氧氣調節器 的英文怎麼說

中文拼音 [yǎngdiàojié]
氧氣調節器 英文
oxygen regulator
  • : 名詞[化學] (氣體元素) oxygen (o)
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : 節構詞成分。
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 氧氣 : [化學] oxygen; oxygen gas
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Respiratory protective devices - plug - in connection between lung governed demand valve and facepiece for self - contained open - circuit compressed air breathing apparatus for use by german fire brigade

    呼吸保護.德國消防隊用自調調閥與獨立
  2. ( 8 ) by studying match between the electronic system and catalytic converter on the base of electronic controlled bypassing air system, conclusions having been gotten as follows : higher conversion efficiency of emission have gotten when a / f fluctuates at definite scope and frequency, by controlling the comparing voltage of 02 sensor, the working scope of catalytic converter can be controlled and the matching that can fulfill the high efficiency of hc, co, nox at same time has been optimized

    ( 8 )進行基於所開發的電控補系統上的催化與電控系統的匹配研究,當控制系統調空燃比在一定范圍按照一定頻率進行波動時,可以提高催化轉化的轉化效率;通過控制傳感的比較電壓,可以控制催化轉化的工作窗口,實現排放污染物中, hc 、 co 、 nox轉化的最優匹配。
  3. Based on advanced technology, this thesis bring forward the optimal scheme and set down general system - drawings and flow charts. using step7 - micro software, we achieve the auto - control aim in drinking water treatment. in practice, the complexity and non - linaerity exit in the system of water treatment, so we apply fuzzy control in water treatment and design a kind of controller which structure can be altered according to the using - rate of ozone and the variety of water quality

    實際飲用水處理系統由於存在復雜性、非線性、時變性,本文根據臭生物活性炭水處理工藝存在復雜性、非線性、時變性等特點,將模糊控制應用在水處理這一不確定的非線性時變系統,針對不同水溫下臭利用率及水質的變化,設計一種基於系統過程狀態的變結構的模糊控制,以單片機作為主要控制硬體,按查表方式設計軟體,對進水閥門開度進行在線控制,調體與進水的比例(臭流量及濃度不變) ,達到水比最優化。
  4. Then a combustion evolution optimizing system based on the radiant energy measuring was built, economical boiler combustion adjustment was carried out, under the combined action of a controller based on fuzzy self - optimizing of fume

    在此基礎上,建立了基於輻射能檢測的燃燒進化優化系統,通過煙量與爐膛總輻射能的模糊自尋優控制和風煤比進化優化組成的燃燒優化迴路的共同作用,對鍋爐進行燃燒經濟性調,達到燃燒優化控制的目的。
  5. One - step synthesization made the electrical properties more stable, controling the reducing sintering temperature and retention time can adjust the electrical properties in a certain scope, changing the oxidation temperature made the varistor ’ s voltage v10ma changed, using the special double - layer silver plasm can eliminate the voltage - direction problem

    一次配料得到的樣品電性能一致性更好;控制還原氛燒結溫度和保溫時間,可以在一定范圍內調鈦酸鍶壓敏電阻的電性能,改變化溫度可以獲得不同的壓敏電壓,從而得到系列化產品;採用雙層銀漿工藝成功消除了壓敏電壓的方向性問題。
  6. The cylinder valve should be turned off when not in use to avoid the regulator being left on the open cylinder for a prolonged period

    在不使用樽時,應關閉其活門,以免調停留在開啟的樽上過
  7. The oxygen regulator should not be manipulated in the lift unless it is safe and really necessary

    除非在安全情況下,並確有必要,否則不應于電梯內操作氧氣調節器
  8. It uses electronic control technology and places an oxide sensor in emission system, then according to the change of the rate of the air to fuel, adjust automatically the ejection of fuel. so it can improve dramatically the automobile performance. after installing three - way catalytic converter, it can make the pollutions lower 20 % ~ 50 % than the same vehicle, and the power of car reduce only 5 %

    對于適合我國現階段的電子閉環控制lpg燃料混合系統進行研究,此方法採用電子控制技術,在排系統中安裝了傳感,可以根據排空燃比的變化,自動反饋調量,使燃汽車性能得到改善,安裝三元催化轉換后,可以使污染物排放較同等水平的汽油車降低20 - 50左右,而發動機功率下降僅達5左右。
  9. Standard test method for evaluating the ignition sensitivity and fault tolerance of oxygen regulators used for medical and emergency applications

    醫療和應急設備用氧氣調節器的引燃敏感性和耐故障性評價的標準試驗方法
  10. This system is utilized the programmable controller ( plc ) bearing of substitution rule ( the figure is apparent the form, writing instrument, individual loop controller, the hand is holded the utensil and is reached to assist the bearing unit and await ), achieve the 29mw ' s cycle stream of water warmhearted water boiler, oxygen remover, warmhearted net system control system together with monitoring voluntarily of electric section together with control being living, the rule to call off greats quantity displays the bearing in that system, boiler, oxygen remover, the warmhearted net operation is achieved crt and is supervised completely, manipulates personnel staff is living inner place the control cabin completely completees failure - free operation and trouble removal operation. the predictive target of putting ino production queen is the boiler, oxygen remover, the warmhearted net is achieved comprehensive self - regulation, moreover be able to be over a long period of time, steady secure operation

    本系統利用可編程式控制制( plc )替代常規的儀表(數顯表、記錄儀、單迴路控制、手操及輔助儀表裝置等) ,實現29mw循環流化床熱水鍋爐、除、熱網系統控制系統與電部分的自動監測與控制。在該系統中取消大量的常規顯示儀表,鍋爐、除、熱網的運行實現crt全面監控,操作人員在控制室內全部完成正常運行及事故處理操作。投產后的預期目標是鍋爐、除、熱網實現全面自動調,並能長期、穩定、安全運行。
  11. In the light of the incident at qeh in december 2003, the ha issued to all public hospitals an update to its safety guidelines on the use and maintenance of oxygen regulators on february 3, 2004. the details of the update are as follows -

    鑒于伊利沙伯醫院在二三年十二月發生的事故,醫管局在二四年二月三日向所有公立醫院發出氧氣調節器使用及維修的修訂安全指引。
  12. Joints for connecting crew member ' s regulators masks to oxygen sources

    機組人員氧氣調節器面罩與源連接的接頭
  13. The task in the open loop system is to get lpg injection duty ratio in pre - set two dimension map according to practical engine operation condition, while the task in the closed - loop system is to calculate lpg injection duty ratio by the approaching increment method or the proportion and integral ( pi ) controller according to the signal of the oxygen sensor. to eliminate the oscillation phenomena of the signal of the oxygen sensor in low - speed condition, this paper develops the stable increment method

    開環階段根據實時工況參數對事先制取的噴占空比map圖執行取值操作;閉環階段根據傳感反饋信號通過增量逼近法或pi環計算輸出適合即時工況的噴占空比值;為解決低速振蕩現象,本文運用固定增量法,對系統進行低速振蕩微調
分享友人