殘值理論 的英文怎麼說

中文拼音 [cánzhílǐlún]
殘值理論 英文
residual theory
  • 殘 : Ⅰ形容詞1 （不完整; 殘缺） incomplete; deficient 2 （剩餘的; 將盡的） remnant; remaining 3 （兇惡...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 理論 : theory
  1. The elastic foundation model is considered as two - parameter elastic foundation model and its effect to moderate - thick plates are taken into account by a set of governing differential equations. united with hu hai - chang ’ s function, least squares collocation weighted residual method which uses b - spline function as trial function is put forward for solving the bending problems. compare with the results of finite element method of lines, spline finite strip method, accurate solution of series etc. it is proved that the method in this article has adequate accuracy and practical feasibility

    本文採用瑞斯納中厚板理論求解彈性地基板，建立雙參數地基與中厚板相互作用的控制微分方程，結合胡海昌的解耦函數，運用雙五次b樣條函數作為試函數的離散型最小二乘加權殘值法分析了雙參數地基上的中厚板的彎曲問題，並將結果與有限元線法、有限條法、級數精確解等進行比較，證明本文方法具有足夠的精確性與實際的可行性。
  2. In this paper, we first analyze the input and output as well as cost - benefit rate of chinese livestock industry by the example of hog, beef, mutton and dairy cow. then, we choose the samples from different regions in different time, use the stochastic production frontier suggested by battese and coelli ( 1992 ), which is aimed at the panel data ( balanced or unbalanced ), and make the econometric analysis for the growth of hog, beef, mutton, and dairy cow. different from the former research for livestock industry, the efficiency measurement theory is introdiced into the growth model and the tfp is dissolved into technical advancement, technological efficiency and residual, the translog production function is used to make the estimation more precised

    本文首先以生豬，肉牛、肉羊和奶牛為例對近年來我國畜牧業的投入產出和成本收益狀況進行了分析，然後採用battese和coelli在1992年提出的針對混合數據（ paneldata ）的隨機邊界生產函數形式，在不同地區選取一定的樣本，利用樣本省的時間序列與截面混合數據，對生豬，肉牛，肉羊和奶牛的增長因素進行了分析，與以往對于畜牧業增長研究不同的是，將效率測算理論引入生產增長模型，把全要素生產率分解為技術進步、技術效率和殘差項，並採取了更加符合實際的超越對數函數形式，使傳統上使用的索洛余值法得到改進，更深層次的剖析了我國畜牧業目前的增長方式。
  3. Specifically, according to the w - w five parameters failure theory, the fracture criterion of crack is established, and the state of crack ( open or close ) is judged by the values of the crack strain. combining the two points, the predict - model about the failure of concrete material is established. this predict - model can predict 16 failure forms, and basing the different failure form predicted after crack, the stress - strain relationship matrix of concrete material is adjusted

    具體來講，根據w - w的五參數混凝土破壞理論，建立混凝土的開裂準則，根據開裂應變值來判斷裂縫是張開還是閉合，從而在兩者基礎上建立了裂縫的開裂預測模式，總共有16種開裂模式；裂后根據具體的開裂模式及殘余抗剪能力來調整混凝土的本構關系矩陣，即用等效剛度代替原有剛度，考慮到垂直於裂縫方向的剛度為零，這樣會使裂后的總剛出現病態，為此文中通過引用鬆弛系數來對出現裂縫的單元進行預處理，一方面可解決因過大的舍入誤差導致計算結果的不可信問題，另一方面就是可加速收斂。
  4. Aiming at the defects of the imc - 70 model stubble - plastic film residue collector that the draft is rather great and the plastic residue or stubble are sometimes left out in the operation process, formulas for the principal parameters of the knives have been driven out based on the analysis of the distribution manner in the field of the stubble and plastic film residue, the variation range and the variation tendency of the principal parameters for the reduction of the draft have been found on a trial basis in the corn field through theoretical analysis and experimental study and a mathematical model for the draft applied on the knives has been established in accordance with the movement and distortion of the soil under the action of the knives

    本文針對1mc ? 70型地膜回收起茬機起膜、起茬鏟刀在作業中阻力大，殘膜、根茬有漏起的現象，通過對作物收獲后殘膜、根茬在田間分佈情況的分析，推導出鏟刀滿足生產要求主要參數的求取方法和公式，並經理論分析和試驗研究，確定了鏟刀對玉米茬地進行起膜、起茬時主要參數的取值范圍和減小牽引阻力各參數的取值規律。以鏟刀作用下土壤的運動變形為基礎，建立了鏟刀牽引阻力模型。
  5. First, the research background of this dissertation is set forth, and summarized with the overview of the history and the current development of residual stress research, based on reading a lot of literatures, and summarized with the general situations of aircraft aluminum alloys quenching and numerical simulation, those are pointed out objective, significance, methods of this research

