求圓的面積 的英文怎麼說

中文拼音 [qiúyuándemiànjī]
求圓的面積 英文
quadrature of a circle
  • 求 : Ⅰ動詞1 （請求; 要求） ask; beg; request; entreat; beseech : 求人幫忙 ask sb a favour; ask a favou...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 面積 : [數學] area
  1. The complex nonlinear pursuit - evasion model of two spacecraft in near - earth coplanar orbit is simplified to linear model, the circular region the radius of which is equal to capture radius is defined as target set, capture is achieved when the evader come into the target set and the game is over ; the boundary of useable part ( bup ) is determined, and the analytical form solution of the linear equations is obtained by backward integration of the state variables from the bup, the linear barrier of the pursuit - evasion model and the optimum thrust of the both sides are thus obtained

    本文將近地共面軌道內運動的兩飛行器非線性追逃模型簡化為線性模型，以捕獲半徑的圓域定為目標集，確定目標集邊界上的可用部分，並以此為各狀態變量的起點，對時間進行倒向積分，求得線性方程組的解析解，從而確定了該追逃模型的線性界柵，以及界柵上對策雙方的最優推力，即求得了滿足最優策略時相對運動的軌跡和推力。
  2. In the course of working, ， the plow will make use of the shuttling method so that it can dig alternately either on the left or on the right. compared to the unilateral plow, it can improve the productivity because it can help leave off the soil 、 take from the consumed energy and reduce the empty journey. to meet the requests above, we will use a remote cylinder with both a small cubage and double functions, approximately designing the plow to be columniform and symmetric. after the experiment for a period in the field, we found that the most frayed areas had happened at the places of both plow shank and share and at the same time the base of the remote cylinder had ruptured suddenly

    與單向犁相比，其優點在於：耕地無開、閉壟，地表平整，降低了耕后整地的能量消耗，減少了地頭的空行程，因而大大提高班次生產率。為了滿足犁體梭式作業的要求，我們採用了一隻小容積雙作用的液壓油缸；同時對犁壁曲面的形狀採用了近似圓柱形的對稱設計。但經過一段時間的田間試驗，我們發現：該犁犁胸部分的犁脛和犁鏵上的犁尖在工作中磨損較為嚴重；主犁梁和油缸缸體的連接部分（即油缸底座）突然發生了斷裂，造成整個犁體無法正常工作。
  3. Since complicated differential and integral operations were involved in the kernel of the integral equation, we simplified the equation and got the nakano equation. as instances, the planar archimedean spiral antenna, the planar equiangular spiral antenna, the monofilar helical antenna, the conical helical antenna with fixed ascending angle and the conical equiangular - spiral antenna were analyzed through the moment method. all of the results matched fairly well with the references and experiment results

    這種方法的積分方程的積分核里含有復雜的微積分運算，為了簡化計算，本文在推廣的海倫積分方程的基礎上，對方程進行了簡化，推導了nakano方程，並以平面阿基米德螺旋天線，平面等角螺旋天線，軸向模圓柱螺旋天線，具有固定升角的圓錐螺旋天線和圓錐等角螺旋天線為例，用矩量法求解了天線上的電流分佈，研究了螺旋天線輻射的寬頻帶特性，所得的結果均與參考文獻吻合很好。
  4. A general stack equation of mobile robot based on analyzing the motion of planar motion object and the mathematical models of four different kinds of common wheels is developed, accordingly, the mobility of mobile robot is addressed and the forward and inverse solutions to speed for specific configuration driven by differential speed are derived. utilizing the muir and newman convention, the description of the posture transformation matrices between different coordinate frames and the solution for the speed of point located on these frames are introduced. according to posture estimation, a more accurate method, dead reckoning algorithm, is developed for a specified configuration characterized by differential speed motorization, and simulations of this algorithm and other traditional methods are carried out using matlab while traversing a circular path

