橫壓試驗 的英文怎麼說

中文拼音 [héngyāshìyàn]
橫壓試驗 英文
sidewise compression test
  • 橫 : 橫形容詞1. （蠻橫; 兇暴） harsh and unreasonable; perverse 2. （不吉利的; 意外的） unexpected
  • 壓 : 壓構詞成分。
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. The test shows that nominal transverse splitting strength of concrete cylinder is well correlated to the concrete cube strength and splitting strength of cube and cylinder, especially, above interrelation is more ideal when hold - down central angle is 90

    經試驗證明，混凝土圓柱體的橫劈名義強度與混凝土的抗壓強度、立方體及圓柱體縱劈強度有很好的相關性，尤其當壓具圓心角為90時，上述關系更為理想。
  2. The experimental result has shown that the ultimate bearing capacity and ductility of eccentrically loaded columns have a certain increase when they are strengthened with transverse cfrp. in addition, the excessive eccentrically loaded columns have a more notable effect as a result of strengthening with the combination of longitudinal and transverse cfrp. the increasing degree of strengthening columns ’ bearing capacity reduces while the volume of cfrp increases

    試驗結果表明，碳纖維布橫向加固偏壓柱時，其承載力和延性均有一定程度的提高;對于大偏心受壓柱，縱橫向聯合粘貼碳纖維布的加固效果非常明顯;隨著cfrp加固層數的增加，構件承載力的提高幅度減小。
  3. Standard test method for transverse compressive properties of hoop wound polymer matrix composite cylinders

    環箍繞制的聚合物基體合成材料圓筒的橫向抗壓縮性能的標準試驗方法
  4. Method of testing in compression perpendicular to grain of wood

    木材橫紋抗壓試驗方法
  5. According to the test platform, the monitoring control system based on computers is designed, which can output voltage signals of rolling moment and swaying force that regular wave and irregular wave press on ships

    針對試驗臺架設計了以微機為中心的監督控制系統，該系統可以實時輸出代表規則波和不規則波海浪作用於船舶的橫搖力矩和橫蕩力的電壓信號。
  6. The thesis had done the theories analysis in detail and built the relevant mathematics models aiming at the mechanics characteristic about the lodging of stalk, the elastic and plastic deform of stalk under the action of the transverse loads, the mechanics condition which causes stalk pushed, the relation between the speed of unit and the surface radius of ski, the relevant location between the thickness of the compressed stalk and action location of load, the relevant location between the mating device and plough, the coefficient of overturning soil under the thickness of the compressed stalk and so on. in addition, the computer aided analysis and simulating experiments in field were acted by choice

    本文對秸稈自倒伏力學特性；橫向載荷作用下的莖稈彈塑性變形與秸稈被推倒的力學條件；機組作業速度與滑撬曲面半徑的關系；秸稈壓實厚度與加載作用點的相對位置；配套裝置與犁體相對位置；秸稈壓實厚度下的翻垡系數等，進行了較詳細的理論分析並建立了相關數學模型。在此基礎上，本項研究還選擇性地進行了計算機輔助分析和田間模擬試驗。
  7. Performance test for prefabricated reinforced components made of autoclaved aerated concrete or lightweight aggregate concrete with open structure under transverse load

    橫向荷載下敞形結構高壓蒸養加氣混凝土或輕集料混凝土預制加筋部件的性能試驗
  8. It now possesses of not only some production equipment advanced in the national level, such as automatic hydraulic pressure spring eye machines, automatic control quenching furnaces and automatic control tempering furnaces the control accuracy attains 5 and shot blasting machines of landscape and vertical orientation, but also some sophisticated quality detection equipment, such as durometers, metallographic microscopes, stiffness and endurance test machines, etc. besides the hardware equipment, the company has a group of senior specialized technical personnel in the field of the design of the leaf spring processing, the leaf heat treatment as well as the tqc total quality control

    擁有自動液壓卷耳機自動控溫的淬火爐和回火爐爐溫控制精度達到5橫向和縱向噴丸機等國內先進的生產設備。同時還有為保證質量購置的硬度計金相顯微鏡剛度檢測及疲勞試驗機等先進的質量檢驗設備。從產品生產開始的每一個環節進行全方位的質量控制。
  9. The 3 - d finite element models of the experimental motors are established. the structural integrity of the experimental motors under internal pressure and lateral overload is analyzed. the influence of lateral overload on the structural integrity of motor is discussed

    建立了試驗發動機的三維有限元模型，分析了內壓和橫向過載聯合作用下發動機結構完整性，討論了橫向過載大小對發動機結構完整性的影響。
  10. Based upon the experimental research and nonlinear finite element calculation, and the analysis of joint failure modes, a set of formula was proposed to predict the ultimate bearing capacity of cfrst joints : 1 ) the ultimate bearing capacity of t -, y -, x - compression joints and k - compression branch joints can be predicted according to the failure model of transverse local compression

