水浸漬法 的英文怎麼說

中文拼音 [shuǐjìnzìfǎ]
水浸漬法 英文
water retting
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 漬 : Ⅰ名詞1 （地面的積水） floodwater on low lying land 2 [方言] （積在物體上難以除去的油泥等） stain;...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. Purpose : to explore the technique of induction of polyploidy in isatica indicago by colchicine treatment

    摘要採用直接浸漬和加入培養基法對菘藍種子進行誘導，探討秋水仙堿誘導菘藍多倍體的方法。
  2. In this paper, the aqueous sol of sno2 ultrafme particles were prepared by the colloid chemistry method. here we found that the partical properties of sno2 was concerned with experimental parameters such as type of peptization acid, sn4 + concentration, peptization time, peptization temperature, ageing time et al

    本文採用膠體化學法制備了sno _ 2納米粒子水溶膠，細致研究了膠溶酸類型、 sn ~ （ 4 + ）濃度、膠溶溫度、膠溶時間、陳化時間等對納米粒子性質的影響，並利用浸漬提拉法制備了sno _ 2超微粒子薄膜。
  3. Base on discuss, choosing mongolian scotch pine and manchurian ash as experiment species, using three kinds of wood fire - retardant treatment methods which included soaking at some pressure, pressurized soaking under ultrasonic wave and the pressurized soaking under ultrasonic wave after treated by microwave, the result is that ultrasonic wave may apply in wood fire - retardant treatment production

    在討論的基礎上，以樟子松和水曲柳為木材試樣，選擇壓力浸漬、超聲波加壓浸漬和微波處理后超聲波加壓浸漬3種木材阻燃處理方法，經過試驗，說明在生產阻燃木材的浸漬方法中引入超聲波技術是可行的。
  4. Standard practice for testing water resistance of coatings using water immersion

    水浸漬法測試塗層的耐水性能的標準實施規程
  5. Aerospace series. fibre reinforced plastics. determination of water absorption by immersion

    航空航天系列.纖維增強塑料.用浸漬法測定吸水量
  6. Rust preventive oils - test method of salt water immersion

    防銹油鹽水浸漬試驗法
  7. Standard test method for saltwater pressure immersion and temperature testing of photovoltaic modules for marine environments

    海洋環境用光電組件的鹽水壓力浸漬試驗和溫度試驗的標準試驗方法
  8. Optical fibres - part 1 - 53 : measurement methods and test procedures - water immersion

    光學纖維.第1 - 53部分:測量方法和試驗程序.水浸漬
  9. Aerospace industry. paints and varnishes. determination of the water resistance. method by immersion in de - ionized water

    航空航天工業.塗料和清漆.耐水性的測定.用去離子水浸漬法
  10. Testing of carbonaceous materials - determination of bulk density by buoyancy method and the open porosity by impregnation with water - solid materials

    炭素材料的試驗.用浮力法測定鬆散密度並用水浸漬法測
  11. Products and systems for the protection and repair of concrete structures - test methods - determination of loss of mass of hydrophobic impregnated concrete after freeze - thaw salt stress

    混凝土結構的防護和維修用產品和系統.試驗方法.鹽力解凍后疏水性浸漬混凝土質量損失測定
  12. Precast concrete products - test method for glass - fibre reinforced cement - determination of the absorption of water by immersion and determination of the dry density

    預制混凝土製產品.玻璃纖維增強水泥的測試方法.浸漬時水吸收性的測定和干密度的測定
  13. Standard test method for abrasiveness of ink - impregnated fabric printer ribbons

    墨水浸漬的織物列印帶的磨損性標準試驗方法
  14. Standard test methods for moisture content of oil - impregnated cellulosic insulation

    經油浸漬的纖維素絕緣材料含水量的標準試驗方法
  15. Testing method for elution by dipping in water of fine ceramics

    細陶瓷的水中浸漬洗脫試驗方法
分享友人
分享到 Line

分享到臉書