水翼理論 的英文怎麼說

中文拼音 [shuǐyìlǐlún]
水翼理論 英文
hydrofoil theory
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 翼 : Ⅰ名詞1 （翅膀） the wing of a bird 2 （像翅膀的東西） the wing of an aeroplane etc : 鼻翼 wing of...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 論 : 論名詞（記錄孔子及其門徒的言行的「論語」） the analects of confucius
  • 理論 : theory
  1. In addition to, the fatigue crack between web and upper flange of welded steel crane beam on heavy duty service was discussed, and based on long - term observation and research, the author classified fatigue crack into bearing type and middle type crack along the horizontal direction. the causation, distributive law and mechanism of the crack were analyzed, and the precautions to take and the measures to remedy crack were presented. the main defacts including damage, crack, erosion and aging in structures, especially in concrete structure were introduced ; the defact mechanism was analyzed and the precautions to take were also given

    另外，作者對重級工作制焊接鋼吊車梁腹板與上翼緣連接焊縫的縱向水平疲勞裂縫進行了長期的觀察和研究，根據疲勞裂縫產生的不同機理，將其分為支點裂縫和肋間裂縫，並討論了兩類裂縫產生的原因、分佈規律、機理以及防治的措施；對工程中經常遇到的結構構件，尤其混凝土構件的幾種主要病害（損傷、裂縫、腐蝕與老化）進行了機理分析並提出了防治措施。
  2. The effect of reynolds number on rudder hydrodynamic performance is also analyzed. up to the stall angle the computed lift and drag agree well with measurements and other author ' s calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under - predicted. the solver is used to investigate laminar and turbulent separated flows around a 6 : 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces

    應用所開發的求解器，以naca0015翼型舵為算例計算了船舵在不同雷諾武漢理三;大學博士學位論文數下大舵角范圍內的三維粘性流場及水動力，成功地預報了舵的失速角和最大升力，並初步探討了雷諾數對舵水動力的影響;計算結果與現有試驗和計算數據比較，吻合程度相當好，初步檢驗和驗證了該求解器精確模擬粘性流動和計算水動力的能力。
  3. In this thesis, four types of steel beam - rectangular cfst column connections, including normal welded flange plate ( wfp ) connection, bolted flange plate ( bfp ) connection, stiffened end plate ( sep ) connection and double split - tee plate ( dst ) connection, were designed based on the configuration of steel frame connection. total 8 models, 2 models of each kind of connections were tested under low - reversed cyclic loading at the end of cfst columns. the relationships between force and displacement at the end of columns, the relationships between the moment and rotation of the joints, degradations of strength and stiffness, ductility, failure mechanism and failure characteristics of these four connections under different axial - compression ratios were presented

    本文借鑒鋼框架節點構造，設計了四種類型矩形鋼管混凝土柱與鋼梁連接節點，包括常規栓焊（ wfp ）節點、翼緣全螺栓連接（ bfp ）節點、雙t板連接（ dst ）節點以及加勁端板連接（ sep ）節點，進行了四類節點8個模型試件在柱端低周反復荷載作用下的抗震性能試驗研究，比較了不同軸壓比下節點的滯回性能、強度與剛度退化、延性、破壞機理與破壞特徵，主要結論有： 1 、節點的位移滯回曲線與轉角滯回曲線為塊型分佈，沒有或略有捏攏現象，耗能能力強； 2 、軸壓比對節點滯回曲線有顯著影響，全部節點都有顯著的剛度退化； 3 、位移與轉角骨架曲線在峰值荷載後有較長的水平或下降段，具有良好的延性性能； 4 、從整體抗震性能上看，翼緣全螺栓連接節點、雙t板連接與加勁端板連接節點都優于常規栓焊節點，可在實際工程中加以推廣。
  4. Abstract : the effects of airfoil geometric parameters on wing " s spacial and polarized scattering characteristics have been systematically revealed. the results of the study indicated that the calculating value of diffraction from trailing edge by using the formula of the straight wedge is very far from experimental results for vertical polarization, and the contribution of thickness of the trailing edge to scattering must be considered in the calculation. the scattering peak of leading edge depends only on radius of airfoil for horizontal polarization. but for vertical polarization, it depends on maximum thickness and the location of maximum thickness. engineering formulas for evaluating all scattering peaks were given in the paper. it is important for the design of low - rcs wing

    文摘:系統地揭示了翼形幾何參數對機翼的空間散射特性、極化散射特性的影響規律.研究發現，在垂直極化狀態下用理論尖劈公式計算機翼后緣繞射的計算結果與實驗結果相差甚遠.提出在垂直極化狀態下機翼后緣繞射的計算必須將后緣厚度考慮在內的見解.對於水平極化，前緣散射波峰只與前緣半徑有關；而對於垂直極化，前緣散射波峰與翼形最大厚度以及最大厚度位置有關.給出前後緣散射波峰的工程估算公式，為低雷達散射截面（ rcs ）機翼設計提供依據
  5. The main work in this paper includes three parts : the theory research on partially - cavitating and super - cavitating axisymmetric bodies, the numerical computations and experimental investigations on partially - cavitation and super - cavitation on axisymmetric bodies. after finishing the study of theory and experiment on the partially - cavitation and super - cavitation for axisymmetric body, i use the potential flow theory to build the mathematical model on the partially - cavitation and super - cavitation for axisymmetric body. many cavity wake models, such as pressure recovery close model, riabouchinsky model and re - entrant jet model, are studied seriously

    本文在深入研究了回轉體局部空化與超空化理論及實驗結果的基礎上，基於勢流理論，建立了回轉體局部空泡和超空泡流場的基本數學模型，通過對kinnas和fine 、 uhlman以及jiedang和gertkuiper等人基於二維水翼提出的壓力恢復閉合模型、鏡像板模型和回射流模型等空泡尾流模型進行了逐一的研究分析，發現其中的壓力恢復閉合模型較適用於模擬回轉體空泡尾部流場，並選用此空泡尾流模型作為求解回轉體空化流場正問題與逆問題的數學模型的組成部分。
分享友人
分享到 Line

分享到臉書