氧氣轉爐 的英文怎麼說

中文拼音 [yǎngzhuǎn]
氧氣轉爐 英文
oxygen converter
  • : 名詞[化學] (氣體元素) oxygen (o)
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 轉構詞成分。
  • 氧氣 : [化學] oxygen; oxygen gas
  1. Such as 180 t oxygen converter, 1550 250 mm plate suspending straightening machine, annealing furnace of the whole hydrogeb mask, 1250mm cantalever straightener etc.

    如180t頂吹, 1550250mm板坯連鑄機, 1829球磨機,全氫罩式退火, 1250mm懸臂矯直機等。
  2. Oxygen - natural rotating gas furnace for cast iron melting

    熔煉鑄鐵用183 ;天然
  3. Specifically for the iron and steel industry during the past 15 years, thermo electron has installed over 100 mass spectrometers for gas analysis applications involving the following plants : coke ovens, blast furnace ( bf ), direct reduction iron ( dri ), basic oxygen furnace ( bof ), electric arc furnace ( eaf ), argon oxygen decarburization ( aod ) furnace, vacuum oxygen decarburization vod furnace and ruhrstahl - hausen ( rh ) furnace

    尤其在過去15年的鋼鐵行業中,超過100臺過程質譜儀用於體分析,包含:焦,高,直接還原煉鐵頂吹,電弧,氬脫碳,真空脫碳和循環法真空脫碳
  4. Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. , if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios

    文摘:在某些廢鋼熔煉過程中,當料中含碳及碳氫物質且燃燒不充分時,會帶來煙中一化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙成分隨時間的改變以及二次燃燒率的變化,試驗結果表明,反應過程的限制性環節是油分的熱分解;在較低的溫度下( co ) / ( co2 )比例影響化率和二次燃燒率;而在任意比例下保證充分反應的溫度為900以上
  5. Basic oxygen furnace

    頂吹
  6. The iron is converted into steel in the bof using oxygen to remove impurities such as carbon

    頂吹中,通過除去碳等雜質將鐵為鋼。
  7. The results showed that the melting ratio of silica flux decreases and the complete melting time prolongs with the size of silica flux and matte grade increasing, and the effect of the blowing air and oxygen enrichment is not remarkable in the high grade copper matte converting process

    對于高品位冰銅吹煉,鼓入體流量和濃度對石英熔劑熔化率影響不顯著;熔劑粒度和冰銅品位對熔化率影響顯著,並隨著熔劑粒度和冰銅品位的增加,熔劑熔化率降低,完全熔化時間延長。
  8. Bof basic oxygen furnace

    堿性氧氣轉爐
  9. Influence of converter steel production on co2 content in the air of oxygen production stations

    煉鋼生產對站區空中二化碳含量的影響
  10. Basic oxygen converter

    鹼性氧氣轉爐
  11. The thin slab continuous casting and continuous rolling technology that was adopted by zhugang is an important technological revolution after the development of oxygen converter and continuous casting in the world iron and steel making industry field. in comparison to the conventional hot strip and sheet rolling technology the new technology has advantages such as saving investment cost, increasing finish product yield, decreasing production cost and shorting production cycle in large scale

    珠鋼選用的薄板坯連鑄連軋工藝是世界鋼鐵工業領域中,繼氧氣轉爐煉鋼、連續鑄鋼之後的重大技術革命,與傳統的熱軋板材生產工藝相比,它具有節約投資、提高成材率、降低生產成本、大幅度縮短生產周期等優勢
分享友人