    本文對兩輪差速驅動移動機器人的運動學及其本體緩沖設計進行了探討，在對平面運動物體運動分析的基礎上結合四種常用車輪的數學模型，推導出了一個通用的移動機器人堆積方程，在此基礎上分析了移動機器人的移動能力、並針對兩輪差速構型推導了速度正解與逆解；使用muir和newman的運動學建模方法，推導了移動機器人上點及連桿坐標系位姿、速度變換關系矩陣及求解方法；在移動機器人位姿識別方法中結合差速驅動構型對航位推演算法進行了分析：推導了一種理論精度較高的航位推算演算法，並使用matlab對其與傳統的推算演算法在跟蹤圓弧軌跡情況下進行了模擬；最後針對本文所研究的機器人給出了一種比較系統、可靠的緩沖結構設計思路，較好地解決了移動機器人作業過程中外界因素及本身設計中引入的各種不確定誤差問題；本論文研究成果已在本實驗室所開發的樣機上得到實現，經過應用與考核證明其中的分析與設計是切實可行的。
  5. Eigenequation about singularity, singular stress fields and electrical displacement fields near the interface edge are obtained under axisymmetric distortion. finally, a special finite element formulation which is based on the principle of minimum potential energy has been developed for determining the orders of the singularity of the singular stress fields around the singular point ( interface edge, interface corner and the interface crack ) in the bonded dissimilar anisotropic / anisotropic, piezoelectric / piezoelectric as well as piezoelectric / anisotropic materials. the numerical results show that this method is very convenient and efficient

    最後，從最小勢能原理出發，在僅僅考慮奇異性支配區域這一前提下，對于彈性接合材料的平面變形問題和擬平面應變問題，以奇異點為原點分別建立極坐標系和圓柱坐標系，通過分部積分消除廠項，從而使奇異性問題的求解由原來的二維降為一維；對於三維變形問題，以奇異點為原點建立球坐標系，通過分部積分消除項，從而使奇異性問題的求解由原來的三維降為二維。
  6. Based on the scalar diffraction theory and the boundary condition of rayleigh - sommerfeld, the accurate on - axis propagating wave function of plane wave diffracted by small circular band is obtained by solving the first integral of rayleigh - sommerfeld

    摘要從標量衍射理論出發，採用瑞利索末菲衍射邊界條件，通過求解第一類瑞利索末菲衍射積分得到平面波經圓環衍射后軸上的波函數，進而分析軸上的光強特性以及光強極值數量、位置和大小與衍射圓環內外孔徑的關系。
  7. Several typical sites are chosen in this paper in order to investigate the main points of wave function expansion method applied to elastic wave scattering problems. antiplane scattering analytical solution for the alluvial valley of shallow circular - arc cross - section is investigated, which has practical engineering value

    本文選擇了幾種典型場地，研究了波函數展開法在求解其中局部場地彈性波散射問題時的要點，對更有工程實際意義的淺圓弧型沉積盆地，研究了其出平面散射解析解答的收斂性和精度。
  8. In particular, its application to partial differential equation, which is concerned by more and more mathematicians, is a very active branch in mathematics research at present. for example, the calderon - zygmund operators of the third era and t ( 1 ), t ( b ) theorem offer the theoretic base of potential method to solve a class of elliptic boundary problems in non smooth domains [ 46 ] ; on the other hand, the lp - lq estimates and space - time estimates of the linear evolution equations offer the nonlinear evolution equations new work spaces, which is established by the estimates of oscillatory integral and potential

    例如第三代calderon - zygmund運算元及t （ 1 ） ， t （ b ）定理，對于非光滑區域上的一類橢圓邊值問題，提供了用位勢求解的理論基礎[ 46 ] ；又如以振蕩積分估計及位勢估計為基礎，建立線性發展方程的l ~ p - l ~ q估計以及相應的時空估計，為研究發展型方程提供了新的工作空間，這方面的工作參見t
分享友人
分享到 Line

分享到臉書