氣體整流器 的英文怎麼說

中文拼音 [qìtǐzhěngliúqì]
氣體整流器 英文
gaseous rectifier
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 體 : 體構詞成分。
  • 整 : Ⅰ形容詞1 （全部在內; 完整） whole; all; complete 2 （整齊） neat; tidy; orderly Ⅱ動詞1 （整理; 整...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 氣體 : gas; gaseous fluid
  1. The torque motor received dc current signals from the electric control and applies torque to the single - piece armature and flapper which is supported on a torsion flexure

    力矩馬達接收來自電氣控制器的直流電信號並將力矩施於由轉矩撓曲支撐的整體式電樞及擋板。 ？
  2. However, in our nation, the research on gan - based microelectronic devices is in the early stage, and a great deal of vestigation is still needed to perform on separative processes of gan devices. due to the lack of algan / gan heterojunction materials in the country, a few researches on algan / gan were made, and the investigation on schottky rectifiers is much less

    在國內， gan基微電子器件的研究剛開始起步，制備gan分立器件的工藝尚處于探索研究階段，特別是受algan gan二維電子氣材料來源的限制，國內algan gan基的場效應晶體管的研究開展得較少，關于肖特基整流二極體的研究更少。
  3. The generator is verified to be of well performances by experiment. the third part concerns the control system of pm generator in vehicle application by commutating and inversion. considering the development of future power supply of auto electric system and the economizing on energy, the multi - voltage power supply system for future autos power supply system is introduced, and the design is given in detail

    最後，結合現代電力電子技術，利用整流橋、逆變器、 mosfet等元器件設計並實現了車用永磁發電機恆壓輸出控制；從未來汽車電氣系統的發展方向和高效節能方面考慮，提出未來汽車的多電壓供電系統的典型配電模型，並對該模型進行具體設計，實現多電壓供電的功能，並給出了控制線路中各主要部分的波形。
  4. This new technology changes from the traditional method by which the induced and compressor wheel separately are designed and produced to a new one by which the one - piece compressor is designed. on the basis of this new technology and the optimum blade profile, the performance of both the compressor and the turbocharger is largely improved. through the heating power calculation of the compressor, the analysis of the surge and the block of the compressor, the test - bed performance test of the turbocharger, the matching test of turbocharger and diesel engine, the propulsion test of the turbocharger on plateau condition, it is proved that the newly - designed compressor not only has high efficiency, but also improves the flow distribution in the high efficiency area so that the propulsion line can run through the high efficiency area

    主要內容包括：提出一種全新的壓氣機葉輪技術和概念，這種技術將傳統的導風輪和壓氣機分開設計、單獨加工改為整體設計、整體加工的單體葉輪；從增壓器與柴油機配機計算所得出的基本參數出發，通過對壓氣機進行熱力計算，確定壓氣機的基本結構參數；再對葉型以及葉輪輪廓與葉輪罩殼的配合間隙進行優化，對新設計的壓氣機進行喘振和堵塞分析；通過增壓器平臺性能試驗，驗證了新設計的壓氣機的性能水平得到了較大的提高，達到了提高增壓器的整體性能水平的目的；通過增壓器與柴油機配機試驗、以及增壓器用於高原條件下的牽引試驗，驗證了新設計的壓氣機不但具有高效率，還改善了高效率區的流量分佈，使牽引特性線貫穿高效率區。
  5. To the cabin which is designed by the forth department chongqing communication college, the model which includes the air in the cabin, generator set and public muffler is built integer, meshed, and added by boundary condition and load. the normal k - model etc are used to be turbulence model of the air in cabin respectively, the turbulence model is calculated by simplef or simplen algorithm, and by the first order accurate msu or the second order accurate supg in advection discretization scheme

    論文對艙內空氣、發電機組和公用消聲器進行了整體建模和網格劃分，施加機組艙模型的邊界條件和載荷，採用標準k -等多個模型來分別模擬機組艙通風散熱的空氣湍流流動，採用simplef和simplen兩種不同的數值演算法以及一階msu和二階supg的對流項分離方案來對流動模型進行運算。
  6. A straight inlet baghouse which can effectively reduce energy consumption of equipment in operation and lengthen the service life of fabric bags, as well as gas flow structure in the tank body have been presented, and numerically simulating the gas flow distribution in the tank body being carried out by using calculated flow dynamics ( cfd ) method, providing a method and parameters for adjusting the gas distributing plates structure to realize reasonable flow rate distribution in the tank body

    摘要介紹了能有效降低設備運行能耗、提高濾袋壽命的直通式袋式除塵器及其箱體氣體流通結構，並利用cfd方法對箱體流量分配和氣流分佈進行數值模擬，給出了實現箱體流量合理分配的氣流分佈板結構調整方法和參數。
  7. In the present paper, according to the characteristics of the dynamic running of the thermoelectric refrigerating devices and its components for the refrigerator is analyzed and the independent components " models are established. the entire model describing the working procedure of the refrigerating system is set up with the method of parameters coupling to combine the models of the refrigerating system, load, cabinet and air in the cabinet. the running characteristics of thermoelectric refrigerators on the effects of received current, load and ambient temperature are investigated using small - signal linearization method

