday, all that we need to do is adding analog module hi plc and sampling control arithmetic hi the computer program. we will get a perfect closed loop control system

    在目前缺乏磁分析儀的情況下,該系統雖然還只是開環控制系統,但是一旦中束線分析部分到位,它只需增量輸出塊和采樣控制演算法,就能形成完善的閉環控制系統。
  14. Radiation effects have been investigated up to - 30 dpa by the heavy ion irradiation simulation and positron annihilation lifetime techniques in the home - made modified 316l stainless steel and the commercially available stainless steel and tungsten, which are used as the beam window materials for the spallation neutron source in accelerator driven radioactive clean nuclear power system ( ads ). their radiation resistance properties are compared

    本工作採用重離子輻照和正電子湮沒壽命測量技術研究了驅動潔凈能源系統( ads )散裂中子源束窗材料鎢、普通不銹鋼和國產改進型316l奧氏體不銹鋼在0 30dpa輻照劑量范圍的輻照效應,並對它們的抗輻照性能作了比較。
  15. In the designing of priority for the transmission ratio, the usage of gear ' s attest on transmission ration should be considered ; the average value is set as the evolution aim of the loss of driving power and the useful effectiveness. a simplified fuel - consumed economically model is used to simulate the fuel consumption while the automobile is in motion

    在變傳動比優化設計中考慮檔位使用率對變傳動比的影響,採用驅動功率損失率和有效效率利用率的權平均值作為評價指標,用參數樣條函數狀態下的燃油消耗量,提出了按變傳動比的使用率來確定汽車的和等的比例,並將其作為實際工況來確定汽車的實際燃油消耗率。
  16. Then, the beam orbit correction in bepcii lianc is simulated by optimum liar program and a design study on the optimum orbit correction system for bepcii linac is discussed. the optimum corrector ' s distribution and the required tolerances of misalignment of the linac components are given

    最後用改進了的liar程序對bepc直線軌道進行計算,討論了該校正系統的設計研究,並給出了軌道校正系統的優化布局和對部件的安裝公差的要求。
  17. Design and simulation of a 1. 2mev electron accelerator used for desulfuration and denitrogenation

    脫硫脫硝電子的設計與
  18. The y rays detecting system for physical diagnosis in nuclear exploding must be calibrated in the pulse radiation field according to field spots. so the 12mv pulse x rays accelerator and the fast neutron reactor are selected as radiation sources for calibrating

    核爆物理診斷探測系統需要在脈沖輻射場中按場點光子注量進行標定,為核爆產生的輻射場,選定12mv脈沖x射線和快中子脈沖堆為標定用脈沖輻射源。
  19. Secondly, the beam orbit offset effects caused by the initial beam offset and the linac components " offsets have been quantitatively studied first. as an example with the injector linac for beijing electron positron collider upgrading project ( bepcii ), the beam orbit offset caused by the above error effects have been simulated and analyzed

    其次定量研究束流的初始徑向誤差和部件的安裝誤差等對束流軌道偏軸的影響,並以北京正負電子對撞機二期工程( bepc )的直線為例,給出了上述各種誤差導致軌道偏軸的計算結果及其分析。
  20. Simulated load measuring of large power gearbox based on virtual instrument

    基於虛的大功率減載測控
分享友人