橫向裂紋 的英文怎麼說

中文拼音 [héngxiànglièwén]
橫向裂紋 英文
transversal crack
  • 橫 : 橫形容詞1. （蠻橫; 兇暴） harsh and unreasonable; perverse 2. （不吉利的; 意外的） unexpected
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 紋 : 名詞（花紋; 紋縷兒） lines; veins; grain
  • 橫向 : broadwise; infeed; crossrange; abeam;transverse; transverse direction; cross; crosswise; lateral;...
  1. Often lack of fusion adjacent to the girder web in the transverse groove welds led to the cracking.

    在靠近主梁腹板的橫向坡口焊縫處常常出現未熔透而導致裂紋。
  2. The results show that : 1 ) the effects of interface on waves scattering are stronger in the structure with the interface perpendicular to the direction of fracture normal than that in the structure with the interface parallel to the direction of fracture normal. 2 ) when the interface is perpendicular to the direction of fracture normal, the amplitude of reflected waves and converted s - waves are higher and there are the sub - p - and sub - s - wave. 3 ) when the elastic waves propagating in the multi - stripe model, wavesforms become complex due to multiple scattering on interfaces

    研究結果表明： 1 ）界面與裂縫排列方向平行時，界面對波的散射作用大於界面與裂縫排列方向垂直時的情況； 2 ）當界面與裂縫排列方向平行時，在界面上產生的反射波及轉換的橫波幅度較大，並且有次級縱波和橫波產生； 3 ）彈性波在多條紋結構中傳播時，在界面上產生多次散射使得波形十分復雜。
  3. Cracks, growing at weld toe, tend to form at numerous sites along the transverse width perpendicular to the applied stresses.

    焊趾處萌生的裂紋往往在垂直於作用應力方向沿著橫向寬度在多處形成。
  4. Yingxian ancient wooden pagoda is a flat - form tall building, which was formed by the superposition of monolayer temples. the height of 67. 31 meters made it encountered two unprecedented puzzles : firstly, with the height increased whopping, wind resisting and aseismatic capability become the main question of the whole structure ; secondly, because of the weight increased unconventionally, members of the lower 1 ~ 3 floors hold overloading perpendicular to grain and they brought large vertical deformation

    相對於一般殿堂結構，高度和自重的成倍增加，使木塔遇到前所未有的兩項難題:其一是因自重增加，使承受上層柱軸向荷載的梁（普拍枋和梁? ）橫紋局壓應力成倍地超過設計強度而產生嚴重的壓縮變形甚至劈裂，導致木塔整體豎向變位。
  5. 3. the two stages of primary creep and steady - state creep of 3d c / sic correspond to the gradual saturation of matrix crack and the opening of these cracks respectively. the transverse crack is the main contributor to the macroscopic creep strain of 3d c / sic, and its opening is controlled by the creep temperature

    （ 3 ） 3dc sic復合材料的減速蠕變階段和穩態蠕變階段分別對應著基體裂紋趨于飽和和逐漸張開這兩個過程；橫向基體裂紋是3dc sic復合材料宏觀蠕變應變的主要貢獻者，溫度是影響橫向裂紋張開速度的一個重要因素。
  6. This segregation behavior of sn accords with the mechanism of non - equilibrium segregation. it can be obtained through the theoretical calculations that the critical time of sn non - equilibrium segregation is 124 seconds at 750 and the critical cooling rate is 8 / s when cooling from 1320. it is suggested that controlling the cooling rate during continuous casting to avoid the critical cooling rate ( 8 / s ) and avoiding high stress near the trough temperature ( 750 ) may control the form

    通過研究殘留元素sn的偏聚機制及其對o . 15wt . % c鋼熱塑性的影響，對試驗鋼進行脆性預測:建議在該鋼的連鑄過程中彎道矯直溫度盡量避開塑性谷底溫度750 ，二冷區的冷速盡量避開臨界冷卻速率8 / s ，從而可以減少該低碳鋼連鑄坯表面裂紋和橫向裂紋，提高其成材率。
  7. Main research content including : 1 ) have studied a same diameter shaft, study how to make use of the change of natural frequency to discern the transverse crack

    本文主要的研究內容包括： 1 ）以最簡單的等直徑光軸為例，研究了利用固有頻率的變化來識別光軸上橫向裂紋的可行性。
  8. A complete parabolic shear - lag analysis containing delamination damage induced by transverse cracks was proposed and applied to predict the global properties of materials

    第三，研究了在應力較高時橫向開裂裂紋的裂尖引發的分層損傷現象。
  9. 2 ) the effects on waves conversion are stronger in rocks with dry fractures than that in rocks with water - filled fractures, and s - waves attenuate more rapidly in rocks with water - filled fractures. 3 ) the explosive point source which locates in anisotropic media can excites not only p - waves but also s - waves. 4 ) the properties of waves propagation were discussed and compared for several point sources with different source functions

    結果表明： 1 ）平行排列裂縫造成的各向異性使波前變寬； 2 ）含乾裂縫巖石對波型轉化的影響比含充水裂縫巖石的大，橫波在含充水裂紋中傳播時衰減較快； 3 ）當介質存在各向異性時，爆炸點源產生的波不僅有縱波，還有橫波； 4 ）通過改變點源函數研究不同點源所產生波以及波型的轉換。
  10. 2 ) have studied the natural vibration characteristic of the crankshaft with and without the transverse crack

    2 ）研究了曲軸在含橫向裂紋前後兩種狀態下的固有振動特性。
  11. Though this text is the research on the transverse crack in the crankshaft, but the method and the conclusion should have reference value to other scholars

    本文雖然研究的是曲軸上的橫向裂紋，但是研究所採用的方法和所得出的結論對其他的學者的研究應該是參考價值的。
  12. The result indicates : adopting certain data processing method, it is feasible to make use of the change of natural frequency to discern the transverse crack in the shaft, and the precision discerned is very high

    結果表明，採用一定的數據處理方式，利用固有頻率的變化來識別光軸上的橫向裂紋是完全可行的，並且識別的精度很高。
  13. The result shows that when contain the transverse crack in the crankshaft, and the depth of the crack is strengthened gradually, its acceleration signal responding frequency moves toward high frequency gradually

    結果表明，當曲軸中含有橫向裂紋，且裂紋逐漸加深時，其響應的加速度信號在頻域范圍內的主頻是逐漸向高頻方向移動的。
  14. The result indicates : when the transverse crack was contained in the crankshaft, the crankshaft ' s natural frequency reduced obviously, but does not change the vibration form of every type

    結果表明，曲軸在含有橫向裂紋后，其固有頻率有很明顯的降低，但是不改變各階振型的振動形式。因此，固有頻率的降低可以作為曲軸中含有橫向裂紋的標志。
  15. The crack moving problem for an infinite orthotropic functionally grated material under antiplane shear loading

    無限大橫觀各向同性功能梯度材料反平面裂紋動力學問題
  16. ( 1 ) assuming that the gfrp rods is transversely isotropic material. derive the micro - mechanical model of splitting failure in concrete reinforced with gfrp rods. analysis the stress and its distribution of the cracked concrete around the gfrp rods, finding the relations of the number of cracks and the crack radius and the stress around the interface of concrete and gfrp rods

    （ 1 ）將玻璃鋼筋視為橫觀各向同性材料，推導了gfrp筋增強混凝土劈裂失效的細觀力學模型，分析了玻璃鋼筋周圍混凝土開裂時的應力及其分佈情況，得到了裂紋數量、開裂半徑與玻璃鋼筋/混凝土界面周圍應力的定量關系。
分享友人
分享到 Line

分享到臉書