橫彈性模數 的英文怎麼說

中文拼音 [héngdànxìngshǔ]
橫彈性模數 英文
modulus of traverse elasticity
  • : 橫形容詞1. (蠻橫; 兇暴) harsh and unreasonable; perverse 2. (不吉利的; 意外的) unexpected
  • : 彈名詞1. (彈子; 小球形的東西) ball; pellet 2. (內裝爆炸物, 具有破壞和殺傷能力的東西) bullet; bomb
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 數副詞(屢次) frequently; repeatedly
  • 模數 : [物理學] modulus; module; modulo; mod
  1. The main contents are as follows. ( 1 ) filter cloth and the surrounding soil mass are taken as an approximate isotropy in horizontal section, the relationship of stress and strain is studied, the anisotropy is fully considered, the constitutive model of filter cloth reinforcement fly - ash compound is obtained, it is tested with numerous indoor experiments. ( 2 ) the permeable coefficient is introduced into the constitutive relationship of soil mass with relevant seepage theory ( kozeny - carman experience formula ). the test of filter cloth depositing hi the condition of long term seepage flow is done hi the dissertation, the varying regular of permeable coefficient without pressure is presented

    本文首先對國內外的研究現狀作了回顧和總結,然後主要針對土工織物加筋粉煤灰復合體的本構關系和計算理論進行研究,主要內容有: ( 1 )將土工織物和周圍土體視為一種近似的非線觀各向同體,研究它的應力應變關系,充分考慮它的各向異,得到土工織物加筋粉煤灰復合體的本構型,然後通過大量室內試驗進行分析驗證; ( 2 )引入有關滲流理論,即柯茲尼-卡爾曼( kozeny - carman )經驗公式,將滲透系引進到土體本構關系中。
  2. The software ansys6. 0 is used to analysis the stability of the state after construction of tongwamen bridge, linear method is used in analyzing the finite element model of the bridge, the coeffient of stability of different state after construction is given. on the basis, the effect of different factors such as the arrangement of lateral brace, the sloping angle of arch ribs, the stiffness of bridge deck system, the effect of non - orientedly conservative loadings of the hanger and tie bar etc is discussed. the different coefficients of stability of changing these factors are given, so the factors that are vital to the lateral stability of x - type arches are found, and the rationality of the methods taken to enhance the lateral stability of tongwamen bridge is evaluated

    本文應用有限元分析商業軟體ansys6 . 0 ,採用線方法,通過對該橋的空間有限元型進行穩定分析,得出其成橋運營階段各種工況下的穩定安全系。在此基礎上,本文還通過有限元型分析,就拱的矢跨比、吊桿(立柱)的非保向力效應、橋面系的剛度、撐布置形式、拱肋側傾角等因素對該橋整體穩定的影響展開探討與研究。文中給出了各因素變化情況下的穩定安全系,指出了對鋼管混凝土提籃拱向穩定有顯著影響的因素及其合理變化范圍,並對銅瓦門大橋提高向穩定的措施的經濟合理進行了分析。
  3. Modify above model along with altering structural form or the constitution of the bridge, such as different standard, steel ratio, steel pipe diameter, concrete module, brace allocation, the length of concrete of the main ribs, suspending pole mode and cable local vibrations, calculate the variety of dynamic character, analyze this factors which will affect. 2

    對斜拉拱橋自振特進行參分析,分別考慮了不同規范、含鋼率、拱肋鋼管直徑、混凝土量、撐布置、拱肋段混凝土長度、吊桿形式對自振特的影響,最後考慮了斜拉索局部振動對自振特的影響。
  4. First, mathematical model of swaying system is made, which is a basis on later chapters. meanwhile, the system is simulated and designed. the effect of loaded mass, loaded suppleness, general leaking coefficient and cubage elasticity modulus on performance of system is also analyzed

    首先,作者建立了蕩控制系統的型,作為以後各章節討論的基礎,同時對系統進行擬和設計,並研究了系統負載質量、負載剛度、總漏損系和容積對系統能的影響。
  5. This paper, on the basis of the theory of aeroelasticity, analysed the galloping phenomenon which the cord was undergone the excitation of the horizontal wind. and also built up the mechanic model when galloping. this model provided the theoretical foundation for the case that the cord begins violently vibrating just after the speed of the horizontal wind reaches a certain level

    以氣動力學理論為基礎,分析了懸索在受到水平方向風激勵時的馳振現象,並建立了其發生馳振時的力學型,該型為懸索在風速度達到一定值時發生激烈的振動提供了理論依據。
  6. The thesis had done the theories analysis in detail and built the relevant mathematics models aiming at the mechanics characteristic about the lodging of stalk, the elastic and plastic deform of stalk under the action of the transverse loads, the mechanics condition which causes stalk pushed, the relation between the speed of unit and the surface radius of ski, the relevant location between the thickness of the compressed stalk and action location of load, the relevant location between the mating device and plough, the coefficient of overturning soil under the thickness of the compressed stalk and so on. in addition, the computer aided analysis and simulating experiments in field were acted by choice

    本文對秸稈自倒伏力學特向載荷作用下的莖稈變形與秸稈被推倒的力學條件;機組作業速度與滑撬曲面半徑的關系;秸稈壓實厚度與加載作用點的相對位置;配套裝置與犁體相對位置;秸稈壓實厚度下的翻垡系等,進行了較詳細的理論分析並建立了相關型。在此基礎上,本項研究還選擇地進行了計算機輔助分析和田間擬試驗。
  7. For the research requirement of the high g - load mobile missile srm, the work process of solid rocket motor under lateral overload is investigated by the use of theoretical analysis and numerical simulation methods involving the calculation of internal ballistics, the simulation of flow field and the analysis of structural integrity

