水接觸角 的英文怎麼說

中文拼音 [shuǐjiēchùjiǎo]
水接觸角 英文
water contact angle
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 接 : Ⅰ動詞1 （靠近;接觸） come into contact with; come close to 2 （連接; 使連接） connect; join; put ...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 觸角 : [動物學] antenna; feeler; tentacle （昆蟲、軟體動物等感覺器官之一, 也叫「觸須」）
  1. The hydrophilicity of the modified nano - tio2 film was also studied. the ruslt shows that the hydrophilic angle has a little increase, but its super hydrophilicity is not alterant, and also shows the hydrophilic angle increasing on open entironment is slowing

    結果表明，改性后催化劑的接觸角有所增加，但催化劑的超親水性沒有發生改變，同時催化劑經等離子體處理后在開放的環境中樣品的接觸角的變化緩慢一些。
  2. The polymer film ' s hydrophile was test with contact angle machine

    利用接觸角測試儀分析該聚合膜的親水性。
  3. Basom observed the contact angle of water against silane-treated e glass to be about 1. 2 rad.

    巴索母觀察到水對硅烷處理的E玻璃接觸角大約是12弧度。
  4. Basom observed the contact angle of water against silane - treated e glass to be about 1. 2 rad

    巴索母觀察到水對硅烷處理的e玻璃接觸角大約是1 2弧度。
  5. The compound modification of silane wet method and stearic acid dry method modification combine the advantage of individual stearic acid modification and silane modification. the indices are listed as following : wetting contact angle 140, penetration time 200 minutes, oil absorption contents 1. 4, dispersion degree17. 5. on the basis of compound modification, silane and stearic acid cooperation modification simplify the modification craft

    試驗研究表明，單一硅烷改性，干法效果優于濕法；硅烷濕法與硬脂酸干法復合改性，結合了硬脂酸、硅烷單獨改性的優勢，改性后的指標分別為：接觸角140度，滲水時間200min ，吸油值31 . 4 ，分散度17 . 5ml ；在復合改性的基礎上，硅烷與硬脂酸復配干法改性，進一步簡化了改性工藝，改性后的指標分別為：接觸角145度，滲水時間220min ，吸油值28 . 2 ，分散度18 . 0ml 。
  6. The 3t3 mouse fibroblasts and human endothelial cells cultured on the surface of the implanted pp showed much better attachment and proliferation than that for controlled pp. at the same time, the cooft ion implantation also exhibited low macrophage attachment with normal cellular morphology. the above results can cause positive effects on the biocompa tibility when it is used as implant material

    研究表明，離子注入后聚丙烯表面的親水性和血液相容性研究表明，通過對pp表面進行cooh ~ +離子注入處理，可以降低其表面能和水接觸角，提高其抗凝血性能和抗鈣化性能，並且pp的抗凝血性能與cooh ~ +離子的注入劑量具有很大的相關性。
  7. Besides, it was founded that the compatible of the system consisted of mts - mma copolymer and pmma was better than that of pmts / pmma

    應用dma ， dsc ， uv及水滴接觸角等測試手段表徵了有機硅聚合物-聚甲基丙烯酸酯梯度膜的性能。
  8. Standard test method for hydrophobic contamination on glass by contact angle measurement

    用接觸角測量法測定玻璃表面上疏水污物量的標準試驗方法
  9. The different ratio and dosage of composite surfactants were researched about the polymer latex ' s stabilization and structure. afterwards, the emulsion polymerization of tris, mma, and p ( mma - co - ptris ) were carried out. some different monomer ratio copolymer latex and homopolymer latex are prepared by emulsion polymerization used self - made organosilicone monomer - [ tris ( trimethylsiloxy ) silyl ] propylmethacrylate and mma

    用ir ， tem ， dma ，水滴接觸角測試等方法表徵所制備的均聚物和共聚物膜發現：採用有機硅表面活性劑與十二烷基硫酸鈉復配使用，用量在6 8 （相對單體量）可得到粒徑分佈均勻且穩定的均聚和共聚乳液。
  10. Test method for surface wettability and absorbency of sheeted materials using an automated contact angle tester

    利用自動接觸角測試儀測定薄板材料的表面濕潤性和吸水性的試驗方法
  11. The ratio f / c decreases with the increase of power, but increases when pressure increase. the power has more marked effect on f / c than that of pressure. contact angle of fluorocarbon films obtained at different of power, pressure and treating time

    最後研究了不同功率、壓力、濺射時間對氟碳膜憎水性能的影響，並測量了氟碳膜的接觸角，發現接觸角隨功率的增加而減小，隨壓力的增加而增大。
  12. After formulation of coating and applied at room temperature produced high durable and superhydrophobic coatings

    所形成的超疏水表面與水接觸角大於150度，耐刷洗亦超過5000次。
  13. A lot of indoor and in - suti test to the properties of the chemical grouting material, especially the properties requested by actual engineering has proceeded. active - diluent of furfural - acetone, low poison hardener. surfactant and a series of formula have been selected by experiment. cw series material has low glue degree, time last of it harden can be adjust, surface tension and contact angle of the material is low

