橫要面 的英文怎麼說

中文拼音 [héngyāomiàn]
橫要面 英文
transverse surface
  • 橫 : 橫形容詞1. （蠻橫; 兇暴） harsh and unreasonable; perverse 2. （不吉利的; 意外的） unexpected
  • 要 : 要動詞1. （求） demand; ask2. （強迫; 威脅） force; coerceⅡ名詞（姓氏） a surname
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. Objective to study amygdaloid body, hippocampal formation and lateral ventricle in thin cross section of brain to provide the anatomy knowledge for clinic

    摘要目的觀察杏仁體、側腦室和海馬結構在腦的薄層橫斷面上的表現及變化，為影像學提供解剖學依據。
  2. Fluid noise mainly comes from out put pulsation of rate of flow, the main reason of out put pulsation of rate of flow is the instant high pressure return flow that obturation cubage produced when the big round curve pressure transition. the v trough on the port plate can reduce the fluid noise. in this paper, the author based on the acting of dam a river and condensability of liquid and used matlab language as tool to calculate the v trough on the original port plate and drew out the p - t diagrammatic curve and analyzed its shortcoming and improved the design of original v trough and got that the best size of its angle was 12. 3 and its length was 5mm and the cross section was an equilateral triangle

    流體噪聲主要來源於輸出流量脈動，造成輸出流量脈動的主要原因是閉死容積在大圓弧段壓力切換時產生的瞬時高壓迴流，在配流盤上開設v型尖槽可降低因高壓迴流而引起的流體噪聲，本文以截流作用和液體的可壓縮性為理論依據，以matlab語言為工具，對原配流盤上的v型尖槽進行了理論計算，繪制出p - t圖線，分析了它的不足，並對原有v型尖槽進行了優化設計，得出了v型尖槽的最佳幾何尺寸：配流盤平面上的v型尖槽的兩邊的夾角為12 . 3 ，槽長5mm ，槽的橫截面為等邊三角形。
  3. So we consider five financial indexes includes stock b / p, e / p, current stock size, current stock stru and financial levge by the international tradition, then descriptive statistical test method and cross section statistical test method proved that b / p and current stock size have marked effect on the securities yield besides coefficient b. in the third chapter, the article fut forward a risk factor model, estimates yield sequences of every risk factor by weight regression, and then estimates each risk factor coefficient of different stock by time sequence regression, at last we can reckon the portfolio risk o2p and yield rp which consists n stocks

    結合國際慣例，文章考慮了股票的凈值市價比（ b p ） ，市盈率倒數（ e p ） ，流通規模（ size ） ，流通比例（ stru ）和財務杠桿（ levge ）等五個財務指標，應用描述性統計檢驗和橫截面統計檢驗等多種方法，結果表明，除系數以外，凈值市價比（ b p ）和流通規模（ size ）對證券收益率部有重要的影響。在論文的第三章，提出了一個基於多因素的風險因子模型，並用加權回歸和時間序列回歸等方法估計出了不同證券的各風險因子系數（類似於單指數模型中的系數） ，據此，即可衡量出一個包括n只股票的組合的風險_ p ~ 2和收益率r _ p 。
  4. Having added super fine li2ni8o10 crystals to enamel as mill addition, the morphology of enamel interface and cross section was observed by metalloscope and sem

    摘要將超細鎳酸鋰晶體磨加在搪瓷釉中，通過金相顯微鏡和電子顯微鏡觀察搪瓷界面及橫截面的顯微形貌。
  5. Diagnosis of spina bifida requires the systematic examination of each neural arch from the cerical to the sacral region both transersely and longitudinally

    診斷脊柱裂需要在橫切面和縱向上從頸部到骶區進行系統的檢查每一個神經弓。
  6. Based on the foundation of treating poor law, the school of oxford idealism and t. h. marshall ' s citizenship theory as transverse sections, this chapter makes a lengthways review of the historical development

    它主要是以《濟貧法》 ，牛津唯心主義學派，以及t . h .馬歇爾的公民資格理論為橫切面而作的一個縱向考察。
  7. The section loss of steel bars and degradation of bond intensity were taken into consideration in this study in order to establish the finite element model of corroded reinforced concrete beam through simulating the bond slip behavior between steel bar and reinforced concrete based on nonlinear spring element

    摘要在考慮銹蝕引起的鋼筋橫截面損失和粘結強度下降的前提下，利用非線性彈簧單元模擬銹蝕鋼筋與混凝土之間的粘結滑移性能，建立了銹蝕鋼筋混凝土梁的有限元分析模型。
  8. The main research techniques include time series analysis and cross section analysis

    採用的主要實證研究方法有：時間序列分析和橫截面分析。
  9. The analytical approaches involved in the dissertation includes cross section analysis 、 time series regression 、 step by step regression and contrast analysis, the following technologies also are applied, including computerizing lower partial moments ( lpm ) with matlab, processing revenue data with excel, regression analysis with eviews

    主要運用橫截面分析、時間序列回歸、逐步回歸和對比分析方法，還用到matlab編程計算下偏矩風險值， excel處理收益數據， eviews回歸分析。
  10. The double - clad fiber ( dcf ) with truncated inner cladding has much better absorption efficiency to optical waves than dcf with circular inner cladding

    摘要缺陷型內包層雙包層光纖由於其特殊的內包層橫截面結構，對于光波的吸收效率要比理想圓型內包層雙包層光纖提高許多。
  11. The proportion that the sediment yield of the main gully accounts for the total sediment yield of the experimental watershed model is from48. 7 % to 66. 6 %, and the proportion that deposition sediment yield of main gully accounts for the total deposition sediment yield of the experimental watershed model is from64. 9 % to 99. 4 %. the developing process of topographic feature of the experimental watershed model. expanding the gully width and cutting down the gully bottom are the two chief forms of the topographic feature development

