氣體加壓 的英文怎麼說

中文拼音 [qìtǐjiāyā]
氣體加壓 英文
gas boosting
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 體 : 體構詞成分。
  • 壓 : 壓構詞成分。
  • 氣體 : gas; gaseous fluid
  1. The buildup of pressure would force gas outward at speeds far above escape velocity

    壓力的增加，將迫使氣體以遠高於脫離速度的速率向外逃逸。
  2. A heating unit in the basement of a house burns gas to heat air or water, which is then forced through the house or building to raise it ' s temperature

    居於樓房地下室的一個供熱裝置通過燃燒氣體釋放熱量來給水和空氣加熱，加熱的水或空氣則靠壓力運送到樓房或大樓來提高它的溫度。
  3. The solubilities of the gases generally decrease with increased water salinity and increase with pressure.

    氣體的溶解度通常隨水的鹽度增加而降低，隨壓力增高而增高。
  4. Hydraulic fluid power - gas loaded accumulators - specification for seamless steel accumulator bodies above 0. 5 l water capacity

    液壓流體動力.氣體加載蓄能器.第1部分:水容量0 . 5l以上無縫鋼蓄能器體規范
  5. Standard specification for circulating liquid and forced air patient temperature management devices

    循環液體和加壓氣體的病人溫度管理設施的標準規范
  6. A reasonable position of driving nozzle helps to achieve the maximum material flow that also depends on other parameters such as backpressure, properties of conveyed material and driving gas. it is observed that, an increase of convergent section angle is harmful to the pneumatic conveying system, and also influences on the mass flow rate of conveyed material, the distribution of static pressures in injector and the pressure drops of conveying pipe. in addition, within a reasonable scope of air mass rate, increasing the driving jet velocity is more advantageous than enlarging the dimension of driving nozzle

    試驗研究發現，氣體噴嘴位置對氣固噴射器的輸送能力影響最大，氣體噴嘴存在某一最佳位置，而這一最佳位置與背壓、輸送物料特性和輸送風特性相關聯；氣固噴射器的收縮角對其輸送能力、內部靜壓分佈和輸送管阻力特性均有適量影響，收縮角增大對整個輸送系統均不利；在適當的輸送風范圍內，提高氣體噴嘴出口速度比擴大氣體噴嘴尺寸更為有利，但氣體噴嘴出口速度過高會增加氣固噴射器和輸送管內的能量損耗，給輸送帶來不利的影響；系統背壓與氣固噴射器的氣體噴嘴出口速度的選取有關。
  7. All analysis and simulations results indicate several methods improving the insulation recovery of spark gap switch : ( 1 ) using the gas with good thermal conductivity, such as h2 and sf6 ; ( 2 ) using the gas flow ; ( 3 ) utilizing the v / p cure ; ( 4 ) modifying the geometry and size of the electrode ; ( 5 ) using the gas with good electronegativity, such as sf6. some experiments on the multi - pulse operation of high power spark gap switch are carried out. the insulation recoveries of switch without and with gas flow are both investigated

    結合理論分析和模擬結果，提出了氣體火花開關多脈沖運行特性可採用如下方法: （ 1 ）使用導熱性能好的氣體，如h2 、 sf6等; （ 2 ）採用吹氣的方法; （ 3 ）增大氣壓，在電極表面增加細小結構，構造平穩的v / p曲線; （ 4 ）改良開關電極結構和尺寸，採用奶頭-半球結構的電極; （ 5 ）使用電負性強的氣體作為開關絕緣氣體，如sf6 。
  8. Speculation is that one of 22 men on board, unaware that the unpressurized cabin contained gas fumes, lit a cigarette, causing the explosion

    推測是機上的22個人其中一個人，沒有意識到非加壓艙充滿了瓦斯氣體，點燃了一根香煙，引起了爆炸。
  9. 1 successively depositing cbn thin films on si substrates which reaches international advanced level, the impact of negative substrate bias voltage and rf powers on the formation of cbn thin films were studied. boron nitride ( bn ) films were deposited on ( 100 ) - oriented p - type silicon substrate ( 8i sqcm ) with rf sputtering system. the target was hexagonal boron nitride ( hbn ) of 4n purity, and the working gas was the mixture of nitrogen and argon

    研究了襯底負偏壓和射頻功率對制備立方氮化硼薄膜的影響立方氮化硼薄膜沉積在p型si （ 100 ） （ 8 15 cm ）襯底上，靶材為h - bn靶（純度達99 . 99 ） ，濺射氣體為氬氣和氮氣混合而成，制樣過程中，襯底加直流負偏壓。
  10. Isolative gas - pressurized expansion device

    隔絕式氣體加壓膨脹裝置
  11. Only when it is impulsed by the high pressure gas, can go am fulfill its performance of the actuating stage

