氧氣引入量 的英文怎麼說

中文拼音 [yǎngqìyǐnrùliáng]
氧氣引入量 英文
the intake of oxygen
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 引 : Ⅰ動詞1 （牽引; 拉） draw; stretch 2 （引導） lead; guide 3 （離開） leave 4 （伸著） stretch 5 （...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 氧氣 : [化學] oxygen; oxygen gas
  1. Kzl series air clean filter to enter empty to is it stand to press since, the compressor and air conditioner imprison the wind system, blast furnace air - introduced machine of steel plant, gas turbine, air making oxygen raw materials air compressor filter, strain and contain a large number of dust except that among them, prevent from in dust particle long - time adjustment air current sports, to operated equipment above blade, impeller, flow dish and part lead to the fact the harm

    Kzl系列空氣自潔過濾裝置kzl系列空氣自潔過濾裝置是對進入空壓站壓縮機及空調關風系統，鋼鐵廠高爐引風機燃氣輪機制氧原料空壓機的空氣進行過濾，濾除其中含有大量塵埃，避免灰塵粒子在長時間的調整氣流運動中，對以上運行設備的葉片葉輪流道及部件將造成損害。
  2. Also, the author ’ s design strategy and creativity has been given in this paper. specifically, it includes : based on the feasibility analysis of the fit selection of control parameters in the aeration process, the aeration process of wastewater treatment of the joint - constructional complete - mixed activated sludge process has been aimed at in this paper. then, the state equations of the aeration process have been proposed in this paper, which is on the base of dissolved oxygen concentration ( do ) and discharge quantity of sludge ( qw ) as control variables, the concentration of bod and sludge as state variables. based on the present study on optimization control of wastewater treatment, the multivariable optimal control model with restriction factor has been presented in the paper with introducing modern control theory and system analysis into the field of activated sludge wastewater treatment,

    具體包括:以完全混合、表面曝氣合建式活性污泥工藝的污水處理曝氣過程為研究對象，在闡述了曝氣過程式控制制參數選取可行性的基礎上，建立了以溶解氧濃度do和活性污泥排放量qw為控制變量，以曝氣池中有機物濃度s和微生物濃度x為狀態變量的活性污泥曝氣過程的基本狀態方程;運用現代控制理論的觀點和污水處理理論，在現有關于污水處理最優控制問題研究的基礎上，建立了有約束條件多變量能耗最小數學模型，該數學模型是以有機物排放總量和狀態變量的末值條件作為約束條件，曝氣過程的能耗最小作為目標泛函;採用增廣拉格朗日乘子法對最優控制問題進行轉化，並對應用極大值原理求解能耗最小這一最優控制問題進行了詳細的解析;引入約束運算元，應用具有控制約束的共軛梯度演算法對能耗最小這一最優控制問題進行求解，並進行模擬實驗驗證。
  3. The studies expressed that the tensile - strength declined with the growth of dose rate after the radiation treatment, and at the same time, the gel content had extreme value with the change of the dose rate. the surface of uhmwpe fibers showed some irregular micro - pits and dents after radiation treatment, narnely rough degree increasing. their number and deepness increased with increase of dose. and this phenomenon is the most obvious when the dose rate was 8. 5kgy / s and the dose was 400kgy. at the same time some containing oxygen groups, including hydroxyl group, carbonyl group and carboxyl group, were introduced into the fiber surface which was exposed to the air

    研究表明， uhmwpe纖維經電子束輻照處理后，纖維的拉伸斷裂強度隨劑量率的增加呈下降趨勢，凝膠含量隨著劑量率的變化存在極值。纖維表面出現了不規則的微裂紋和凹痕，隨著劑量的增大，電子束對纖維表面的刻蝕程度增加，在本研究中以劑量為400kgy劑量率為8 . 5kgy s時刻蝕效應最為明顯。同時，在空氣中進行輻照時，纖維表面被引入了一些含氧基團，包括羥基、羰基和羧基。
  4. Another possible reason for this phenomenon is that with higher temperature, the mobility near defects of carbon atoms in grown carbon nanotubes would be also elevated, which gave carbon atoms higher mobility and have chance to readjus to decrease or eliminate some defects. a series of pretreatments and modifications including purification, annealing and doping were performed before hydrogen storage experiments carried out at room temperature under modest pressure ( 12mpa )

    在氮氣中進行退火處理納米碳管的儲氫性能高於在空氣中退火的納米碳管，主要原因是在空氣中退火時，納米碳管的表面引入了大量的氧官能團，而氧官能團能夠占據納米碳管的缺陷位，減少了氫的可吸附位置，阻礙氫進入納米碳管，從而降低了納米碳管的儲氫能力。
分享友人
分享到 Line

分享到臉書