    對漿材性能特別是工程實際對漿材要求的性能進行了大量室內、現場試驗測試，選擇性能優良的糠醛?丙酮活性稀釋劑、低毒憎水性固化劑、表面活性劑及系列漿材配比， cw系漿液粘度、固化時間大范圍可調、表面張力及接觸角小、漿材固化及固結強度高，具有優良的浸潤性能和工藝性能。
  14. Because of the larger contact angle 9 of low - energy surface, the phase transformation energy barrier of vapor is higher than those of high - energy surface, and the frosting of air cooler is effectively restrained ; 3

    低能表面因水接觸角大，水蒸氣相變時的核化能障較大，從而有效地抑制了蒸發器的結霜。
  15. Interestingly the complicated surface is much like the microstructure of nature lotus leaf, which has never reported in a - c films ; via ca tests on the a - c films with different surface features indicated that the wettability of a - c films can be controlled in large scale, ranging from very hydrophilicity ( 40o ) to super - hydrophobicity ( 152o ) by only adjusting the surface morphology ; 2

    對具有不同表面特徵薄膜的潤濕性能測試表明:僅僅通過工藝的調控，形貌的改變就可以使非晶碳薄膜的表面從非常親水（接觸角為40o ）到超疏水（接觸角為152o ）大范圍的浮動。 2 .通過計盒分維法將不同形貌的薄膜定量描述。
  16. Special and easily controllable wettability of solid has attracted much interest because it will bring great convenience on our daily life as well as in many industrial and agricultural processes, for example, super - hydrophobic surfaces ( water contact angle ( ca ) larger than 150o ) have or will play a important role in prevention of adhesion of snow to antennas and windows, self - cleaning traffic indicators, cell motility

    無論是在工農業生產還是人們的日常生活中，潤濕都是一種非常重要的現象，具有特殊潤濕性和可控潤濕性材料一直是人們關注的熱點，比如超疏水材料（接觸角大於150o ）在窗戶和天線的防雪防霜，汽車擋風玻璃的自清潔，以及生物細胞的活動等領域已經或者即將發揮極大的作用。
  17. Compared with untreated graphite under the same condition, the surface electric potential of treated graphite changes in part, but unlike a1 ( oh ) 3, the oxidation ratio decreases 10 % when a1 ( oh ) 3 / graphite ( wt % ) = 10, and the wetting angle of treated graphite hold the line, namely the wetting ability is not improved. contrasted with the hydrolyze coating way, the deposition coating way has simple technical process, lower cost, and its disadvantage, for instance, coat layer distributes unevenly, the wetting ability is not improved. furthermore, the effect of treated graphite applied in mgo - c castables are investigated

    經沉澱法改性后，石墨的表面電性發生了一定的變化，其等電點從2 3變為7 8 ，但與al （ oh ） _ 3的等電點（ 8 9 ）存在一定的差異；接觸角測定結果則表明，經沉澱法改性后，石墨與水的接觸角並沒有改變，即改性石墨與水的潤濕性沒有明顯改善；當al （ oh ） _ 3石墨（ wt ） = 10時，改性石墨的氧化失重率比未改性石墨下降了約10 ，這說明經沉澱法改性后，石墨的抗氧化性得到了一定的改善。
  18. Treated by hydrolyze coating way, the surface electric potential of graphite moves and iep changes from 2 - 3 to 8 - 9, reach the one of a1 ( oh ) 3 ; moreover, the wetting angle of treated graphite decreased 10, and the oxidation ratio decreased 20 % when al ( oh ) 3 / graphite ( wt % ) = 10, compared with untreated graphite under the same condition. that is to say, the wetting and anti - oxidation ability of graphite is improved, after treated by hydrolyze coating way

    經水解法改性后，石墨的表面電性發生改變，其等電點由2 3變為8 9 ，與al （ oh ） _ 3的等電點相近；與未改性石墨相比，改性石墨與水的接觸角下降約10 。當al （ oh ） _ 3石墨（ wt ） = 10時，水解法改性石墨的氧化失重率比未改性石墨下降了約20 ，因此經水解法改性后，石墨與水的潤濕性有所改善，抗氧化性有所提高。
  19. The different ratio and dosage of composite surfactants were researched about the polymer latex ' s stabilization and structure. these copolymers and homo - polymer blend to prepare self - structure gradient film. to prepare the functionally gradient materials ( fgm ) of polysilane - polyacrylate, the method of emulsion mixture was performed

    各種均聚物、共聚物膜的水滴接觸角顯示，單體tris的含量越高，膜的水滴接觸角越大，這也表明共聚物的表面能隨tris的含量呈梯度變化。
  20. Water contact angle measurement of the control and the modified plla membranes indicated that the hydrophilicity of the membrane was improved obviously after the grafting modification

    Atr - ir和xps測試結果證明了接枝聚合的發生。接觸角測試結果表明改性后plla膜表面的親水性明顯提高。
分享友人
分享到 Line

分享到臉書