氣泡流量計 的英文怎麼說

中文拼音 [qìpāoliúliángjì]
氣泡流量計 英文
bubble flowmeter
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 泡 : 泡Ⅰ名詞1 （氣泡） bubble 2 （像泡一樣的東西） sth shaped like a bubble Ⅱ動詞1 （較長時間地放在液...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 氣泡 : air bubble; bubble; bubble cell; pin hole
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  1. Ultrasonic has being attracted much attention gradually in fuel atomization because of some specialities of cavitation and infection on liquid flow. in the course of atomization of pitchy oil, especially, does it show greatly its advantage, but its material atomizational mechanism need research ulteriorly. the primary content of this thesis is about adding cantilever reed to effervescent atomizer so as to combine ultrasonic and effervescent. this thesis has discussed ultrasonic some mechanism, ultrasonic dynamical procreator, effervescent and liquid mucosity infection on atomization, at the some time we make some experiments and discuss atomization rule following some machinery parameter and run parameter so as to find some rule about ultrasonic atomization and to rich the research of ultrasonic atomization mechanism. all that will be beneficial to the design about ultrasonic atomization atomizer

    超聲波由於其空化機理及對液體的流變性影響等特性，在燃油霧化燃燒中逐步引起人們的重視，尤其在重渣油等高粘度液體的霧化過程中逐步顯示出其優越性，但其具體的霧化機理還需要做進一步的研究在氣泡霧化噴嘴基礎加入懸臂式簧片哨，將超聲波與氣泡霧化相結合是本文討論的主要內容本文從研究超聲波的一些機理入手，討論了超聲動力發生器氣泡霧化以及液體粘度對霧化質量的影響，並通過具體的實驗，根據實驗數據來討論霧化質量隨各種結構參數運行參數的變化規律，以便找到超聲霧化的一些規律，豐富對超聲霧化機理的研究，對超聲霧化噴嘴的設計具有一定的指導意義。
  2. The meter handles gases, liquids, foams, and slurries.

    這流量計可以處理氣體，液體，泡沫狀物和稀漿等。
  3. Moreover, the resulted prediction model of foam size of the closed cell aluminum foam was verified by comparison to the experimental results from the foaming process at different foaming conditions, and the predicted bubble diameter is in good agreement with the experimental ones, the relative error distributes between - 5. 04 % and 6. 32 %

    當入射空氣的壓強、氣流量，液面高度，出氣孔直徑增大時，氣泡直徑隨之增大；當出氣孔數量，液體粘度增大時，氣泡直徑減小，表面張力對氣泡直徑的影響可以忽略不計；靜態條件下液體表面氣泡直徑的預測值和實驗測量值符合得較好，相對誤差分佈在- 5 . 04 % ~ 6 . 32 %之間。
  4. Result of numerical simulation shows that the grads of continuous phase " s velocities decreases with the presence of microbubble of which the diameter is 100 / / w, the profiles of air volume fraction in the boundary layers is similar to triangle or echelon, affected by interaction among the particle, there is a saturated air fraction, within the scope of saturated air fraction, increasing the air injection ratio can accrete the friction reduction ratio, under the condition of same air injection ratio, the free - steam velocity is larger, the effect of friction reduction is worse

    計算結果表明，直徑為100 m的微氣泡能減小近壁面連續相的速度梯度；微氣泡在邊界層中的濃度分佈近似為三角形或梯形分佈；受粒子間相互作用的影響，存在一飽和濃度；減阻率隨噴氣量的增大而增大，直至飽和噴氣量，此後，增大噴氣量，壁面摩擦阻力變化不大；相同噴氣量下，來流速度越大，減阻率越低。
  5. Using digital image processing technique to process the solid - gas - water three - phase flow image and separate dispersed phase from the three - phase flow image, author calculated the bubble number, particle number in instantaneous image, area of bubble image and other parameters, and analyzed the effect of image enhancement, image segmentation, image analysis and other problems existed in bubble image processing

    應用數字圖像處理方法對水氣固三相流圖像進行處理，將其中的分散相分別提取出來，計算得出瞬時圖像范圍內的氣泡個數、粒子個數，氣相所佔流動截面比等參數；分析了圖像增強、圖像分割、圖像分析等方法在多相流圖像測量上的作用以及氣泡圖像處理中存在的問題。
  6. Based on simulation results which were satisfied, the effect of bubble diameter on entrainment concentration forcast result was analyzed. the bubble moving rule was found which includs the bubble is escaping upwards along the way, the diameter of the bubble is bigger, the velocity upwards is larger and the bladder remaining near channel bottom is smaller. to make best use of the function of the aerator, the demands of enough air entrainment quantity and suitable air bubble diameter are needed to be satisfied

    根據計算結果，對水氣兩相流中氣泡尺寸對摻氣濃度預測結果的影響進行了分析，得到沿程氣泡不斷上逸，氣泡粒徑越大，其上逸速度越大，則留在渠底附近的氣泡越少的氣泡運動規律，提出了摻氣槽的設計，除滿足摻氣量外還應滿足摻氣粒徑要求的工程建議。
  7. Analysis of tobacco and tobacco products ; determination of flow rates of gas using the soap film bubble flowmeter

    煙草和煙草製品的分析.用皂膜泡流量計測量煙氣的流量
  8. A set of experimental system was designed to in measure water - gas two - phase flow and influence factors in bubble image analysis was discussed

    作者與他人合作設計構建了一套水氣兩相流圖像測量實驗系統，詳細分析了氣泡圖像實驗的各種影響因素，為后續研究提供了前提條件。
分享友人
分享到 Line

分享到臉書