    本文根據熱電製冷系統動態運行的特點，分析了電冰箱製冷系統及各個部件的熱物理過程，運用參數耦合的方法把製冷系統、負載、箱體及箱內空氣模型有機地結合在一起，建立了完整的製冷系統工作過程模型，用小階躍信號線性化法分析了電流、負載功率和環境溫度波動共同作用下的熱電製冷器工作特性。
  8. On - line monitoring of hvcb is the precondition of predicting maintenance, is the key element of reliable run, and is the important supplement to the traditional off - line preventive maintenance in fact, the faults are made by hvcb, no matter in number or in times, is over 60 % of total faults so it has determinative importance for improving the reliability of power supply and this can greatly decrease the capital waste used by - dating overhaul in this paper, the inspecting way of hvcb mechanism characteristic is discussed the concept of sub - circuit protector is presented, the scheme that we offered has been combined with sub - circuit integrality monitoring theory, to ensure that it has the two functions as a whole according the shut - off times at rated short circuit given by hvcb manufacturer, the electricity longevity loss can be calculated in each operation, and the remained longevity can be forecast too an indirect way for calculating main touch ' s temperature by using breaker shell temperature, air circumference temperature and breaker ' s heat resistance is improved in this paper, and main touch resistance can be calculated if providing the load current msp430, a new single chip microcomputer made by ti company, is engaged to develop the hardware system of the on - line monitoring device, and special problem brought by the lower supply voltage range of this chip is considered fully

    高壓斷路器所造成的事故無論是在次數，還是在事故所造成的停電時間上都占據總量60以上。因此，及時了解斷路器的工作狀態對提高供電可靠性有決定性意義；並可以大大減少盲目定期檢修帶來的資金浪費。本文論述了斷路器機械特性參數監測方法；提出了二次迴路保護器的概念，並將跳、合閘線圈完整性監視和二次迴路保護結合起來，給出具有完整性監視功能的二次迴路保護器實現方案；根據斷路器生產廠家提供的斷路器額定短路電流分斷次數，計算每次分閘對應的觸頭電壽命損耗，預測觸頭電壽命；提出根據斷路器殼體溫度和斷路器周圍空氣溫度結合斷路器熱阻來計算斷路器主觸頭穩態溫升的方法，並根據此時的負荷電流間接計算主觸頭迴路的電阻；在硬體電路設計上，採用美國ti公司最新推出的一種功能強大的單片機msp430 ，並充分考慮該晶元的適用電壓范圍給設計帶來的特殊問題；在通信模塊的設計中，解決了不同工作電壓晶元之間的介面問題，並給出了直接聯接的接線方案。
  9. We specialize in the manufacture of high pressure sodium lamp, metal halide lamp, high pressure mercury vapor lamp, electromagnetic ballast for hid lamps, electronic igniter, compensation capacitor condenser, and various industrial and outdoor lighting fixture

    公司主要產品有金屬鹵化物燈高壓鈉燈高壓汞燈燈泡管芯全部自已生產以及各類型號規格的氣體放電燈用鎮流器電子觸發器，整體電器箱。同時生產各種外形雅緻質量上乘價格合理的工礦燈具及室外照明燈具，深受用戶青睞，在市場上享有良好的聲譽。
  10. From the calculation for the system of refrigeration, the choice of equipment, to the calculation for the temperature field and velocity field, the emphases is building model for evaporator in static state and dynamic state, do calculation and analyse for the whole space with temperature field and velocity field

    從製冷系統的負荷計算，設備的選型到溫度場和流速場的計算，其中重點是為蒸發器製冷劑側和空氣側參數建立穩態和動態數學模型，對整個冷庫的庫體空間進行溫度場和流速場的分析計算。
  11. Through preventive and analyzing test of dissolved gas, water content in oil of the large - scale rectification transformer, we discuss the validity of the preventive test, and put forward the proposal on examining method, the failure diagnosis as well as the present situation and the development of maintenance for large - scale rectification transformer

    摘要通過對大型整流變壓器油中溶解氣體、油中含水量分析預防性試驗，探討預防性試驗有效性，並對檢測方法、故障診斷以及大型整流變壓器狀態檢修的現狀與發展提出建議。
  12. In this way, life span of catalytic converter assembly can be checkout in short time. a set of evaluation and test method has been put forward and the test bench has been built up. some catalyst converters on the chinese market as the sample have been tested on the bench, but many quality problems have been found

    另外，本文對催化轉化器內部氣體流動的特性進行了研究，模擬結果表明本文把蜂窩結構的催化器用當量連續法建立載體的流動力學模型，並用ansys軟體對整個催化器的流場進行穩態流動數值模擬的方法是可行的。
  13. Different from fabricating sbd with bulk semiconductor, thin semiconductor films were utilized as the active layer in order to minimize the series resistance. si epilayer with sub - micro thickness was deposited by ultra high vauum chemical vapor deposition ( uhv - cvd ). the sbd with rectifying performance was developed, using si epilayer as the active layer

    利用我們自行研製的超高真空化學氣相沉積（ uhv - cvd ）技術外延了亞微米級的si薄膜，成功的製作了具有整流特性的高頻薄硅肖特基二極體的原型器件。
  14. In this paper, the composition of surgical instrument is described, and the laser control including the communication between computer and laser device, laser pulse on - off control and gas exchange are detailed

    本文簡述了一準分子激光眼科治療機的整體組成部分，並詳細描述了激光器的控制部分：計算機與激光器的通信控制、激光發射停止控制、充換氣流程式控制制。
分享友人
分享到 Line

分享到臉書