殘余應力場 的英文怎麼說

中文拼音 [cányúyīnglìchǎng]
殘余應力場 英文
residual stress field
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 場 : 場Ⅰ名詞1 （平坦的空地 多用來翻曬糧食 碾軋穀物） a level open space; threshing ground 2 [方言] （...
  1. The phase structure of different cu - fe thin films were studied by using grazing incidence x - ray analysis ( gixa ). the texture and residual stress of different cu - fe thin films were measured by scan of x - ray diffraction ( xrd ) and 2 scan with different. the thicknesses of different thin films were characterized by means of small angle x - ray scattering ( saxs ) technique. by using atomic force microscope ( afm ) measured surface roughness of thin films. the component of different thin film was characterized by energy disperse spectrum ( eds ) and x - ray fluorescence ( xrf ). the magnetic properties of cu - fe thin films were measured by means of vibrating sample magnetometer ( vsm ). in addition, the giant magnetoresistance ( gmr ) effects of different films were also measured. the original resistance of the film fabricated by a direction - current magnetron sputtering system is directly affected by bias voltage

    利用掠入射x射線分析（ gixa ）技術對不同cu - fe薄膜的相結構進行了研究;利用xrd掃描及不同角度的2掃描對薄膜進行了結晶織構及殘余應力分析;運用小角x射線散射（ saxs ）技術測量了薄膜的厚度;採用原子力顯微鏡（ afm ）觀察了薄膜的表面形貌;運用能量損失譜（ eds ）及x射線熒光光譜（ xrf ）對薄膜進行了成分標定;使用振動樣品磁強計測量了不同cu - fe過飽和固溶體薄膜的磁性能;最後利用自製的磁阻性能測試設備測量了真空磁場熱處理前後不同薄膜的巨磁阻值。
  2. By simulating the excavation course of foundation pits and starting with the change of stress field, the regularities of remanent strength and static earth pressure of viscous soil mass under excavated plane are analyzed so that the influence depth due to soil mass excavation unloading may be determined

    摘要模擬基坑開挖過程，由應力場變化方面入手分析開挖面以下粘性土體殘余強度和靜止土壓力的規律性，以期確定土體開挖卸荷的影響深度。
  3. In order to study the thermal performance and residual stress of microelectronic subassembly, in this paper, a newly optical interferometry method for 3 - d displacement measurement is developed based on wavefront interference theory. in which the moire interferometry provide the in - plane displacement, but the system is different from the conventional interferometry, the system applies the double diffraction of the specimen grating, the in - plane displacement sensitivity is a factor of 2 higher than that of the conventional moire interferometer. twyman / green interferometry method for out - of - plane displacement measurement is adapted, the advantages of the optical set - up are structure novelty, and the fringe patterns of the displacement fields shown high contrast and spatial resolution

    為了詳細研究試件的熱變形特徵以及殘余應力的影響作用，本文在波前干涉理論的基礎上，設計了一新型三維光學測試系統，該系統的平面位移測試基於雲紋干涉方法，但採用與普通雲紋干涉不同的光路系統，利用試件光柵和平面反射鏡組形成的兩次衍射，使平面位移干涉條紋倍增，測量靈敏度是普通雲紋干涉的2倍，系統的離面位移場測試採用泰曼格林干涉光路。
  4. An inverse approach for constructing planar residual stresses using bem

    用邊界元反分析構造平面殘余應力場
  5. Finally, a non - linear finite element method on the basis of the classical plastic theory was introduced to analyze the distribution of residual stress field in the filament winding layers and metal liner after the autofrettage process

    採用經典塑性理論為基礎的非線性有限元方法，預測了預超壓工藝后容器復合材料纏繞層和金屬內襯內殘余應力場的分佈。
  6. A gray prediction model of autofrettage residual stress relaxation in even temperature field

    穩態溫度場下自增強殘余應力鬆弛的灰色預測
  7. In fundamental theory, adaptive optics, electrostatic actuation, flexure beam theory and squeeze film damping are researched ; in fabrication, bulk micro fabrication process and surface micro fabrication process are researched and compared, then the structure parameters and layout of a 8 x 8 micromirror array are designed using summit foundry ; in analysis, analytical and numerical method are used to perform static analysis, modal analysis, transient analysis, frequency analysis and to characterize the farfield performance of this 8x8 micromirror array. finally, in order to realize large scale micromirror array with lower snap down voltage, advices are given for further research

    在基本理論方面，通過對自適應光學，靜電力驅動，彈性梁理論和擠壓薄膜阻尼的研究，確定了微變形鏡的配置方案；在加工方面對體加工工藝， mumps工藝和summit工藝進行了研究與比較，並選用殘余應力小，表面質量好的summit工藝對8 8的微變形鏡陣列原型進行了結構設計與版圖設計；在分析方面主要對微變形鏡單元的靜態特性，模態特性，瞬態響應，頻率響應和8 8規模的微變形鏡陣列的遠場光學模型進行了研究，確定了微變形鏡的性能參數。
  8. Through the erp project, the process automation level can be improved, realized good specification process and reduce the residue inner strain of the high intensity annular. at last, it can strengthen produce capability of the high intensity casing tube in the alloy tube plant and the competitive power in the market

    通過該生產流程再造，提高了該生產線的自動化水平，實現了流水線順工序生產，使高強套管的殘余內應力在流水線上通過帶溫矯直得到了有效控制，最終大大提高了該公司合金管廠高強套管的生產能力、產品質量，增強了該公司高強套管的市場競爭能力，為以後的技改搬遷積累了寶貴經驗。
  9. The analysis of the temperature environment and the welding line ' s remaining stress of the laser welding

    激光焊接的溫度場及焊縫殘余應力分析
  10. The constitutive equation is a euler form to a reference which has initial stresses ( or residual stresses ), the constitutive equation also refers to a motion of constant velocity along a straight line

    該本構方程是參考具有初始應力場（或殘余應力場）的直線勻速運動狀態而建立的空間描寫形式。
  11. On basis of numerical simulation, the optimized weling technological has been vadidated and adjusted by plane test, results show that residual stress of both ends welded in advance can be decreased by the interspace welded later, and decreasing effect is the most obvious in the 50mm range of the interspace ; for local heating, it is 60mm from the edge of heated area to decrease residual stress

    通過平板試驗得到了分段焊與局部加熱合理工藝參數，並在此基礎上，對轉輪的焊接殘余應力場進行了調整與控制，使葉片出水邊危險區域附近產生了較大的殘余壓應力，且轉輪整體的殘余應力水平低於轉輪材料屈服極限的三分之一。
  12. Magnetic testing method of residual stress distribution by geomagnetic excitation

    地磁場激勵下殘余應力分佈的磁檢測方法
分享友人
分享到 Line

分享到臉書