模擬基帶晶元 的英文怎麼說

中文拼音 [mónǐjīdàijīngyuán]
模擬基帶晶元 英文
analog baseband chip
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 擬 : 動詞1. （設計; 起草） draw up; draft 2. （打算; 想要） intend; plan 3. （模仿） imitate
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  • 模擬 : imitate; simulate; analog; analogy; imitation; simulation模擬艙 boilerplate; 模擬電路 [電學] circ...
  1. In all kinds of complicated network, oriented linking and unlinking, communication frequency resource is strained, and bandwith to transmitting audio frequency signal is too restricted, complicated and fluky, while audio frequency data exponential have been increased in the last several years. under the circumstances, based on the research of predecessor, this paper studies wavelet analysis ' s maths gist and practices significance on signal process, and puts forward a optimized wavelet package condensation arithmetic to process audio frequency data, which gives attention to coding efficiency, multirate and compression delay. simulation experiment on the arithmetic has been done by matlab

    針對無連接和面向連接的各種復雜網路環境下，通信頻帶資源緊張，音頻傳輸帶寬有限且復雜多變，而各種音頻數據又日益增多的局面，本文研究小波分析在信號處理方面的數學依據和在數據壓縮方面的實際意義，在前人不斷工作的基礎上，提出了一種優化小波包變換編碼方案用於音頻數據的壓縮演算法，兼考慮了編碼效率、多碼率和壓縮時延多個方面，並在matlab環境下做了模擬實驗，對各種音頻信號及多種小波函數做了模擬結果比較，實驗結果證明該演算法可以在一定計算復雜度下可以很好地改進壓縮效果，達到多碼率下實現實時編解碼的過程，在高速dsp晶元等硬體設備支持下，可以有效應用於實際復雜多變信源編碼。
  2. In order to make the sensitivity of 2 - demension accelerometer along the two main arbors almost identical, symmetric four - beam structure that embeds a double - sides interdigitated differential capacitive with puckered beam in two directions was used as sensitive component. in addition, the differential capacitive accelerometer fabricated by bulky silicon micromechanical technique has high sensitivity, wide measurement scope, less nonlinear error, and simple converting circuit. then, the structure parameters of the sensitive component were calculated and stimulated, which results in a set of the optimized structure design parameters, main fabrication procedure and several key fabrication technology

    為使二維振動傳感器在兩主軸方向的靈敏度大致相同，敏感元件採用高度對稱的四梁結構，其中每個軸向上均採用帶折疊梁的雙側叉指電容結構，採用體硅微機械工藝製作的高深寬比叉指電容式敏感元件，具有高靈敏度、寬量程、非線性誤差小、外圍電路簡單等優點;對設計的敏感元件結構參數進行了計算，並利用有限元法進行了模擬分析，根據模擬結果得出了優化參數;在確定敏感結構的基礎上，研究了敏感元件採用體硅微機械加工工藝製作的工藝流程和關鍵工藝技術;對敏感晶元內部的c - v介面電路進行了原理設計與分析，利用差動測量技術得到由振動引起的微小電容變化量，經c - v介面電路進行相位調制處理，然後通過解調輸出與加速度成正比的電壓信號。
  3. We also develop an experiential formulation based on structural unit model for high - index surfaces and that can give an estimate of the energies of the high - index surfaces, given the value of surface energy of ( 001 ), ( 110 ) or ( 111 )

    在此基礎上，提出了基於表面結構單元模型的[ 001 ]晶帶和[ - 110 ]晶帶表面能的經驗計算公式。公式計算結果和採用分子動力學模擬結果一致。
  4. Numerical viscoelastic modeling for porphyroclast rotation in ductile shear zones is done by a viscoelastic finite element program based on detailed investigation to three ductile shear zones, the taihangshan mountains, north china. in this model porphyroclast garnet is assumed as isotropic elastic material with small elastic deformation, while the matrix quartz, feldspar as viscous fluid maxwell material which has increasing deformation with time. the viscosity of matrix is supposed to be 10

    採用粘彈性力學分析程序對太行山阜平地區剪切帶中斑晶旋轉問題進行了有限元數值模擬。在計算模型中假定：石榴石斑晶為彈性材料，在應力作用下只產生很小的彈性變形石英長石質的基質部分為粘彈性材料，它具有隨時間變形不斷增大的特性。
  5. Simulation indicates : using band - pass sampling is right in digitalizing if signal ; it is necessary to use special chip to process if digital signal ; at the same time, it is feasible to process base - band low speed signal ( am, fm etc. ) by software

    模擬表明：中頻數字化技術，使用帶通采樣方案是恰當的；現階段對中頻采樣信號使用專用晶元作降速率處理是必然選擇；同時，對基帶低速率信號（如am 、 fm 、 bpsk信號）作全數字化軟體處理是切實可行的。
  6. Firstly, a data acquisition circuit was designed, which is consisted of ad420, dac702 and ad7701. then, comparing with different usb control ics, an2131 was selected to achieve the control of data acquisition and usb communication. detailed rules to develop a usb device general purpose drivers were introduced, and the virtual instrument application software was developed basing on labview

    首先是數據採集卡的製作，包括由ad420 、 dac702數模轉換晶元構成的模擬輸出通道，由ad7701 、 ad8200構成的模擬輸入通道;然後比較幾種不同的usb介面晶元，選擇帶usb介面的an2131微處理器實現數據採集的控制和usb傳輸功能;之後是usb設備驅動程序的開發和基於labview的虛擬儀器應用程序的設計。
  7. When the channel changes rapidly, this proposed dynamic algorithm is efficient. other than above, this paper also studies the character of ofdm under multipath fading and gives the baseband computer simulation by systemview. at last, it performs ofdm dsp hardware plug - in simulation

    利用systemview軟體進行模擬多徑通道下ofdm系統性能模擬，並探討了模擬過程中的一些問題，最後搭建了ofdm基帶模擬系統，並利用tms320c54dsp晶元，進行了ofdm硬體嵌入式模擬。
  8. Second, the design of hardware module including a / d converter, ddc ( digtial downconverter ) and dsp was illustrated. in this part, the design and application of ad6644, hsp50216 and dsp chips are fully discussed. the design of software module mainly refers to the parameter design for ddc filter and the baseband signal processing of dsp which is realized by some simulation

    其次模塊的硬體設計，主要包括： a d轉換器、數字下變頻（ ddc ）以及dsp ，詳盡地介紹了a d轉換器件ad6644 、數字下變頻hsp50216 、 dsp晶元的設計方法，模塊的軟體設計主要是數字下變頻參數的設計和后續基帶信號的處理，並對該系統實現系統模擬。
  9. Based on the principle of gmsk, analyzing the form of gmsk modulation and demodulation, we have completed the system simulation of gmsk in the systemview platform, at the same time, combined with hardware and software, we have realized modulation and demodulation of gmsk with the dsp chips tms320vc549

    在熟悉gmsk調制解調原理的基礎上，分析了gmsk正交數據機的基帶構成，完成了在systemview平臺下gmsk數據機的系統模擬，並將模擬演算法用於tms320vc549dsp晶元，使用軟硬體結合的方式完成了gmsk基帶信號的調制解調，為國內研製ais系統儲備了關鍵技術。
分享友人
分享到 Line

分享到臉書