正弦波特性 的英文怎麼說

中文拼音 [zhēngxiánxìng]
正弦波特性 英文
sine wave characteristics
  • : 正名詞(正月) the first month of the lunar year; the first moon
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  • : Ⅰ形容詞(特殊; 超出一般) particular; special; exceptional; unusual Ⅱ副詞1 (特別) especially; v...
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  • 特性 : characteristic(s); character; performance; features; properties; behaviour; response; character...
  1. Through the test of sine wave sweep, the character of response of aeolian sand due to motivation is gained

    利用掃頻試驗,得到風積沙對激勵的響應
  2. 1 m 0. 5, the phase - shifted angle 6 is controlled in term of sine law which makes the magnitude of resonant voltage track a reference sine voltage, and the resonant voltage is rectified, filtered, inverted and then the better sine - voltage output is obtained, theoretical analysis and experimental results show that for the resistive load and inductive load, the switches of leading leg of the phase - shift - controlled circuit are always turned on at zvs, and ones of lagging leg are turned on at zvs ( < 0 ) or turned off at zcs ( ( > 0 ), moreover, all switches in the low - frequency inverter are always turned on and off at zvs, the measured circuit efficiency for rated load reaches up to 88 %

    從功率單向流動角度出發,提出了一種lcc諧振型恆頻移相單相高頻鏈逆變電路拓撲,在調制系數0 . 1 m 0 . 5情況下,控制移相角按規律變化,使諧振電壓脈沖列的幅值追蹤參考電壓信號,經過整流、濾、低頻逆變,從而獲得度較好的輸出電壓。理論分析和實驗結果證明對于阻負載或阻感負載,移相全橋具有超前橋臂零電壓開通,滯后橋臂或者零電壓開通( _ 0 )或者零電流關斷( _ 0 )的軟開關,而低頻逆變器的各個開關均實現零電壓條件下的開通與關斷。
  3. In view of this situation this article has conducted research to the design of metallurgy auxiliary biography with the frequency conversion table electrical machinery first multianalysis to the frequency changer and the frequency conversion table electrical machinery movement characteristic is carried out, the voltage waveform harmonious which the frequency changer outputs is big, attacks in a big way, and the voltage climbing rate reaches as high as 6600v / mu s which is 20 times ordinary sine alternating voltage, the rolling mill auxiliary biography table set the extremely strict request to the electrical machinery ; its movement frequency is very low, rate frequency in 8 - 20hz ; the velocity modulation scope is wide, the lowest movement frequency lowers to 1hz, and the starting number of times is quite frequently, each hour reaches as high as 600 - 800 time, the impact shoulders in a big way, the overload capacity request is high

    針對這一情況本文對冶金輔傳用變頻輥道電機的設計進行了系統研究。首先對變頻器和變頻輥道電機的運行進行詳細分析,變頻器輸出的電壓形諧大,沖擊大,電壓上升率高達6600v / s ,是普通交流電壓的20倍;軋機輔傳輥道對電機提出了十分嚴格的要求:其運行頻率很低,額定頻率在8 - 20hz ;調速范圍寬,最低運行頻率低到0 . 5hz ,起動次數相當頻繁,每小時高達600 - 800次,沖擊負荷大,過載能力要求較高。
  4. On the aspect of the dynamic character, the electrocircuit model of the motor is being realized on the pspice environment. the transient character of the pmlsm under the sinusoidal power is reached using the pspice model at circuit level, the results are compared with those using time - stepping fem

    從電機的動態能方面:建立了電機的pspice模型,在pspice環境下對電機進行驅動下瞬態的模擬,並與以電磁場分析為基礎的時步有限元電機的動態模擬分析進行了比較。
  5. Biology, etc. owing to many merits has not yet been used to measure parameters of gratings. the paper researches on the subject in view of current lack of it. the main tasks of the paper include : analyzing ellipsometric characteristics of gratings in detail with vector diffraction theory and ellipsometrics ; devising a reflective quarter wave plate at normal incidence according to some ellipsometric characteristics ; making use of normal simplex algorithm during ellipsometric inversion of gratings parameters, inversing ellipsometric parameters with gaussian noise of different standard deviations to simulate actually measured values with examples of isotropic metallic and anisotropic step gratings and testing that ellipsometry about gratings parameters is feasible with the range of certain precision ; discussing choice of incidence angle at length

    本論文的主要工作包括:結合光柵的矢量衍射理論和薄膜的橢偏理論,詳細分析了光柵的橢偏;並且根據一些橢偏設計出一款入射反射型單長1 4片;在光柵參數的橢偏反演中,引入單純形法作為反演演算法,分別以各向同形金屬光柵和各向異的階梯型光柵為例,在標準橢偏值的基礎上加入不同偏差的高斯噪聲來模擬實際的橢偏測量值進行反演,在一定精度范圍內得出滿意的光柵參數,說明光柵參數的橢偏測量是可行的;還就入射角的選取問題進行了一定的探討。
  6. First, the system operation conditions that include three input types ( square, sinuous and triangle ) with different frequencies ( l / 250hz, l / 5hz and 1hz ) are discussed. in fault detection processes, we construct 4 three - layer bp neural networks to learn the normal states of the system. the outputs of trained neural networks are as the estimate values of the sensors

    本文詳細研究了在這種情況下的故障診斷問題,針對某液壓系統,分析了系統在方輸入、輸入、鋸齒輸入下,分別在常工作頻率、極限工作頻率以及接近極限工作頻率等9種工作狀態的,以及在這9種工作狀態下,運用神經網路觀測器進行傳感器故障診斷研究。
  7. Sine sweeping constant current exciting for geophone characteristic parameter measurement and identification

