橫桿支架 的英文怎麼說

中文拼音 [hénggǎnzhījià]
橫桿支架 英文
over brace
  • : 橫形容詞1. (蠻橫; 兇暴) harsh and unreasonable; perverse 2. (不吉利的; 意外的) unexpected
  • : 桿名詞(桿子) pole; staff
  • : Ⅰ名詞1 (分支; 支派) branch; offshoot 2 (地支) the twelve earthly branches3 (姓氏) a surname...
  • : Ⅰ名詞1 (用來放置東西或支撐物體等的東西; 架子) frame; rack; shelf; stand 2 (毆打; 爭吵) fight;...
  • 支架 : support; stand; trestle; holder; rack; tressel; spur; sting; husk (hoose); buck; undercarriage
  1. 2 ) the structure elements should be laid out symmetrically and uniformly when designing steeve - arch structure, what ' s more, the reasonable selection of section geometric size near the arch foots of first beams is paid attention to and the arrangement difficulties of steel bar due to the big eccentric pressures 2, the analyses of anti - seismic features on transverse direction of the aqueduct l ) the method of adjusting the elements " mass can be harnessed in order to even the layout of seismic loads

    2 )設計吊式拱承結構時,各部分構件應當均勻對稱布置。另外,還應注意頭道梁拱腳附近截面的尺寸擬定,克服地震內力造成的大偏心受壓狀態給結構配筋設計增加的困難。 2 、槽向抗震性能分析1 )可利用調整構件質量的方法,使得結構的某些構件的地震荷載分佈均勻一些。
  2. Research on lateral pressure in truss rod for support of loose roof

    錨拉護散體頂板時拉向受力研究
  3. Insulators and fittings for overhead lines arming for horizontal arrangement of wires on strutted wooden poles

    空線路用絕緣子和器材.金具.木電上的水平布線用帶撐的
  4. Firstly, for the system of moulding board and support frame in construction the side pressure and screws are analyzed. the material and structure form of support frame are discussed. the design of support frame uses the method of limited state, and also it analyses the integer stability, part stability, and single stability, and then proposes the load analysis of multi - level support frame

    首先,針對轉換層梁模體系及施工,重點分析了轉換層結構現澆混凝土對模板側壓力值及模板對拉螺的計算;討論了轉換層撐體系的形式及構造,詳細論述了基於極限狀態設計的計算方法,包括縱向水平的強度驗算、立的整體穩定性、局部穩定性、單肢件穩定性等驗算,並提出了多層的施工荷載計算方法。
  5. A support for a beam in the framework of a building

    柱,建築物框梁的撐物
  6. On the base of the link ways of each member joint, the dissertation also puts forth a method to simplify the crossbeam bracing structure into spatial truss , spatial stiff frame and spatial combined structure

    撐體系根據各件結點的連接方式,多簡化為空間桁、空間剛或空間組合結構。
分享友人