模腔表面溫度 的英文怎麼說
中文拼音 [móqiāngbiǎomiànwēndù]
模腔表面溫度
英文
cavity surface temperature- 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
- 腔 : 名詞1. （動物體內空的部分） cavity; chamber 2. （話） speech 3. （樂曲的調子） tune; pitch 4. （說話的腔調） accent; tone
- 表 : Ⅰ名詞1 （外面;外表） outside; surface; external 2 （中表親戚） the relationship between the child...
- 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
- 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
- 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
- 表面 : surface; superficies; boundary; face; rind; sheet; skin; outside; appearance
- 溫度 : [物理學] temperature
-
According to heat load source of die cavity, temperature distribution gradient equations and heat flux equations and the peak value equations of temperature load at die cavity surface have been obtained with research of temperature distribution and transfer laws of die surface by unsteady heat transfer theory
摘要根據鍛模型腔熱負荷來源，通過非穩態傳熱理論，分析研究了模具工作表面層的溫度分佈與傳遞規律，給出了型腔表面溫度分佈梯度和熱流密度公式，並給出了鍛模型腔表面的溫度負荷峰值的計算公式。The third one, we calculated the local facet temperature theoretically and experimentally when ld are operated, the former, we used the henry ' s model, however, the latter, we chose the photoluminescence and raman spectra, finally, we found that accuracy of pl is better than that of raman spectra, however, theoretical results is higher than trial results, but theoretical results accorded with pl when operating current increase. the fourth, electric derivative testing techinque at the constant current ( 500ma ) and temperarure ( 40c ). we study the reliability of ld, and analyzed the reasons, we measured more than the ingaasp high power semiconductor lasers with electric derivative technique, and analyzed the relation between the electric derivative parameters, m, b, h and reliability of devices
分別從理論上和實驗上計算分析了激光器在工作時腔面的溫度分佈，理論上採用的是henry模型，實驗上通過光致發光和拉曼光譜法測試了激光器在工作時的腔面溫度分佈；結果表明光致發光法測量的較為準確，拉曼光譜法測量的值偏大，由於我們對理論模型做了一定的近似，理論結果偏大，但理論值在大注入時和光致發光法符合的較好，由此可見光致發光法對研究腔面的溫度有更大的優越性。
分享友人