殘余水分 的英文怎麼說

中文拼音 [cányúshuǐfēn]
殘余水分 英文
residual moisture
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 余 : Ⅰ動詞（剩下） remain; leave: 9減4 余 5。 nine minus four is five ; four from nine leaves five ; i...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 水分 : 1. （物體內所含的水） moisture [water] content; dew; humidity 2. （誇大的成分） exaggeration
  1. The welding technology of francis turbine runners is optimized from the view of subsection welding and local heating by numerical simulation. the result shows that welding residual tensile stress appears in the weld and its area nearby, and peak stress appears in the dangerous area of blades after practising quondam welding technology ; welding residual tensile peak stress in the dangerous area of blades can be decreased by welding both ends earlier and then welding middle section later during subsection welding, and decreasing effect on welding residual stress of the subsection welding is related to the weld length of blade outlets and welding direction of each subsection ; decreasing effect on residual stress of the local heating is direct proportional to heating time, heating temperature, heating area, and inversely proportional to cooling area, and welding residual tensile peak stress in the dangerous area is decreasing trend earlier, and then increasing trend later with heated location increased

    本文利用數值模擬手段對轉輪的焊接工藝從分段焊和局部加熱兩個方面進行了優化，結果表明:採用普通工藝焊接時，葉片焊后殘余拉應力出現在焊縫及其附近區域，並且在葉片出水邊的熔合線附近（危險區域）出現了峰值;在採用優化的分段焊時，先焊兩端后焊中間的方法可以降低葉片危險區域的焊接殘余拉應力峰值，降低效果與葉片出水邊焊段長度、焊縫各段的焊接方向有關;局部加熱法降低轉輪危險區域殘余應力的效果主要與加熱時間、加熱溫度以及加熱面積成正比，與冷卻面積成反比，並且危險區域的殘余應力隨加熱區域的增大呈先降低后升高的趨勢。
  2. The variations in trace element contents and ratios may hold up a mirror to the lake - level fluctuations and climatic changes, which, in turn, have exerted a direct and important effect on the sequence stratigraphic development. collectively, the reservoir rocks from the yanchang formation consist dominantly of the delta front subfacies subaqueous distributary channel and channel - mouth bar microfacies and delta plain subfacies subaerial distributary channel microfacies fine - grained feldspar sandstones and siltstones. the reservoir rocks have been subjected to three stages of diagenetic and porosity evolution : ( 1 ) the porosity reduction by the mechanical compaction and chemical pressure solution during the early diagenetic stage ; ( 2 ) the porosity increase by the dissolution during the a substage of the late diagenetic stage, and ( 3 ) the porosity reduction by the cementation and filling during the b substage of the late diagenetic stage

    系統的儲層特徵研究表明，該區延長組儲層成因類型主要為三角洲前緣水下分流河道、河口砂壩及三角洲平原水上分流河道微相細粒長石砂巖、粉砂巖；儲層巖石經歷了壓實，膠結，溶蝕等成巖作用，歷經早成巖機械壓實和化學壓溶孔隙縮小期、晚成巖a亞期溶蝕作用孔隙擴大期及晚成巖a亞期（ b亞期）膠結充填孔隙縮小期三個成巖-孔隙演化階段；儲層物性總體上具有較低孔滲、低孔滲的特點，孔隙類型主要為粒間溶孔、殘余粒間孔隙、粒內溶孔、晶間孔及晶間溶孔，裂縫不發育，儲集巖排驅壓力和中值壓力較高，孔隙結構類型以細小孔-微孔隙，微細喉-微喉型為主。
  3. Through measuring residual swhirling flow field in the flue duct of a real boiler, and analysing layout features of front and back platen supe - heaters in large - scale tangential firing boilers, the flue gas energy distribution regularity in horizontal flue duct of tangential firing boilers has been studied

    摘要通過對實際鍋爐煙道煙氣殘余旋轉流場的測量及大型切圓燃燒鍋爐前、后屏過熱器的布置特點分析，研究了切圓燃燒鍋爐水平煙道煙氣能量的分佈規律。
  4. The paper mainly discussed the reasons of stress from liquid ammonia pressure vessel causing crack through examing data and experimental results and analysing relevant referential documents and materials, taking 1200 ammonia vessel ' s crack and leaking in a certain fertilization company as an example : there existed remaining welding, stress in the equipment ; there existed a stress decaying surrounding, i. e., moisture 0. 2 %, and temperature > - 5 with o2 or co2 inside ; the higher the intensity of raw materials, more possible it was to have stress decaying crack

    摘要以某化肥公司1200氨冷器殼體開裂泄漏的失效分析為例，通過對檢驗數據和結果及有關文獻資料的分析研究，探究了液氨介質壓力容器產生應力腐蝕裂紋的原因：設備中存在較高的焊接殘余應力；液氨介質具備應力腐蝕環境，即含水量0 . 2 % ，且有空氣（ o2或co2 ）污染（或摻入） ，使用溫度高於零下5 ；母材強度越高，應力腐蝕裂紋產生的傾向就越大。
  5. The name sounds suspiciously like a way to class up an unsavory punch assembled from the assorted remnants of fruit juices left over at the end of a week ' s production