    本文以高速機動防空導固體發動機研製需求為背景,採用理論分析和擬方法,從內道計算、內流場擬、結構完整分析等幾個方面對向過載作用下固體火箭發動機工作過程進行了研究。
  8. The third, the vibration theory of chord is applied to establish the model of the ramming system. the chain organ ' s polygon effect and it s meshing impact are involved in the model. the transverse vibration of the ramming system is analysed for the solution

    運用弦振動理論建立了描述供向振動的理論型,計及了鏈傳動機構固有的多邊形效應和嚙入嚙出沖擊效應,計算獲得了方程的值解,描述了該機構的向振動特
  9. In this paper, deconvolution and linearized inversion of receiver function are improved ; multi - channel deconvolution and wavelet inversion are developed for receiver function. the elastic wave motion equation is applied in the simulation and migration of receiver function in lateral inhomogeneous media, multi - grid algorithm is introduced in numerical modeling of elastic wave motion equation, and phase - delay boundary condition is also provided to absorb boundary reflection

    在此基礎上,重點研究和發展了向非均勻介質中,基於波動方程的擬與偏移成像方法,首次將多重網格演算法引入到波方程的擬和接收函的偏移成像,還發展了一種延遲邊界方法,以消除人為邊界反射的影響。
  10. Via the forward modeling in the 2 - d transversely isotropic elastic random medium, we studied the change features of the wave field characteristic quantities as changing the medias autocorrelation length and anisotropic coefficient

    我們通過在二維各向同隨機介質中的正演擬,研究當自相關長度以及介質的各向異變化時,對應的上述波場特徵量的變化特點。
  11. First1y, in this paper, the testes about tensi1e resistance of masonry components in different period are processed and re1ated suppositions and formu1as are brought forward : the formu1a about maxima1 shear stress of top side in high or tier masonry bui1dings is deduced. it can be found easi1y that the factors affect ing the maxima1 shear stress are vertica1 resi stance coefficient 1oad magnitude wa11 geometry dimensions and its modu1us of e1asticity

    首先,進行了不同齡期下的砌體試件抗壓力學能試驗,提出了相關的假定和公式,推導出了縱墻荷載差影響下的多、高層砌體結構房屋頂層的最大剪應力公式,從中可以看出影響最大剪應力的因素有豎向阻力系、荷載大小、墻體的幾何尺寸和墻體的量等。
  12. Receiver function is simulated for inhomogeneous media, as a special case for elastic wave modeling with nearly vertical incidence plane p wave as initial condition, and provide the base for inversion and migration of receiver function in inhomogeneous media

    以下覆半無限空間近垂直入射平面p波,作為擬的特例,來擬接收函,從而為向非均勻介質中接收函的反演和偏移成像問題奠定了研究基礎。
  13. The longitudinal young ' s modulus and the in - plane shear modulus decrease with the increase of the maximum misalignment and the distortion width, but the transverse young ' s modulus and main poisson ' s ratio have no obvious change

    研究了不同的最大纖維偏轉角和變形區寬度對層合板的影響,發現隨著和的增加縱向量和面內剪切量逐漸降低,量和主泊松比變化不明顯。
  14. In the paper, consolidation effects on stress and displacement distributions are n ' t taken into consideration due to supposing that foundation soil consolidation has completed after surcharging preloading. based on the inherent anisotropy and induced anisotropy of foundation soil body, transversely isotropic elastic constitutive relations are adopted to simulate half - space clastic foundation body. the relations between displacement and displacement function are proposed by extending t, ove displacement function to transversely isotropic elastic half - space

    本文假設地基土體是經過超載預壓處理過的,固結已經完成,不考慮固結對應力、位移場分佈的影響;基於地基土存在著固有各向異和誘發各向異,在前人的基礎上對e地基型進行修正,採用觀各向同擬無限半空間,將love位移函推廣到半空間,得到位移與位移函之間的關系,然後經過hankel變換得到非軸對稱問題位移、應力的一般解。
  15. After confirming the mix property of rpc, the 28 groups of cubes ( 70. 7mm ) the 48 groups cube ( 100mm ) and the 6 groups of prism specimens were carried out to study rpc200 strength standard, discuss the relationship between the mechanical properties ( peak strain 、 young ' s modulus and poission ' s ration ) and prismatic strength, and establish the stress - strain curve for rpc200

    在確定rpc配合比后,本文進行了28組邊長70 . 7mm立方體試件、 48組邊長100mm立方體試件和6組100mm 100mm 300mm稜柱體試件的力學能試驗,研究了rpc200的強度標準,探討rpc200的基本力學指標(峰值應變、量、向變形系等)與稜柱體抗壓強度之間的關系,建立了rpc200應力應變曲線上升段方程。
  16. The principle of the ultrasonic method applied to measure elastic coefficient is by measuring the velocity of ultrasonic wave propagation in the solid material to obtain the elastic module, shear modulus and poisson ratio

    摘要的超聲檢測,即藉助固體與超聲波波速間的固有關系,通過測量縱波及波在固體中的傳播速度來獲取材料的量、剪切量及泊松比。
分享友人