氣流分流器 的英文怎麼說

中文拼音 [qìliúfēnliúqì]
氣流分流器 英文
stream splitter
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 氣流 : 1 [氣象學] air current; airflow; wind current; airstream2 [語言學] breath氣流紡紗 open end spinni...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Boiling drier, the other name is fluid bed, is composed of air filter, heater, main frame of boiling bed, star like feeder, cyclone separator, cloth bag dust catcher, high pressure centrifugal blower, and control board

    沸騰乾燥器，又稱流化床，經過30多年的使用、改進，目前在制藥、化工、食品、糧食加工等方面，越來越體現它的重要作用。它是由空氣過濾器、沸騰床主機、旋風分離器、布袋除塵器、高壓離心通風機、操作臺組成。
  3. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下，不同流速對熱管空氣預熱器壁面溫度的影響；然後對影響整個流場分佈的各種因素：包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬；最後提出在分流煙道轉彎處加裝導流板，並模擬加裝導流板后的流場分佈，得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈，以論證加裝導流板能達到流場均勻化的作用。
  4. The metal nanoparticles that form in hot critical layer are drawn from reaction area and arrives designated installation via the centrifugal selection grades ware under the transport of inertia gas current, then metal nanoparticles are collect via filter completion

    氣流將在熱臨界層中形四川大學博士學位論文成的金屬懸浮顆粒從反應區中提取出來，經過離心分級器的篩選，在惰性氣流的輸運下抵達指定裝置，通過濾器完成對金屬納米顆粒的收集。
  5. However, in our nation, the research on gan - based microelectronic devices is in the early stage, and a great deal of vestigation is still needed to perform on separative processes of gan devices. due to the lack of algan / gan heterojunction materials in the country, a few researches on algan / gan were made, and the investigation on schottky rectifiers is much less

    在國內， gan基微電子器件的研究剛開始起步，制備gan分立器件的工藝尚處于探索研究階段，特別是受algan gan二維電子氣材料來源的限制，國內algan gan基的場效應晶體管的研究開展得較少，關于肖特基整流二極體的研究更少。
  6. Box type liquid - gas distributor is the patent product of our company, it not only realized the full connect of liquid but also avoid leak of it, the distributor can add the liquid distribute hole, it has small central line horizontal windage

    該氣液分佈器不但實現了液體流動全連通，而且避免了液體泄露，液體分佈孔數量可以增加，分佈孔中心線水平度偏差小，具有更加優良的氣液分佈效果。
  7. The influences of structure variables such as impeller types, baffle configurations, gas sparger, and operational variables such as gas rate, particle fraction on critical suspension speed of floating particle in an agitated vessel were investigated

    摘要探討了攪拌槳型、擋板和氣體分佈器等結構因素及氣體流量、顆粒質量分數等工藝因素對下沉顆粒三相體系臨界攪拌轉速的影響。
  8. Water wave pump combines the functions of air wave charger and water hammer pump to show fine performance, where the total energy of inflow is redistributed to heighten the presure of a part of the the flow to the desired level whereas for the rest of flow a low level of pressure is maintained, which causes moving water with high energy to reach to a higher place

    水波泵是一種巧妙地綜合氣波增壓器和水錘泵功能的全新的水泵，它通過合理利用水波動力的特殊性質，將來流中的總體能量進行重新分配，使一部分來流水提高到所需的高壓力，而其餘部分水則降到較低的壓力，即完成一個大多數能量向部分來流水轉移的過程。
  9. Make the theoretical and experimental research of self - cleanup, through the experimental research to the tin, we get the conclusions of jointed cold - blowing and hot - blowing period and the effective temperature range etc. proposed the practical measures to improve the effect of the self - cleanup, laid the groundwork for the future further in - depth study and application

    通過對蓄冷器的實驗研究，掌握了冷吹期和熱吹期的溫度變化規律，獲得了熱吹期填料溫度閉合和輸出氣流有效溫度范圍等結論。通過自清除原理的分析和自清除過程的實驗，提出了改善自清除效果的實用措施，為今後進一步深入研究和應用打下了基礎。
  10. The components of this system are a cross - flow finned - tube evaporator, cross - flow finned - tube gascooler, a reciprocation compressor, a gas - liquid seperator, a double pipe internal heat exchanger and a throttling valve

