橫向標線 的英文怎麼說

中文拼音 [héngxiàngbiāoxiàn]
橫向標線 英文
horizontal marking
  • 橫 : 橫形容詞1. （蠻橫; 兇暴） harsh and unreasonable; perverse 2. （不吉利的; 意外的） unexpected
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 橫向 : broadwise; infeed; crossrange; abeam;transverse; transverse direction; cross; crosswise; lateral;...
  • 標線 : graticule; reticule
  1. Due to the short distance among the planes which fly in a group, the conventional low resolution radar can not distinguish them in both distance and azimuth ? if we use the technology of isar to resolve the difference among doppler frequency of the targets and obtain a fine resolution cross - cross image, we may separate them, but a long time of coherent processing is needed <, for the formation targets, it can be approximately divided to rigid body and nonrigid body, so for the formation targets, that can be regarded as rigid which has a relative position and an identical movement, can be approximately considered as a large target, and be compensated by translational phase with the rule of minimum entropy, but for the most those cannot accord with the approximation of rigid, being the doppler - frequency of the aim is linear changed, by the relax method with short data, increases the resolving performance of multiple target to the aim in the frequency domain, since cross - range resolution is based on the accumulative time, so it is greatly improve the resolution to formation targets by the instant cross - range image which produced by radon - wigner transformation

    低分辨isan成像及干涉技術應用研究一因此直接無法分辨編隊目標的架數，我們借鑒isar的技術，通過較長時間的相干積累，在多普勒頻域上對目標進行分辨。而對于編隊目標，可分為近似剛性的多目標和非剛性的多目標，所以對于可以近似為剛體的編隊目標相對位置固定，運動方式一致，可以近似看作一個大目標，採用最小墑準則對平動相位的進行補償，但是大多數並不滿足剛體近似的編隊目標，由於目標在相干積累時間的多普勒頻率近似呈線性變化，通過對較短數據利用relax的時頻分析方法，提高了頻率域上目標分辨的性能。由於橫向解析度取塊于橫向積累時間，所以利用radnwigner變換得到瞬時的一維橫向距離像大大提高了對編隊目標的分辨，對模擬和實測數據的大量分析結果表明此方法的有效性和可行。
  2. Because of the original design standard was low, the horizontal angur rigidity is serious lack, when the high speed train passes, the exceed limit of the horizontal swing had affected the lifting of the main trunk line, these diseases had been existed earlier but had not been gotten to resolve radical, and along with the increasing in speed of railroad train, these diseases performance will be more seriously, it ' s time for resolve

    同時提速列車對橋梁結構的動力作用增大，特別是對上承式鋼板梁。由於原設計標準低，橫向剛度嚴重不足，高速列車通過時橫向擺動嚴重超限等已嚴重影響了主要干線的提速，這些病害很早就存在但沒有得到根治，隨著列車提速，這些病害表現越來越嚴重，已到了必須整治的時候了。
  3. Liner 400 / 450mm is auxiliary in road construction activity, used in zebra crossing ( pedestrian crossing ) and entrance and exit to a highway, hand pull marker

    斑馬線熱熔劃線機是熱熔標線施工的輔助設備，它是用來塗敷斑馬線（人行橫道線）及高速公路出入口標線的，施工方向為拉力方向。
  4. The whole paper is composed vertically of the following sections : the significance, standard and model of the strategic alliance ' s stability ; key interference factors ; key corrective measures and china ' s implementation of the model

    全文縱向以「戰略聯盟穩定性涵義、標準和模型?關鍵因素?關鍵措施?中國的應用」線索組成，橫向由「穩定性?不穩定性」 、 「關鍵因素?關鍵措施」 、 「普遍理論?中國實踐」所組成。
  5. However, since the " line of sight " to the target is in motion, the missiles must develop a continuous lateral acceleration to stay on the beam

    然而，由於目標瞄準線處于運動之中，所以導彈必須具有連續的橫向加速度才能保持正確的航向。
  6. Above all, with the data acquired by tests, this thesis has analysized the lateral resistanc, longitudinal resistance and rail creep etc between ballast and sleeper before and after mass machine work, discussed the effect of mass machine on stability of continuously welded rail track, reseached the change regularity of fastening - down temperature of rail, which is resulted by mass machine work, and have settled the suitable range of work temperature which guarantees the stability of jointless railway. what ' s more, this thesis has put forward the appropriate work pattern, work temperature and work area for mass machine work in future. at the same time, this thesis has given rational suggestions about some conditions worth of attention in production of mass machine, which can in return raise the work productiveness of mass machine. at last, this thesis has considered formulating reasonable measures for operation organization and work standard, so that mass machine work can play an important role in maintenance, which can reduce work load, raise work efficiency and maintenance cost in daily maintenance

    本文通過實測的各種數據，分別對大機作業前後道床對軌枕的橫向阻力、縱向阻力、鋼軌爬行情況等進行深入分析，進一步探討大機作業對無縫線路穩定性的影響，研究大機作業引起的鎖定軌溫的變化規律，確定保證無縫線路穩定的合適作業軌溫范圍。為我國今後的大型養路機械作業提出合理的作業方式、合適的作業軌溫和作業地段，同時對大型養路機械作業中應注意的問題提出合理化建議，為大型養路機械作業提供更高的安全保障，進一步提高大機作業效率。最後，對工務段在大機作業中的配合制定完善的施工組織措施及作業標準，使大機作業在養護維修中發揮更大的作用，為工務段日常的養護維修減少工作量，提高勞動效率，降低維修成本。
  7. During this paper, definition of the measure enter - cover - probability is given, andthree - dimension detection space are transformed to level detection circles on differentheights. aiming at the most normal situation of symmetric line, cross - to line and cross - awayline taken by the carrier, probablely - enter - cover - target - distribution are analysed in relativemovement method on the premise that targets fly perpendicular to the flying direction of thecarrier. mont - cario method is used to simulate uniformly - distributed - targets situation and getthe measure, and results are used to analyse the influence of line - landscape - orientation - ratio, line - portrait - ratio, and speed - ratio on the measure. for further research, influences of height and blind space are also discussed on base ofradar level detection range, and situations of non - uniformly - distributed targets are alsoresearched

