水壓致裂法 的英文怎麼說

中文拼音 [shuǐyāzhìlièfǎ]
水壓致裂法 英文
hydraulic fracturing
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 壓 : 壓構詞成分。
  • 致 : Ⅰ動詞1 （給與;向對方表示禮節、情意等） deliver; send; extend 2 （集中於某個方面） devote （one s ...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 水壓 : water gage; hydraulic pressure （用英寸高度表示的）水壓泵 hydraulic pump; 水壓鍛造 hydraulic forg...
  1. Obtain these chief research achievements. ( 1 ) the method of hydraulic fracturing, kaiser effect experiment and the finite element numerical simulation computation results, the direction of maximum horizontal principal stress intersect the small - angle of tunnel axial line, it is favorable to the stability of tunnel peripheral rock ; according to the test rust of field stress - relief method, at the present time, zhe gu mount tunnel have n ' t access to high crustal stress site, maximum principal stress magnitude is 17mpa ~ 20mpa

    主要獲得以下研究成果： （ 1 ）綜合水壓致裂法、室內巖石kaiser效應試驗和有限元數值模擬計算研究成果，最大水平主應力方向與隧道洞軸線小角度相交，對隧道圍巖穩定性有利；根據現場應力解除法測試結果，目前鷓鴣山隧道尚未進入高地應力段，最大主應力量級為17mpa 20mpa 。
  2. The authors and their research team design a sat of bran - new hydro jacking test equipment and suited software on the basis of their hydro - fracture research

    摘要在水壓致裂法地應力測試研究的基礎上，結合工程實際情況設計出一套全新的水壓劈裂測試系統設備和相匹配的測試軟體。
  3. Code of hydraulic fracturing and overcoring method for in - situ stress measurement

    原地應力測量水壓致裂法和套芯解除法技術規范
  4. Two methods " principle of three dimensional stress determination developed from the above four basic ones by yangtze river scientific research institute are presented, one based on hydraulic fracturing and hydraulic tests on preexistent fractures in single borehole, another one based on ckx - 97 hollow package 3 direction strain gauge

    並對長江科學院完善的單鉆孔中水壓致裂法三維地應力測量和ckx - 97型空心包體式鉆孔三向應變計的三維地應力測量的計算公式作了推導。
  5. It is stated systematically in the thesis the method ' s theories and measuring principle of all kinds of geostress determination technology. in particular the four methods recommended in 1987 by the committee of test method of the international society of rock mechanics, i. e. two over - coring methods of strain relief in boreholes, hydraulic fracturing method and stress furbish measurement which measures the surface stress

    本文較為系統地、全面地介紹了當前國內外通用的各種地應力測量方法的理論、測量原理；特別就國際巖石力學學會試驗方法委員會於1987年推薦的4種地應力測定方法（鉆孔孔徑變形測量法、鉆孔孔壁應變測量法、水壓致裂法以及測量巖體表面應力的應力恢復測量法）作了較為詳細的敘述。
  6. The hydraulic fracturing technology has been developed into a reliable and practical method to determine the in - situ stress slate of underground caverns, self - bearing capability of wall rock of high - pressure cavern and the high - pressure hydraulic permeability of rock mass, which has been widely used in the disposal of nuclear waste, the long and deeply - buried communication tunnels and the high - pressure caverns of hydraulic power plant

    摘要水壓致裂技術現已發展成為確定地下洞室二維原地應力狀態、高壓洞室圍巖的自身承載能力以及巖體高壓透水性的可靠實用方法，並已經在核廢料處置、長大深埋交通隧道以及水電站高壓力洞室工程中得到廣泛應用。
  7. Deep well dewatering of soft soil two - layer structure excavation is a kind of economical and effective dewatering method to ensure waterproof in deep excavation. nevertheless its negative impact on is often unavoidable. deep excavation dewatering often leads to the formation of a depressing cone, which may cause the cracking and even the breaking of surrounding buildings and utilities

    在軟土地區二元結構地層，採用深井降低承壓水，是保證深基坑施工作業的一種經濟有效的方法，但也存在著一定的負面影響，因為降水勢必會形成降水漏斗，而引起基坑周邊地面沉降，可能導致周邊建築物和公共設施的開裂或損壞。
分享友人
分享到 Line

分享到臉書