    系統由一個叉流翅片管式蒸發器、一個叉流翅片管式冷卻器、一臺往復式壓縮機、一個氣液分離器、一個套管式回熱器、一個節流閥組成。
  11. Axial flow gas separator

    軸流式氣體分離器
  12. Simulating calculation for electric field strength distributions of electrostatic precipitators

    屋頂電除塵器入口氣流分佈的數值模擬試驗研究
  13. Study and application of numerical calculation method for gas flow distribution of electrostatic precipitation

    大型電除塵器氣流分佈數值計算的研究和應用
  14. Combination effect of nozzle gas distributor and particle properties on gas - solid flow behaviors in cfb risers

    噴管型氣體分佈器和顆粒物性對提升管內氣固兩相流動行為的聯合影響
  15. A straight inlet baghouse which can effectively reduce energy consumption of equipment in operation and lengthen the service life of fabric bags, as well as gas flow structure in the tank body have been presented, and numerically simulating the gas flow distribution in the tank body being carried out by using calculated flow dynamics ( cfd ) method, providing a method and parameters for adjusting the gas distributing plates structure to realize reasonable flow rate distribution in the tank body

    摘要介紹了能有效降低設備運行能耗、提高濾袋壽命的直通式袋式除塵器及其箱體氣體流通結構，並利用cfd方法對箱體流量分配和氣流分佈進行數值模擬，給出了實現箱體流量合理分配的氣流分佈板結構調整方法和參數。
  16. This distributor use small space. has more distribute hole, little gas resistance, low pressure drop, wide operation flexibility

    該氣液分佈器空間佔位更低，氣體通道開孔率更大，氣流阻力小，壓降低，操作彈性范圍大。
  17. Three dimensional numerical simulation on the flow field of centrifugal gas - liquid separator

    離心式氣液分離器流場的全三維數值模擬
  18. To improve the performance of ashp, an improved ashp system is presented. different from the original system, the new one can control the refrigerant flow rate by the sub - cooling of condenser and adjust the sup - heating of the compressor inlet vapor by the heater in accumulator. the simulation shows the new system not only has better dynamic characteristic of frost and defrost of ashp, but also has higher coefficient of performance

    為改善空氣源熱泵機組的結霜除霜動態性能，提出了一種利用冷凝器過冷度來調節製冷劑流量，在氣液分離器里增加電熱裝置保持壓縮機進口過熱度的改進型系統，結果表明這種改進型系統不但可以改善系統的運行性能，同時能改善系統運行的經濟性，為機組的技術升級和產品更新提供了一個新的途徑。
  19. Main physical and chemical processes including heat and mass transfer, flow distribution, chemical kinetics, oxygen storage and catalyst deactivation are discussed

    討論了催化轉化器中主要的物理和化學過程，包括傳熱傳質、氣流分佈、化學動力學、儲氧和催化劑中毒。
  20. In order to study the regeneration mechanism of dpf in detail, we still need a mathematical model of the channel unit, which present temperature field and the soot reaction rate of the channel. finally, it points out the influences of various factors to the regeneration process by computing the numerical solution of model under different boundary conditions and geometry parameters, such as the initial temperature, the gas flow rate, the oxygen concentration, the sediment quantity and the wall thickness of the filters, and so on. in this way, the paper provides theoretical guidance for optimization design of the dpf

    首先研究了干凈壁流式過濾體的加熱特性，然後在加熱和燃燒理論的基礎上建立了微粒捕集器再生過程的數學模型，並對模型進行了數值計算，得到了捕集器內部的三維溫度場分佈以及溫度梯度分佈，結果與實驗值吻合較好，驗證了模型的正確性;為了詳細的研究微粒捕集器的再生機理，建立了孔道單元數學模型，得到了孔道內的溫度場分佈和微粒反應速率分佈;最後，通過求解模型在不同邊界條件和不同幾何參數下的數值解，分析了各種因素對再生過程的影響，如過濾體初始溫度、過濾體內氣流的流動速率、氧濃度、微粒沉積量以及過濾體壁面厚度，為微粒捕集器的優化設計提供理論指導。
分享友人
分享到 Line

分享到臉書