    地震檢參數識別的一種新的掃頻恆流激勵方法
  8. Characteristic parameter measurement and identification of geophone by electric sine sweeping exciting

    掃頻電激勵法測量與識別地震檢參數
  9. We modulate the amplitude of the continuous single tune jamming by noise and produce the continuous noise - modulated jamming. this kind of jamming is effective to pc radar including linear frequency - modulated radar and bi - phase coded radar

    在對單頻進行噪聲調幅后形成的噪聲調幅干擾對線調頻雷達和二相編碼雷達都是有效干擾,其干擾和射頻噪聲干擾類似。
  10. The dynamic characteristics identification model of high - speed flexible rotor sys tem has been set up, the technology of steady state sine excitation and digital elliptic filter is used in order to identify the system parameter, and by constrasting the real measure to the theoretical computation, it proved that the method is accurater

    建立了高速柔轉子系統參數識別模型,並採用穩態激勵及數字橢圓濾器技術對系統參數進行識別,通過對實測和理論計算結果的比較,證明該方法有較高的精確
  11. With the conduction property of the triggered thyristor and the intellective numerical controlled frequency reduction of the triggering pulse by mpu, we can divide alternating current into several complete sinusoidal waves to supply some loads. it can be made as a controller or a pcb ware, which is suitable for the air conditioning, machine tool and various instruments that require electric power or rotate speed adjustment

    利用晶閘管的觸發導通,用單片機對觸發信號進行智能數字降頻,可在交流電中切分出部分完整的形供負載使用,可以單獨做成一臺控制儀器或者作為一個控制電路板用於需要電功率和轉速調節的空調、機床以及各類儀器設備中。
  12. After studying the traits and operating characteristic of the repmsm, a speed adjusting scheme combining the in - phase variable - frequency speed adjusting with a speed - closed loop is introduced specially

    本文研究了永磁同步電動機的點及其運行,確定了以他控式磁通軌跡法變頻調速和轉速閉環調節相結合的調速方案。
  13. Combining the methods of in - phase variable - frequency adjusting speed with brushless dc control, this system uses repmsm ( rare earth permanent magnet synchronous motor ) as executing motor. this system makes full use of characteristic of high static precision and dynamic fast response

    永磁同步電動機為執行電機,採用他控式磁通軌跡法變頻調速和無刷直流方式調速方法相結合的控制策略,充分發揮了同步電機的穩態高精度和直流電機的動態快速點。
  14. In order to research sinusoidal - and trapezoidal - current compound driven technology, the controller uses variable structure control ( vss ), by designing switch function s ( x ), which switches motor between sinusoidal - and trapezoidal - current driven technology, and thus realizes motor ' s excellent control in different range of speed. also we do software simulation using matlab

    為了研究方驅動和驅動的復合控制,控制器採用變結構控制,通過設計切換函數,使電機在驅動和方驅動兩種控制模式下切換,實現不同速度段的優良控制,並用matlab軟體對整個復合驅動系統進行了模擬實驗。
  15. Such problems as the attenuation of dc elements and sine waveform, voltage sag and frequency deviation should be taken into account in order to analyze the transient process in the power system

    要分析電網的暫態,還必須考慮衰減直流分量和衰減,以及電壓缺口和頻率偏移等問題。
  16. ( 2 ) the properties of displacement measurement based on self - mixing interference are mathematically analyzed. first, how the external phase influences upon the output frequency, intensity, power and line - width is discussed. then, the output signal ' s properties modulated by four waves, including sine wave, square wave, triangular wave and saw tooth wave, is discussed

    ( 2 )通過數值分析討論了自混合干涉位移測量系統的基本,包括外腔相位對輸出光頻、輸出強度、輸出功率、譜線寬度的影響,以及、方、三角、鋸齒調制反射體位移時輸出信號的點。
  17. I has mainly discussed the sofeware and hardware of aribrary waveform generator controlled by the microcontroller in my with the control of the high proformance microcontroller - 80c196kc, this instrument builds up the main circuit adopting single tone and dac of ad9857. in my project, i. have designed some special circuits with the advanced method of eda ( electron design automation ) based on vhdl and cpld. it can produce standard waveforms such as sine, square, triangle, and generate aribrary waveform according to the user ' s demand, at the same time, it has the ability to produce the amplitude modulation signal based on the carrier of sine and the aribrary waveform

    論文中主要對微機控制的任意形發生器的軟硬體設計進行了相應的研究,該任意形發生器以intel公司16位高能單片機80c196kc作為控制器,分別利用了ad9857的單音頻模式和dac模式組成和任意產生的電路,在硬體電路的設計中採用了先進的eda (電子設計自動化)技術,使用vhdl語言和可編程門陣列器件對一些殊的電路進行了設計。
  18. They thus have sine waves with large amplitudes and short wavelengths, both of which make them easy to see

    這樣,這些大行星就具有大振幅與短的長「」曲線,而這兩種讓它們能更容易地被觀察到。
  19. The method segments the original document into paragraphs and determines the parameters of sine wave by the characteristic of related text block. then the watermark can be embedded. after the modification, the alteration of the grayscale shows characteristics of corresponding sine wave ; next, a scheme for copyright marking is proposed, which embeds the copyright information into the text document to provide protection

    即將原始文本按段落分成多個相對獨立的塊,由與該塊相關的文本決定的參數,然後通過改變塊內字元的灰度值,嵌入對應的;其次,提出了一種用於版權標識的水印演算法,將版權信息嵌入文本,保護其所有者的權益。
  20. Due to the symmetry of sine waveform, the logic resource of cpld is saved greatly by a particular searching way of the sine table

    利用的對稱,採用一種殊的查表方法,大大節省了cpld的資源。
分享友人