殘余氮時間 的英文怎麼說

中文拼音 [cányúdànshíjiān]
殘余氮時間 英文
residual nitrogen time
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 氮 : 名詞[化學] nitrogen （7號元素, 符號n）
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv鋼強韌化機理，本文通過對不同淬火溫度，回火溫度，回火時間下的力學性能指標的對比及顯微分析，認為微合金元素的細化晶粒，馬氏體的回火分解，殘余奧氏體的轉變，第二相的沉澱析出共同決定了微合金鋼的強韌化情況，特別是由於微合金元素的存在，其細化晶粒及其碳氮化物的沉澱析出，導致鋼的良好的強韌性，並且如果工藝滿足第二相的沉澱析出強化大於回火馬氏體分解引起的軟化效應，會在硬度曲線中產生明顯的二次硬化現象。
  2. Changing the grading of sic particles not only affects the strength and pile density, but also modifies the phase compositions and microstructure of the material. with the reducing of sic particles, the strength of the material increases obviously. the nitrification scheme has the greatest influence on phase compositions and microstructure " of si3n4 ( si2on2 ) - sic, after two continuous nitrification reacting peak and short - time high - temperature treating, the best properties can be obtained ; and the residual strength of the composite is much higher after the thermal shock resistance test, which shows that the material possesses excellent thermal shock resistance

    本論文較全面地探討促進強度和顯微結構良好的si _ 3n _ 4 （ si _ 2on _ 2 ）結合相的實驗條件，實驗數據顯示：引入適量的燒結助劑能夠促進si _ 3n _ 4 （ si _ 2on _ 2 ）的生成和晶粒的長大，而過量時，其促進作用反而下降；隨著si粉加入量增加，生成的結合相明顯增多，復合材料的性能顯著提高；改變sic顆粒級配不僅影響復合材料的強度與堆積密度，而且對復合材料的物相與顯微結構也有影響，隨著顆粒逐漸細化，材料的強度有較大的提高；對復合材料的強度、物相與顯微結構影響最大的是氮化制度，經過兩個氮化高峰連續的反應和短時間的高溫后處理得到的復合材料性能最好；通過抗熱震性能實驗后復合材料的殘余強度較高，顯示出較好的抗熱震性能。
分享友人
分享到 Line

分享到臉書