氣油流度比 的英文怎麼說

中文拼音 [qìyóuliúdùbǐ]
氣油流度比 英文
gas-to-oil mobility ratio
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  1. Many researches have been done with the simulation model. it was found that some structure parameters such as the diameter of the driving piston, the diameter of the buffer piston, the stiffness of the valve spring, the compress ratio of the buffer piston, and the flux area of the solenoid valve etc. have great effect on the performance of the haecvvs. for certain performance demand of the variable vale system, there is a most suitable combination for the structure parameters

    通過對電控可變氣門系統的主要結構參數，如動力活塞直徑、緩沖活塞直徑、氣門彈簧剛度、緩沖活塞實際壓縮比、電磁閥通流面積等參中壓共軌電控柴油機可變氣門系統的研究數對電控可變氣門系統啟、閉特性的影響規律的研究發現，動力活塞直徑、氣門彈簧剛度、電磁閥通流面積對電控可變氣門系統啟、閉性能起著決定性的作用，對於一定的氣門啟閉規律要求，這些結構參數存在一組最佳值。
  2. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  3. The new device consists of paint - drying box, heat carrier boiler, heating pipe, expansion tank, gas separator and oil tank, etc. the data of two applied examples shows that heat carrier paint drying method is able to make painting - drying cost drop by 88 %, compared with the conventional one, that it has some advantages such as uniform temperature field, good appearance and lower costs, compared with conventional hot air convection mode

    該裝置主要由熱載體烤漆爐、輻射加熱管，熱載體爐、膨脹器、油氣分離器和儲油槽等組成。應用實例的測試數據表明，與傳統的遠紅外電加熱鋼瓶烤漆方式相比較，鋼瓶熱載體烤漆節能和降低能耗費用十分顯著，能耗費用降幅達到88 。與熱風爐對流烤漆方式相比較，熱載體烤漆方法不僅節能，而且烤漆爐溫度場均勻穩定，同時烤漆的外觀質量也得到了明顯提高。
  4. In this paper combustion performances of the single - head annular combustor with different swirler cups are investigated by experiment and numerical simulation. under different fuel - air ratios, profiles of exit temperature 、 combustion efficiency 、 lean blowout limit and pollutant emission are measured

    在相同的雙級旋流器情況下，試驗分析不同油氣比對單頭部環形燃燒室的出口溫度分佈、燃燒效率、貧油熄火油氣比以及污染物（ co _ 2 、 co和nox ）排放等燃燒性能的影響規律。
  5. Effects of different fuel - air ratios and different geometric parameters of dual - stage swirler ( such as inner diameters of the primary swirl and secondary swirl passages, outer diameters of the secondary swirl passages, vane angle of the primary and secondary swirler, the distance of the flare exit from throat etc ) on combustion performances are studied experimentally. the experimental results show that radial profiles of the outlet gas temperature 、 combustion efficiency 、 emissions of co2 、 co and nox and lean blowout are affected with different degrees by the different geometric parameters of dual - stage swirler and the arrangement of primary holes

    在不同油氣比下，不同的雙級旋流器幾何參數（例如:一級與二級旋流器出口內徑d 、葉片安裝角、二級旋流器出口外徑d 、二級旋流器的喉道到出口截面的距離l和喉道前後的圓弧半徑r以及主燃孔孔布局等）對單頭部環形燃燒室的出口溫度分佈、燃燒效率、貧油熄火油氣比以及污染物（ co _ 2 、 co和nox ）排放等燃燒性能的影響規律進行了研究。
  6. The convective term is solved by ausm + ( a sequel to ausm which means " the advection upstream splitting method " ). the 7 species 8 steps model and 7 species 7 steps model of hydrogen / air is used in the hydrogen reacting flowfield, the 9 species 5 steps model of methane, the 10 species 10 steps model of ethane and the 10 species 13 steps model of kerosene are used in the hydrocarbon reacting flowfield, the results of the distributions of velocity, mach number, pressure, static temperature, total temperature, species mass fraction and the combustion efficiency are gained, and the numerical results of the pressure of hydrogen and methane are compared with those of the experiment

