氣隙長度 的英文怎麼說

中文拼音 [qìxìzhǎngdù]
氣隙長度 英文
airgap clearance
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 長度 : length; longitude; size; extent; footage
  1. For increasing the effective material peak - value power ( empvp ), solving the contradiction between enhancing the pmsm ' s flux - weakening capability in the electromotor state and reducing the pmsm ' s connatural adjustment ratio in the dynamotor state and improving the efficiency of the pmsm, some solving method are taken as follows : the influence of length / diameter ratio to the empvp is analyzed, and the optimum size of length and diameter is chosen

    主要是從提高電機的有效材料峰值功率、解決pmsm提高電動機運行狀態時的弱磁擴速能力和減小發電機運行狀態時的電壓調整率之間的矛盾及提高電機的效率著手，分析了長徑比、氣隙長度對有效材料峰值功率的影響，並確定了它們的最佳尺寸。
  2. It is studied that the formation mechanism of taylor bubble and its control method in gas - liquid two - phase flow, which affects the pressure balance and mechanical driving efficiency in the flow of petroleum engineering. experiments show that the formation of taylor bubble in gas - liquid two - phase flow is due to the intensive congregation and amalgamation of small bubbles driven by void fraction waves and that the highly turbulent flow is able to restrain this formation. thus, the flow regime transition may be checked by increasing the flow turbulence and controlling the disturbed frequency

    對大管徑氣-液兩相流動中嚴重影響壓力平衡與機械驅動效率的段塞流生成機制和控制方法進行了研究，實驗證明段塞流的形成是由於空隙率波的大幅度增長使氣泡高度集中，並形成聚並所致。強湍流運動可以抑制taylor泡的形成。因此，通過強化湍流或控制擾動頻率可以對氣泡聚並起明顯的抑制作用。
  3. Model xjq has following features ： （ 1 ） dummy bottom is adopted, making the recycling capacity of the recycling cylinder is 2. 5times of the tand. ( 2 ) the stator is a cylinder in structure with its inner wall being vertically ribbed, and slots are placed, leading to better cutting lffect to the slurry. ( 3 ) due to low immerging depth of the rotator, low rurning speed of the impeller, and wide space between the impeller and stator, wearing is low and power consumption greatly reduced. ( 4 ) it is spontaneously aerated

    Xjq型浮選機為仿維姆科型，該機主要有以下幾個特點： （ 1 ）採用了假底，循環簡可使循環量達到槽容積的2 . 5倍; （ 2 ）定子結構為圓筒型，內壁設有立筋條和長孔，對礦漿的前切作用好; （ 3 ）轉子浸沒深度淺，葉輪轉速低，葉輪和定子間隙大，所以其磨損輕，動力消耗大大減少; （ 4 ）可自吸空氣。
  4. The results indicate that there is an obvious effect of air gap and ice state on the inception voltage across the air gap

    研究結果表明:間隙長度、冰的狀態和氣壓對間隙的起暈電壓有明顯的影響。
  5. It is necessary to study the welding machine power supply for endless - rolling. it can assure the working reliability of welding machine, decrease the mechanical and electric fault, prolong apparatus ' s life, reduce cost and increase product quality

    它可以保證焊機正常工作，減少機械和電氣事故，延長易損件使用壽命，減低工作強度從而實現無間隙地生產鋼材，大幅度提高車間的經濟效益，降低生產成本，提高鋼材質量。
  6. Railway rolling stock. airconditioning. dimensions and clearances reserved for vg - length air conduits

    鐵路車輛.空調.供vg -長度空氣導管備用的間隙孔和尺寸
  7. By applying related theory of gas discharge and mathematical statistics, this paper more in - depth and systemic study the influence of the length of air gap, ice state, water conductivity and air pressure on the inception corona and pulse discharge characteristics, included the discharge frequency, discharge amplitude and time interval

    根據試驗結果，用氣體放電和數理統計方法，分析了覆冰水電導率、冰的狀態（乾冰和濕冰） 、空氣間隙長度、氣壓和施加電壓等參數的變化對間隙模型的起始放電電壓、脈沖放電特性、放電頻率、放電幅值和時間間隔等的影響。
  8. While, the mean discharge magnitude increase first and after that it has an approximate constant with the increase of applied voltage

    間隙中的平均放電量隨著空氣間隙長度的增加而減小，隨著施加電壓的升高先增加后近似保持不變。
  9. ( 3 ) in order to be suitable for the secrecy of control system, convenient for debugging the control system and make the control system be applied to capacitance, inductance and phase - shifting controlled ozonier, the control system of the ozonier power is based on cpld / fpga chip is presented. ( 4 ) the paper analyzes the shortage of routine inductor designing methods which are used to design intermediate frequency, high voltage resonance reactor, puts forth an iterative method to prevent the problem

    （ 3 ）為解決大功率諧振電抗器的設計困難一直是大功率諧振電源的難點，本文在電抗器常用的ap設計法的基礎上，提出了一種迭代設計方法，這種方法同時考慮氣隙長度范圍和氣隙磁通邊緣效應因數，根據所需電感值來求解滿足要求的鐵芯規格和線圈匝數，不必對電感器的匝數進行修正。
分享友人
分享到 Line

分享到臉書