    本文主要採用數值模擬、理論分析、實驗驗證等方法，對航空構件淬火殘余應力的產生及影響進行了研究。主要工作集中在以下幾個方面： 1 、闡述了本學位論文的選題背景，在查閱國內外研究文獻的基礎上，歸納總結了航空鋁合金淬火殘余應力的研究概況，給出了論文的主要研究目標、內容及方法。
  6. Based on method of moment and method of weighted residuals, a new analysis method for the stochastic structures is proposed and described as a unified form in this paper

    本文基於加權殘值法和矩法的特點，提出了隨機結構分析的一種新方法，並從理論上給出了其統一的表述。
  7. In the course of assessing environmental pollution, a sensibility assessing method is introduced and limited dualism of fuzzy maths is applied to decide the proportion of respective sources, then educes a damage assessment formula. as to profits and gain losses, the model of remanent data discriminating of grey theory is applied to measure the anticipated interests. furthermore, a deep research and careful analysis are made about the legal matters of compensation for oil damage, and a general juristical criterion of whether compensation for respective losses should be made is defined

    筆者引入環境敏感度評價方法對環境損害進行評估，採用模糊數學的有限二元法理論確定各項資源權值，進而確定受污染區域環境綜合敏感度值；吸收華盛頓州損害評估思想，建立大連灣溢油對環境的損害評估公式；應用灰色理論中數據殘差辯識模型計算各受害人的期得利益；分析圍繞油污損害賠償的法律問題和界定各項損失應否予以賠償的一般標準。
  8. Theory analysis in this paper pointed out that the flexural - torsional buckling is the usual form of t - section steel. so the slenderness ratio of flexural - torsional buckling should be used when people give out the b / t ratio by the " equal stability " conception. initial stress, defects and tangent modulus are include in the deduce of the paper to get a rational b / t ratio

    通過理論分析指出軸心受力剖分t型鋼整體失穩以彎扭屈曲為主，所以在運用「等穩定」方法確定腹板寬厚比限值時應與桿件的扭轉長細比「掛鉤」 ，並以此為出發點考慮殘余應力、初始缺陷，應用切線模量推導出了較為合理的腹板寬厚比限值公式。
  9. For the first time, take tarim basin as an example to establish theoretical, industrial threshold value of organic enrichment of carbonate source rocks. calculate gas quantity of generation, adsorption, dissolving in oil, dissolving in water, diffusion of unit area carbonate rocks at different geologic conditions. and then according to the material balance principle, figure out the corresponding organic carbon content when gas being started expelling from source rocks with separate phase

    分別計算了不同地質條件下單位面積碳酸鹽巖的生氣量及源巖和圍巖各種形式的殘留和耗散氣量（吸附氣量、油溶氣量、水溶氣量、擴散氣量） ，進而根據物質平衡原理計算出源巖開始以游離相有效排氣時所對應的有機碳含量，並將它作為該地質條件下氣源巖的有機質豐度理論下限值。
  10. Calculate gas quantity of generation, adsorption, dissolving in oil, dissolving in water, diffusion of unit area carbonate rocks at different geologic conditions. and then according to the material balance principle, figure out the corresponding organic carbon content when gas being started expelling from source rocks with separate phase. regard it as the theoretical threshold value ( tocmin ) of gas source rocks at that same geologic condition

    分別計算了不同地質條件下單位面積碳酸鹽巖的生氣量及源巖和圍巖各種形式的殘留和耗散氣量（吸附氣量、油溶氣量、水溶氣量、擴散氣量） ，進而根據物質平衡原理計算出氣源巖開始以游離相有效排氣時所對應的有機碳含量，並將它作為該地質條件下氣源巖的有機質豐度理論下限值。
  11. The point interpolation method ( pim ) is a kind of new meshless method based on the theory of interpolation, its shape function is constructed by interpolation method. in this article, the thinking of point interpolation function is used in the method of weighted residuals ( wrm ), so the pifwrm is presented, and the numerical examples show its validity

    其次，由於點插值法是基於插值型形函數構造理論的一種無單元法，我們研究了這種構造函數方法的數學基礎，並提出了點插值插值函數加權殘值法，進行了算例驗證。
  12. After the analysis results are checked against the experimental results and, it is founded that a satisfactory agreement is obtained in elastic phase and a discontented agreement is gained in plastic phase since the influence of residual stress, degradation of cross - sectional stiffness and the spread of plastic zone length cannot be taken into account in plastic hinges theory

    程序計算結果與試驗值相比，彈性階段吻合得較好，塑性階段由於塑性鉸法無法考慮殘余應力、剛度硬化以及塑性區長度的發武漢理工大學博士學位論文展等因素，因此與試驗值相比誤差偏大。
分享友人
分享到 Line

分享到臉書