氯電位 的英文怎麼說

中文拼音 [diànwèi]
氯電位 英文
chloride ion potential
  • : 名詞[化學] chlorine (17號元素, 符號cl)
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ名詞1 (所在或所佔的地方) place; location 2 (職位; 地位) position; post; status 3 (特指皇帝...
  1. If we can find a way to artificially enhance the adsorption of activated carbon, its benefits on economy and environment will be considerable. it is the aim of this work to investigate electrosorption of chloroform in water on granular activated carbon. the potentials on working electrode are controlled by potentiostat and the concentration of chloroform is measured by headspace gas chromatography

    實驗用恆儀作控制源,調節工作(相對于參比)來控制加在活性炭上的場,用頂空進樣法測定水中仿的剩餘濃度,參照方法與依據都是國家標準方法或國外先進方法。
  2. The corrosion behavior of nanocrystalline ( nc ) copper bulks with various grain sizes prepared from igc ( inert gas condemsation ) and vacuum annealing in comparison with conventional microcrystalline ( mc ) copper ( as - rolled and electrolytic ) in acid copper sulphate solution and neutral solution containing chlorides under free corrosion conditions and anodic polarizations has been studied using potentiodynamic polarization, potentiometric analysis, cyclic voltammetry and electrochemical impedance spectroscopy. x - ray diffraction was used to estimate the grain size of the annealed nc copper. field emission gun scanning electron microscopy and x - ray energy - dispersive spectroscopy was used to characterize the surface morphology and analyze the surface composition after the polarization and potentiometric test of both nc and mc copper

    本文研究了用igc (惰性氣體蒸發凝聚原溫壓法)制備並真空退火到不同晶粒尺寸的納米晶銅和微米晶銅(冷軋紫銅、解銅)在酸性硫酸銅溶液和中性含溶液中,在自腐蝕狀態和陽極極化狀態下的腐蝕性能。使用了動勢極化、測定、循環伏安法( cv )和化學阻抗譜( eis )等方法。 x -射線衍射( xrd )的方法用來估算納米晶銅晶粒尺寸。
  3. In this paper, rebar corrosion state was judged with three electrochemical nondestructive measuring technologies, i. e. half - cell potential, a. c. impedance and time potential. when the rebar was transformed from passivation to depassivation, it can obtain the chloride ions corrosion critical content through taking and analyzing chloride ions content around the rebar

    本文利用半法、交流阻抗法和時間法三種化學無損檢測技術判斷評估試件在試驗過程中鋼筋腐蝕狀況,當鋼筋由鈍化狀態轉為活化狀態時,取樣分析鋼筋周圍離子含量,得到了不同技術條件混凝土的離子臨界濃度。
  4. Inorganic chemical products for industrial use - general method for determination of chloride content - potentiometric method

    無機化工產品中化物含量測定的通用方法滴定法
  5. Effects of rare earth elements on chlorine evolution potential

    稀土元素對析氯電位的影響
  6. Paper, board and pulp - determination of water soluble chlorides agno3 method

    紙紙板和紙漿水溶性化物的測定硝酸銀滴定法
  7. Soaps. determination of chlorides. potentiometric method

    肥皂.化物含量的測定.測定法
  8. Essential oils. determination of the carbonyl value. potentiometric methods using hydroxylammonium chloride

    香精油.羰基值的測定.化羥銨計測量法
  9. Starches and derived products. determination of chloride content. potentiometric method

    澱粉及其製品.化物含量測定.計法
  10. Surface active agents. determination of the sodium chloride contentpotentiometric method

    表面活性劑.化鈉含量的測定.計法
  11. Fruits, vegetables and derived products. determination of chloride content. potentiometric method

    水果蔬菜和衍生製品.化物含量的測定.計法
  12. Mol l, artemisinin can be reduced via the hemin - catalysis and its original cathodic peak at - 1. 08v completely disappeared. the cathodic overpotential of artemisinin is decreased ca. 600mv. this process is verified by the fact that complex edta - fe can also promote the artemisinin reduction with decreasing the cathodic overpotential of artemisinin for 590mv. these results show that the reduction of artemisinin at the glassy carbon electrode is a catalytic process with the aids of hemin. hemin can greatly decrease the cathodic activation energy of the reduction of artemisinin and promote the decomposition of artemisinin

    Mol l化血紅素存在下,青蒿素仍可被催化還原,陰極過降低了600mv 。配合物edta - fe具有類似化血紅素的催化性質,它降低了qhs陰極過590mv 。在這個體系中,青蒿素在碳極上的還原是一個藉助于化血紅素催化的還原過程,化血紅素的存在降低了青蒿素還原活化能,促進了青蒿素的分解。
  13. Sodium carbonate for industrial use - part 4 : determination of sodium chloride content - modified volhard method, potentiometric method

    工業用碳酸鈉.第4部分:化鈉含量的測定.改進的伏哈德測定法
  14. Sulphuric acid for industrial use. determination of chlorides content. potentiometric method

    工業用硫酸.化物含量的測定.測定法
  15. Chemical products for industrial use. general method for determination of chloride ions. potentiometric method

    工業用化學製品.離子含量測定的一般方法.測定法
  16. The redox potentials of chloroform are more than 500mv and electrosorption is only controlled by electric field and adsorption of granular activated carbon. the tests of adsorptions also testify it. the freundlich isotherm equation q = kc n is used for fitting the data

    另外,仿的解氧化還原大於500mv ,因此,此場范圍不會分解仿,回收率實驗與色譜分析也證明了場只對活性炭的吸附起催化作用,而不改變吸附劑與吸附質的內部性質。
  17. In neutral solution containing chloridions, the nc copper has a more positive corrosion potentialanodic polarization test revealed that the nc copper has a lower passivation potential, critical current density and passivation current density

    Eds分析表明納米晶銅蝕孔中的s和cl含量遠高於表面。在中性含溶液中,納米晶銅的腐蝕比微米晶銅高300mv 。
  18. Lithium carbonate - determination of lithium chloride content - potentiometric method

    碳酸鋰單水氫氧化鋰化鋰化學分析方法滴定法測定化鋰量
  19. Starches and derived products - determination of chloride content - potentiometric method

    澱粉及其製品.化物含量測定.
  20. General methods of chemical analysis - method for determination of chloride ions by potentiometry

    通用化學分析方法.第4部分:滴定法測定離子
分享友人