    名字聲音懷疑地在從在一個星期的生產的結束推遲的水果蜜汁的分類殘余裝配的一個沒有味道的穿孔機上面喜歡一個方法到班。
  6. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  7. Crushing index, grain size distribution, residual humidity and other results form the basis for accurate design recommendations ensuring customer satisfaction

    破碎指數顆粒分佈殘余水分和其它的指標都能對機械的設計給予決定性的指導，因此也是使顧客滿意的基礎。
  8. The basic physical and mechanical properties, mineral composition, micro structures, swelling potential, consolidated drained triaxial shear strength, parameters of constitutive model and residual strength of the soft clayey rocks were tested in laboratory with a large number of natural samples. the changing trend of the strength about these rocks is obtained by modeling the condition of softening due to immersion. from the principles of modern soil mechanics, the structural and swelling characteristics of soft clayey rocks were analyzed systematically

    本文通過現場調查，查明風化泥質軟巖的宏觀結構特徵，利用現代試驗測試手段，取原狀土系統進行特殊土室內土工試驗，測定土的基本物理力學特性、礦物成分及微觀結構、膨脹性、三軸排水剪強度及本構模型參數、軟化殘余強度，並模擬土體在長期浸水軟化后的強度變化趨勢，測試該類土的浸水軟化殘余強度。
  9. Aiming at the coal under the building, rail and water, difficultly - mined coal and the side of strip mine, hardly mined, but it is utilization for the ucg study on field test of air coal gas, water coal gas, rich oxygen coal on the side of strip the side of strip mine mine of fu xin, using the ucg for the mineral well, getting the method for building stove of ucg, obtain different coal gas group and heat value for the different gasification craft high volatile, multiple thin coal seams on the side of strip mine are suitable to underground coal gasification to produce middle low heat value gas

    摘要針對「三下」煤層，難採煤層，復雜煤層以及露天邊坡剩餘的煤炭資源，並工開采不經濟或難以開采，可利用煤炭地下氣化將這些殘余資源得以回收利用，試驗利用礦井式煤炭地下氣化方式，對阜新礦露天邊坡進行了空氣煤氣、水煤氣、富氧煤氣的工業性試驗研究，通過煤炭地下氣化工業性試驗，得出在露天邊坡礦井式氣化建爐方式，不同氣化工藝的煤氣組分，熱值。
  10. While the chips are attached to near center or near a edge of subatrate, the mean, deviation and maximum are at the almost same level ; when the chip is attached near a corner, the deviation and the maximum is far larger than those of the above two positions ; during thermal treatment followed, the residual stress demonstrates a regular cycle trend when the chips are attached near center or edge of the substrate and fluctuates in a wide range when the chip is attached near a corner

    當晶元粘貼在基板中心和靠近基板邊緣的位置時粘合劑固化后殘余應力的平均值、最大值和數值的分散性皆處于相接近的水平，而當粘貼在基板靠近一角的位置時應力分佈狀況則有很大不同：應力的分散性增大，應力最大值也遠大於粘貼于另外兩個位置時的值。
  11. With the established dynamic pore pressure model, the calculated results of total stress method and effective stress method are compared. consolidation settlement induced by dispersion of residual pore pressure is calculated, and the effect of pore pressure on pavement settlement is discussed

    採用本文建立的軟土地基動孔壓模型，對比分析了不排水有效應力法和總應力法計算結果，計算了殘余孔隙水壓力消散所產生的固結沉降，探討了孔壓對道路變形的影響。
  12. Based on a regress analysis of the results of 74 columns models from eight different tests, an empirical formula for calculating the residual shear strength of reinforced concrete bridge columns is derived. and compare the formula to them proposed by the current codes

    通過對得自8次不同試驗的74根鋼筋混凝土墩柱模型試驗結果的回歸分析，最終建議了一種考慮軸壓比影響和延性水平影響的強震動下，鋼筋混凝土橋墩殘余剪切強度的實用計算公式，並與國內外現行規范公式進行對比。
  13. Semiconductor devices - mechanical and climatic test methods - part 7 : internal moisture content measurement and the analysis of other residual gases

    半導體器件.機械和氣候試驗方法.第7部分:其他殘余氣體的分析和內部水分含量的測量
  14. On basis of numerical simulation, the optimized weling technological has been vadidated and adjusted by plane test, results show that residual stress of both ends welded in advance can be decreased by the interspace welded later, and decreasing effect is the most obvious in the 50mm range of the interspace ; for local heating, it is 60mm from the edge of heated area to decrease residual stress

    通過平板試驗得到了分段焊與局部加熱合理工藝參數，並在此基礎上，對轉輪的焊接殘余應力場進行了調整與控制，使葉片出水邊危險區域附近產生了較大的殘余壓應力，且轉輪整體的殘余應力水平低於轉輪材料屈服極限的三分之一。
分享友人
分享到 Line

分享到臉書