    計算中通量項採用ausm +通量分裂格式，氫反應流場採用氫/空氣的七組元八方程模型和七組元七方程模型，碳氫反應流場採用甲烷的九組元五方程模型、乙烯的十組元十方程模型和煤油的十組元十三方程模型，得出了超燃發動機燃燒室流場的速度、馬赫數、壓力、靜溫、總溫和組元質量分數分佈及燃燒效率等性能參數，其中氫和甲烷的計算壓力分佈與實驗結果進行了比較。
  7. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  8. As compared with the conventional straight well, the horizontal well can greatly increase the contact area between well and reservoir, change the filtrational mode in the vicinity of wellbore in the reservoir and reduce filtrational resistance, thus obtaining higher oil and gas production by a relatively low producing pressure difference

    摘要同常規的垂直井相對比，採用水平井開采能夠大幅度增加油氣井與油氣藏的接觸面積，改變油氣藏中井筒附近區域的滲流方式，降低滲流阻力，進而可以利用較低的生產壓差來實現更高的油氣產量。
  9. Based on the careful strata correlation and division of chang - 6 formation of panguiang in jing ' an oil field, the article discusses the structure characteristics, the sand body shape and distribution and the microfacies feature of chang - 6 oil set, analyses the physical properties and heterogeneities of the reservoir which is classified three types as i, ii and iii type, summarizes the relation between microfacies, sandbody distribution and physical properties, evaluates the reservoir from the flow unit aspect, reveals the affecting feature of oil concentration

    本文在對靖安油田盤古梁油藏長6油層組進行小層精細劃分和對比的基礎上，詳細研究了盤古梁長6油層組的構造，砂體形態、展布方向及沉積微相特徵，對儲層的非均質性作了定性定量的分析並且對其進行分類，總結了沉積微相和砂體展布、物性之間的關系，從流動單元的角度對砂體進行了評價，揭示和確定油氣富集規律的影響因素。
  10. According to the new criterion for classification of oil and gas resources / reserves ( gb / t19492 - 2004 ) issued in 2004, this paper reviews the studied methods at home and abroad for the purpose of establishment of new series of recoverable reserves such as technically recoverable reserves, economic recoverable reserves, sub - economic recoverable reserves and remaining economic recoverable reserves of oil - gas fields

    摘要按照2004年頒布的新的《石油天然氣資源儲量分類》 （ gb - t19492 - 2004 ）標準，為了建立和形成油氣田技術可采儲量、經濟可采儲量、次經濟可采儲量和剩餘經濟可采儲量等新的可采儲量系列，在總結國內外研究方法的基礎上，結合油田的地質開發特點，根據我國現行的財稅制度，以現金流法為主要方法，進一步研究提出了經濟極限法、井網密度法、邊際成本法、類比法等經濟可采儲量計算方法。
  11. The bump height and secondary wall - impingement distance were discovered to play an important role in producing a secondary space jet, reducing the quantity of fuel stuck on the wall and forming lean mixture, and their suitable values being 1. 0 - 1. 5mm and 0 - 2. 0mm respectively

    發現bump高度及二次撞壁距離對撞壁油束形成二次空間射流、減少壁面燃油堆積以及形成稀混合氣有重要作用，且發現bump的高度和二次撞壁距離分別為1 . 0 1 . 5mm和0 2 . 0mm比較合適。
  12. Planar laser induced fluorescence ( plif ) was used to study the spray / wall impinging in constant volume vessel. the experimental result show that when fuel spray impinging on the plane wall, wall jet was formed while fuel impinging on a plane wall with a bump, when the wall jet meet the bump, a secondary jet can be formed. some parameters affecting the secondary spray were studied, including bump height, the secondary impinging distance, impinging distance and injector parameters

    對傳統燃燒室和bump燃燒室內燃油空氣混合過程進行了對比研究，發現燃油撞壁以後在傳統燃燒室壁面形成壁面射流，這一層燃油濃度很高，很難與空氣混合，而在bump燃燒室內，壁面射流遇到bump后，會在空間形成二次射流，二次射流進一步能快速與空氣充分混合。
分享友人
分享到 Line

分享到臉書