    1 、自動機是藉助高壓氣體的外力而完成啟動及預加速任務的。
  12. Material is ejected into the crushing chamber by means of high speed ejection flow formed by high - pressure air through charging ejector, and the crushing nozzles outside ejects high - speed airflow into the crushing chamber at certain direction, making the materials severely collided and fractionated, and thus crushed

    該機是靠高壓氣體通過加料噴射器所形成的高速射流，使粉碎原料被射入料碎室，粉碎室外圍的粉碎噴嘴，有方向性的向粉碎室噴射高速氣流，使物料間產生激烈的碰撞，磨擦而獲得粉碎。
  13. The ramp - type sustain waveform is featured with the longer rise - time than the conventional waveform and it is a compromise to let gas discharge with lower cell voltage but still helps accumulate enough wall charges to sustain discharge sequence in cells

    斜緩維持波形的特徵為其電壓上升時間較傳統波形增加了三倍左右，其有助於降低氣體放電時的空間電壓差和累積足量的壁電荷以維持腔體中氣體放電作用得以連續產生的效果。
  14. An exhaust system should be added for the inflammable gas storage area as well as a flameproof machine, a pressure alarm device ; the cylinder cabinet needs an emergency exhaust device

    增加排氣系統（兼顧事故通風） ，易燃氣體放置區域採用防爆風機，並配置滅火器。並且氣瓶櫃需要自動防爆、壓力報警裝置，氣瓶櫃需要事故排風裝置。
  15. By increasing the h2 dilution ratio, it is found that atomic hydrogen can selectively etch amorphous phase and stabilize crystalline phase. from the study on the distance from substrate to catalyzer, choosing a proper distance can ensure the gas fully decomposed, while a relatively low substrate temperature can cause the nanocrystalline particles to lose mobility and keep their sizes. the pre - carbonization process can enhance the nucleation density and make the growth of high quality nanocrystalline p - sic films much easier

    實驗結果表明：隨著工作氣壓的減小，薄膜的晶粒尺寸有所減小；通過提高氫氣稀釋度，利用原子氫在成膜過程中起的刻蝕作用，可以穩定結晶相併去除雜相；選擇適當的熱絲距離能保證反應氣體充分分解，又使襯底具有較高的過冷度，是形成納米薄膜的重要條件；採用分步碳化法可以提高形核密度，有利於獲得高質量的納米- sic薄膜；襯底施加負偏壓可以明顯提高襯底表面的基團的活性，因負偏壓產生的離子轟擊還能造成高的表面缺陷密度，形成更多的形核位置。
  16. The sequence of two patterns presence is changed alternately, that is, one pattern will appear at the second pulse of total pattern in this half cycle if it appears at first pulse in last half cycle. the stability of square pattern was studied by considering the interaction among the wall charges. the discharge moments of individual filament alternate from long one to short in the square pattern, which can been explained by using the breakdown and quench model through considering the wall discharge accumulated on the dielectric layers

    實驗研究了正方網格斑圖與混合氣體的比例及外加電壓的關系，給出了班圖類型隨上述條件變化的相圖；實驗採用光學方法對正方網格斑圖進行了時空動力學測量，發現正方網格斑圖是由兩套正方網格斑圖相互嵌套而成，其中一套的微放電絲位於另一套正方形單元的中心，這兩套微放電絲交替進行放電；考慮到壁電荷之間的相互作用，研究了正方網格斑圖的穩定性；實驗發現正方網格斑圖的微放電絲放電時間間隔是長短交替變化的，考慮到電介質表面積累的壁電荷的作用，使用擊穿?熄滅方程很好的解釋了該現象。
  17. Standard test method for burst testing of flexible package seals using internal air pressurization within restraining plates

    在約束板中使用內部氣體加壓法做撓性包裝密封件破裂試驗的標準試驗方法
  18. In order to reduce the oxidation of contacts greatly ( or eliminate it ), the environment inside the glass tube is often pressurized with a gas that contains no oxygen

    為了大幅度降低（或者消除）觸點的氧化，玻璃管內的環境往往是採用不含氧氣的氣體加壓的。
  19. 452 the compressor is loaded up with the medium of air ( nitrogen, process gas )

    壓縮機以空氣（氮氣、工藝氣體）加載運轉。
  20. The neutral gas pressure is smaller where electric fields is stronger, which is independent of the instantanious electric polarity of the electrode and cause gas flow from high pressure region to low pressure region. so flow can be accelerated if electric field is properly adjusted, which is the mechanism of the active flow control

    場強越大的區域氣體靜壓反而越低，而與瞬間電極的極性無關，導致了氣體從高壓區到低壓區的流動，因此只要適當改變電場的分佈就可以使氣體產生加速，這就等離子體主動流動控制的加速機理。
分享友人
分享到 Line

分享到臉書