正向偏壓 的英文怎麼說

中文拼音 [zhēngxiàngpiānyā]
正向偏壓 英文
forward biased
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 壓 : 壓構詞成分。
  • 正向 : [電學] forward direction正向傳導 forward conduction
  1. With sufficient forward bias, the diffusion capacitance can easily exceed the space charge region capacitance.

    當正向偏壓足夠高時，擴散電容很容易超過空間電荷壓電容。
  2. The displacement current mechanism is operative only for capacitors under reverse bias or very weak forward bias conditions which maintain a space-charge layer.

    位移電流的機理只對反向偏壓或要維持空間電荷層所需要的非常弱的正向偏壓條件下的電容器才有用。
  3. The second, at the high frequency primary coil, when switch turn on with control signal ( the spwm pulse is modulated ), in the positive or negative semi - period of low frequency modulation signal, transformer coil with same direction voltage. the magnetic flux of transformer core will increase step by step. at the end, it leads to magnetic flux saturation

    二、在高頻變壓器原邊，當開關管接收控制信號脈沖列（經調制的spwm波列）導通時，在低頻調制信號的正半周或負半周內，施加在變壓器繞組上的是同一方向的電壓，變壓器磁芯中的磁通可能將級進地逐漸增加，導致磁芯飽和，造成磁偏或單向磁化，導致低頻電信號放大失真或由於很大的磁化電流而無法正常工作。
  4. The positive-going signal subtracts from the forward bias of the lower transistor.

    正向信號則使它的正向偏壓減弱。
  5. Based on plane section assumption, this paper presents the methods of calculating the ultimate strength of the columns strengthened with cfrp, and makes a simplification of the methods. a fortran program on nonlinear method is presented to numerically analyze the characteristics of large eccentrically loaded columns strengthened by longitudinal straps of cfrp, calculating results compare well with experimental data

    本文在平截面假定的基礎上分別推導了碳纖維布縱向粘貼大偏心受壓柱的正截面承載力校核和截面加固基本計算公式，並對公式進行了相應的簡化；運用fortran語言編制相應程序對縱向粘貼碳纖維布大偏壓柱進行了數值分析，本文公式計算結果和程序計算結果均與試驗結果吻合良好。
  6. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  7. Influence of dc - rail zero - voltage notch on the output of the inverter is investigated, and an important conclusion is obtained that the direction of output current of the inverter is not effected by the voltage deviation produced by dc - rail zero - voltage notch, on the basis of which, a new simple correction approach is put forward. experiment results show that the proposed correction method is effective

    探索了直流母線零電壓凹槽對逆變器輸出特性的影響，得出了母線零電壓凹槽形成的輸出電壓偏差與逆變器輸出電流方向無關這一重要結論，在此基礎上，提出了一種簡便的校正新方法，通過試驗驗證了該校正方法的有效性。
  8. However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences

    干涉儀測向不必進行測向信號預處理而是直接或間接求取在空間上分開的傳感器上感應電勢之間的相位關系，即干涉相位差，方位角或仰角是直接由干涉相位差計算得到，或將兩基線正交的天線陣的干涉相位差轉化為驅動電壓（電流）分別加到crt陰極顯示器的垂直偏轉線圈和水平偏轉線圈，模擬顯示出來波方位，干涉儀測向為典型的相位測向方法。
  9. These topologies of inverters are composed of two bi - boost dc / dc converters, they are symmetry. so whole circuit turn into four - quadrant converters, we can control every power mosfet on or off. then we can get sine wave with direct current polarization at the left, at the same we also can get sine wave with direct current polarization phase contrast 180 compared of the left at the right

    這類逆變器由左右二個雙向boostdc / dc變換器構成，左右二邊是對稱的，所以整個電路構成了一個四象限變換器，我們可以恰當控制各功率管的開、關，使左邊的兩象限dc / dc變換器輸出一個帶直流偏置的正弦波，使右邊的兩象限dc / dc變換器輸出一個相差180度帶同樣直流偏置的正弦波形，這樣，負載zl上的電壓是左、右兩個dc / dc變換器電壓的差動輸出，正好可以消掉直流偏置，最終在負載r1上得到的就是正弦波。
  10. Difference iterative method was used to estimate numerically director configurations in the nlc - bl037 cell in this paper. the refractive indices and phase retard of nlc in electric field was presented on the basis of the calculation of liquid crystal director distributions. then we analysed the diffraction phenomenon when the linearly polarized light was controlled by diffraction grating which was based on rectangular grating and sinusoidal phase grating models and we got it ’ s math model 。 finally we designed the nlc phase grating and we did the experiment to validate the theoretic calculation

    文中利用差分迭代法計算了向列相液晶bl037盒中指向矢分佈的計算，根據指向矢的分佈情況得到了向列相液晶的雙折射率分佈和非常光通過液晶盒產生的相位延遲隨電壓變化;並在矩形光柵和正弦相位光柵的基礎上，分析了入射偏振光通過液晶電控光柵所產生的衍射情況。
  11. Based on experience coefficient method, eccentric - pressed method and modified eccentric - pressed method, a new simplified calculation formula of the eccentric - loaded coefficients was presented according to the actual load transverse distribution on the rib

    摘要基於經驗系數法、偏心壓力法以及修正的偏心壓力法等幾種偏載系數的簡化演算法，提出了按梁肋實際橫向分配系數來計算偏載系數的簡化公式。
  12. However, in july 2002, the subtropical ridge did not extend to southern china and the steering flow over the northwest pacific had a more northerly direction than usual. as a result, the tropical cyclones in the region were carried northwards and did not enter the south china sea (

    但今年同期副熱帶高壓脊並沒有西伸至華南，使西北太平洋上引導氣流的方向比正常偏北，在該區的熱帶氣旋因此偏向北移，而不向西進入南海（
  13. In this system micro - vision system is used to check the orthogonality of the joints, the radial error is adjusted by the precision motor and force sensor, and axial centering is changed by the piezoelectric ceramic

    採用視覺系統對裝配中接頭的正交性偏差進行檢測;利用精密定位和力傳感技術對裝配徑向偏差進行調整;通過壓電陶瓷驅動實現接頭軸向對中。
  14. Practical calculation method of normal cross section bearing capacity of r. c. column with deformed section subjected to biaxial eccentric compression loading

    異型截面鋼筋混凝土雙向偏心受壓構件正截面承載力的實用計算方法
分享友人
分享到 Line

分享到臉書