    流域模型地貌形態發育過程溝谷擴展和下切是流域模型地貌形態發育的主要形式，溝谷擴展發育主要發生在發育活躍時段，主溝所佔溝谷總面積比例在流域模型溝谷擴展發育過程中保持在60以上：主支溝下切發育在發育初期和發育活躍時段前期表現最為劇烈，其橫剖面為v字形，在發育初期和穩定時期時段呈現淺u字形和底部較為平坦的梯形，主溝的橫剖面發育明顯優先於各支溝。
  12. Tower truss structure is a kind of rise independence structure, landscape orientation level load is the determine load, moreover wind load is main load to tower truss structure in all of level loads

    塔桅結構是一種高度相對于橫截面尺寸很大，水平風荷載起主要作用的自立式結構。
  13. To the software, generation of the longitudinal functions and traverse sections has the most importance

    其中縱向函數及橫剖面的生成是最主要的部分。
  14. Abstract : by both the external combination of deck coefficient and designed water - line coefficient ? and the in - ternal combination of deck transformation and cross - section area curve transformation ? a new ship line is generated on the condition that cross - section area is the same as the basic ship and designed water line satisfies the need. this method needs not look for any transformation function to finish the change of cross - section area curve. it is a profitable development to the traditional lackenby method

    文摘:本文通過甲板面面積系數和設計水線面面積系數的外層疊代、甲板面變換和橫剖面面積曲線變換的自身內層疊代，在保持橫剖面面積曲線不變的條件下，獲得滿足設計水線面系數變化要求的新船型，而不必尋找橫剖面線的變換函數來實現設計水線面的變換，本方法是對傳統的母型船變換的一個有益補充。
  15. However, the cross-sectional shape frequently departs from the circular and at times this eccentricity may assume importance.

    然而，橫斷面形狀往往偏離圓形，而且有時這種偏離是有其重要性的。
  16. Literature search is the major method of the research. on technique, it selects typical events that can form some units by time, through which we can investigate cross - sections of reading - education conceptions, and then outspread and recount them by exemplification and generalization, in part and in whole. it tries to comment by material and avoid remarking on empty

    本論文的研究方法主要是歷史文獻研究法，在技術上，以時間為經線，切取有代表性的事件組成時間單元，對有影響的閱讀教學觀念思想作橫斷面研究，然後用例舉和概括方式展開敘述，點面結合，用材料說話，避免空洞議論。
  17. ( 5 ) intersecting point distribution between every cross - section of both hull and damaged compartment under arbitrary floatation and waterline with 2d offsets is given particularly. calculation of underwater geometric properties of both hull and compartment is treated as one process, the same to calculation of ship floatation, intact stability and damaged stability

    （ 5 ）本文給出了基於剖面曲線的積分計算模型中任意浮態下的船體及破損艙的每個橫剖面與水線的交點分佈，並將完整船舶與破損艙室在任意浮態時水線下的要素計算、完整船舶與破損船舶的浮態計算與穩性計算分別統一為一個過程。
  18. ( 2 ) respectively by elastic theory analyses and methods of structural mechanics, transverse static analytical equations for flexible pipeline rigid pipeline are established whose outcomes are applied in numerical example to compare those with that by finite element method. ( 3 ) considering interaction of filled soil, pipeline and foundation, with an eye to non - linear soil model, in view of the initial geo - stress field and the effects of interface between soil and pipeline, and by finite element method the calculational model and method are built for transverse stress in pipeline. then, by the great finite element analytical software ansys, those outcomes are applied in calculation example of positive buried pipe to educe the distribution of circumjacent soil pressure and stresses on cross section and to compare it with that calculated by conventional ways before those outcomes are applied in engineering case of positive buried pipe with flexible filled materials to confirm distribution of soil pressures after the measure for reduction and to compare it with measurements. as a result, the model set up in this paper is proved to be applicable after all above - mentioned analyses

    本文基於彈性理論和有限元原理與方法，分析了上埋式地下管道橫向力學計算方法和性狀並探討了上埋式地下管道的減荷等問題： （ 1 ）在分析現有幾種典型的管道垂直土壓力計算方法的基礎上，探討了影響垂直土壓力的主要因素以及改進的方法； （ 2 ）分別通過彈性理論分析法和結構力學的方法，建立了地下管道柔性圓環和剛性管涵的橫向靜力計算方程，並應用在算例中，把所得結果和有限元方法所得結果進行對比分析； （ 3 ）考慮填土、管道和基礎的共同作用、土體的非線性特性、初始應力場以及土體和管道的接觸面因素的影響，利用有限元的思路，建立了地下管道橫向力學有限元計算模型和方法，並且採用大型有限元分析軟體ansys ，針對上埋式管道工程算例，得出了管周土壓力以及管道橫截面應力的分佈狀況和規律，並和理論值進行對比；針對施加柔性填料的上埋式管道工程實例，得出了減荷后的土壓力分佈，並和實測值進行了對比。
  19. The round, often darker cross section of such a lump as it appears on a piece of cut lumber

    節疤這種突出物的橫截面，呈圓形，比周圍的地方要黑，常常出現在切割好的木材上
  20. The properties of nd : glass rod lasers in the heat capacity operation, including the temperature and stress distributions, are simulated and compared with the conventional pumping and cooling scheme

    摘要對釹玻璃棒狀激光器在熱容型的運行方式下的特性，包括溫度和應力分佈作了分析，並和常規抽運和冷卻方式下棒橫截面的溫度和應力分佈作了比較。
分享友人
分享到 Line

分享到臉書