    基於試驗研究和非線性有限元數值計算，通過對矩形鋼管混凝土桁架節點各種可能破壞模式的分析，提出了矩形鋼管混凝土桁架節點承載力計算的破壞模式和相應計算公式： t 、 y 、 x型受壓節點和k型受壓支管節點承載力按橫向局部承壓破壞模式進行計算。
  11. Standard test method for compressive strength of soil - cement using portions of beams broken in flexure modified cube method

    用橫梁彎曲斷裂部分測定摻土水泥抗壓強度的標準試驗方法
  12. Observing the mechanics and effect of the new strengthening method with test and finite element method is supposed to offer a guide for technology and become valuable in theory and practice. both compression test, including four reinforced and three control specimens, and shear - compression test, including nineteen reinforced and four control specimens are being studied in this paper. the research on the curves of load - strain, load - deflection and hysteretic shows that the transverse translation of the reinforced columns is well controlled with an upgrading of both ductility and ultimate bearing capacity ( ubc )

    本文對4根鋼絲網外噴高強砂漿加固鋼筋混凝土柱和3根對比鋼筋混凝土柱進行了軸壓試驗研究，並對19根加固鋼筋混凝土柱和4根對比鋼筋混凝土柱進行了剪壓試驗研究；通過對試件荷載-應變曲線、荷載-撓度曲線和滯回曲線等的研究表明，採用該加固方法能有效的約束柱子橫向變形，並對提高鋼筋混凝土柱的極限承載力和延性有明顯的效果；同時根據理論及加固機理分析提出了適應於此加固方法的軸壓極限承載力計算公式。
  13. Based on the test results, the simplified model of transverse local compression to calculate the strength of cfrst joints under compression load was built up

    根據試驗結果，建立了適用於矩形鋼管混凝土桁架受壓節點承載力計算的矩形鋼管混凝土橫向局部承壓強度計算的簡化模型。
  14. Rubber and plastics test equipment - tensile, flexural and compression types constant rate of traverse - specification

    橡膠和塑料的試驗設備.拉伸彎曲和壓縮型橫動的速率.規范
  15. Group a, humeral fractures fixed with shape memory connector ( smc ) group b fixed with dynamic compression plate ( dcp )

    方法紐西蘭兔肱骨幹橫斷截骨，試驗組以天鵝記憶接骨器內固定，對照組以4孔加壓鋼板內固定。
  16. An experimental study on the aerodynamic characteristics of new concept car is conducted by model wind tunnel test, covering the pressure coefficient and wake vortices on longitudinal symmetry plane, as well as aerodynamic forces and moments under different yaw angles

    摘要用模型風洞對新概念車在不同橫擺角下縱對稱面上壓力系數、整車氣動力和氣動力矩的變化以及縱對稱面尾部流態分佈進行了試驗研究。
  17. First1y, in this paper, the testes about tensi1e resistance of masonry components in different period are processed and re1ated suppositions and formu1as are brought forward : the formu1a about maxima1 shear stress of top side in high or tier masonry bui1dings is deduced. it can be found easi1y that the factors affect ing the maxima1 shear stress are vertica1 resi stance coefficient 1oad magnitude wa11 geometry dimensions and its modu1us of e1asticity

    首先，進行了不同齡期下的砌體試件抗壓力學性能試驗，提出了相關的假定和公式，推導出了縱橫墻荷載差影響下的多、高層砌體結構房屋頂層的最大剪應力公式，從中可以看出影響最大剪應力的因素有豎向阻力系數、荷載大小、墻體的幾何尺寸和墻體的彈性模量等。
  18. Insulating materials - industrial, rigid moulded, laminated tubes and rods of rectangular and hexagonal cross - section based on thermosetting resins for electrical purposes - part 2 : methods of test

    絕緣材料.電工用工業剛性模製矩形和六角形橫截面的熱固性樹脂基層壓管材和棒材.第2部分:試驗方法
  19. Building roofing. fibre - cement profiled sheets. resistance to passing through of large dimensions soft body. test method

    建築物屋頂.纖維水泥壓型板.大尺寸軟波紋板的橫向強度.試驗方法
  20. Building roofing. roofing made of fibre - cement profiled sheets. resistance to passing through of large dimensions soft body. testing and classification

    建築物屋頂.纖維水泥壓型板制屋頂.大尺寸軟波紋板的橫向強度.試驗和分類
分享友人
分享到 Line

分享到臉書