    為了分析主動探測空間動態性能，本文首先提出以「目標進入雷達覆蓋區概率」 （簡稱為「覆蓋率」 ）作為評價指標;然後將三維探測空間轉換為不同高度層對應的水平探測圓，針對載機採用雙平行航線、交叉相向航線和交叉同向航線的最一般情形，採用相對運動的方法，分析目標垂直入侵時可能進入雷達覆蓋區的目標分佈情況;再運用蒙特卡洛法進行模擬計算，分析並比較目標服從均勻分佈時航線橫比、航線縱比及速度比對性能的影響。
  8. Using spss, a statistic analysis software, the paper develop and calibrate generalized liner accident regression model for three type of roads, including two motor vehicle lanes and two non motor vehicle lanes, two lane road with road marking and two lane road without road marking

    利用spss統計分析軟體，建立並標定了橫斷面為雙車道對向車道間有標線車道與硬路肩之間有標線有標線道路、雙車道對向車道間有標線道路和雙車道對向車道間無標線道路的事故廣義線性回歸模型。
  9. In the implementation process, expert knowledge that easy to imply was concluded based on system distinguishing and maintainer ' s experience. in, the following practice in realization, we put forward parameter optimizing method using statistics theory to optimizing pid parameters, and have comparisons visually on different control policies and parameters

    在隨后的現場實現過程中，又針對pid控制參數難以整定的問題，創新性地提出了基於數理統計的離線參數尋優方法，通過對誤差平方積分等指標的統計，形象地作出了各種控制方法和參數設置下的控制效果橫向比較。
  10. Based on the analysis of the current status of highway bridge security examination of native and abroad, combing with the construction plan and operation condition of the highway bridges in hubei, this paper discusses the principle and method of highway bridge security examination, especially analyzes the relation of the traffic security with the facts such as the width of lane, transverse arrangement, security devices, environment and the geometrical line type which is formed by the longitudinal transverse technical target of bridges, and then raises the principle, content and program of the highway bridge security examination, in addition, this paper applies the bridge security examination to plan, design, construction and operation

    本文以國內外公路橋梁安全審查現狀分析為基礎，結合湖北省公路橋梁規劃建設與運營狀況，對公路橋梁安全審查的原理和方法進行了探討，重點分析了橋梁平縱橫技術指標組合構成的幾何線形、行車道寬度及橫向布置、安全設施、環境及其他相關因素等與交通安全的關系，提出了公路橋梁安全審查的原則、內容及程序，並分別對規劃、設計、施工及運營中的橋梁安全審查進行了具體應用。
  11. Single mode optical fiber laser confocal scanning microscopy is a new technology in microstructure studying. the speciality of the system is limiting the out - of - focus light reflected from out - of - focus plane in object to restrict the blur of image. therefore, the plane resolution and axial resolution of the system could be improved to sub - micron grade

    單模光纖激光共焦掃描顯微成像系統是研究微觀結構的一種新技術，其本質是抑制目標物體離焦面所反射的光線進入系統，從而抑制這些離焦光線造成像點彌散斑增大的影響，使系統的橫向與軸向解析度得到大幅度的提高，能實現亞微米級的層析。
  12. Firstly, well logging responses of fractured reservoir have been worked out by using rock core to calibrate well logging data. secondly, with the help of the seismic coherence cube, 3d volume visualization, seismic multi - attribute parameter, the curves of geophysical characteristics restructed, seismic data inversion with well logging restrict, the well curves inversion and so on, much work has been done, such as the full 3d seismic data fine structure interpretation and the studies for predicting the fractured reservoir in buried hills. a technique has been invented to predicting the fractured reservoir of metamorphic rock in buried hills with the integration of the multi - attribute and the multi - parameters

    利用巖芯標定測井資料，研究了裂縫性儲層的測井響應，進而藉助于地震相干體技術、三維可視化、地震多屬性參數、地球物理特徵曲線重構、測井約束地震反演和測井特徵曲線反演等多項技術開展了全三維地震構造精細解釋和潛山裂縫性儲層橫向預測研究，形成了多屬性、多參數綜合預測變質巖裂縫性儲層的方法。
  13. After confirming the mix property of rpc, the 28 groups of cubes ( 70. 7mm ) the 48 groups cube ( 100mm ) and the 6 groups of prism specimens were carried out to study rpc200 strength standard, discuss the relationship between the mechanical properties ( peak strain 、 young ' s modulus and poission ' s ration ) and prismatic strength, and establish the stress - strain curve for rpc200

    在確定rpc配合比后，本文進行了28組邊長70 . 7mm立方體試件、 48組邊長100mm立方體試件和6組100mm 100mm 300mm稜柱體試件的力學性能試驗，研究了rpc200的強度標準，探討rpc200的基本力學指標（峰值應變、彈性模量、橫向變形系數等）與稜柱體抗壓強度之間的關系，建立了rpc200應力應變曲線上升段方程。
分享友人
分享到 Line

分享到臉書