求容積法 的英文怎麼說

中文拼音 [qiúróngjīfǎ]
求容積法 英文
cubature
  • 求 : Ⅰ動詞1 （請求; 要求） ask; beg; request; entreat; beseech : 求人幫忙 ask sb a favour; ask a favou...
  • 積 : Ⅰ動詞（積累） amass; store up; accumulate Ⅱ形容詞（長時間積累下來的） long standing; long pending...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. In the course of working, ， the plow will make use of the shuttling method so that it can dig alternately either on the left or on the right. compared to the unilateral plow, it can improve the productivity because it can help leave off the soil 、 take from the consumed energy and reduce the empty journey. to meet the requests above, we will use a remote cylinder with both a small cubage and double functions, approximately designing the plow to be columniform and symmetric. after the experiment for a period in the field, we found that the most frayed areas had happened at the places of both plow shank and share and at the same time the base of the remote cylinder had ruptured suddenly

    與單向犁相比，其優點在於：耕地無開、閉壟，地表平整，降低了耕后整地的能量消耗，減少了地頭的空行程，因而大大提高班次生產率。為了滿足犁體梭式作業的要求，我們採用了一隻小容積雙作用的液壓油缸；同時對犁壁曲面的形狀採用了近似圓柱形的對稱設計。但經過一段時間的田間試驗，我們發現：該犁犁胸部分的犁脛和犁鏵上的犁尖在工作中磨損較為嚴重；主犁梁和油缸缸體的連接部分（即油缸底座）突然發生了斷裂，造成整個犁體無法正常工作。
  2. Based on the single point measurement, to a south towards constuction being built and some windows of the original housing behind the new building, this paper works out the whole height of the new building with the largest cubage which is also the optimization on the condition that all the windows mentioned above satisfying the sunlight standard. thus it can not only realize both land saving and scientific housing, but also give the designer some guiding advices

    在此基礎上，對一正南朝向的待建建築物和其後面原有住宅樓上的窗體，在滿足原有住宅樓上的窗體都滿足日照標準的條件下，利用遺傳演算法來求解該待建建築物的整體高度，使其容積最大，即達到最優，從而達到節約土地和科學住房的目的，為建築設計者起到一定的指導作用。
  3. Here we obtain the strain compatibility method ande equilibrium of forces and concepts of fracture mechanincs, they can be used to predict the ultimats strength in flexure that can be achieved by such elements, given the cfrp cross - sectional area, or conversely, the required cfrp cross - sectional area to achieve a targeted resisting moment of rehabilitated flexureal elements

    Cfrp加固梁在承受彎曲荷載時的破壞是鋼筋屈服后碳纖維斷裂和鋼筋屈服后混凝土壓碎。本文通過應變相容方法和對破壞機理的定義，由給定的cfrp橫截面積預測加固梁的極限彎曲強度；或者相反，在已知加固梁的極限彎曲強度時可以求出所需的cfrp橫截面積。
  4. Several ways of coupling of solid - fluid regions, including that vacant proportion practice, segregated volume practice etc, are discussed, and the brief treatment method of solid - region in the fluid is put forward

    討論並比較了幾種固體一流體耦合求解的辦法：空度法、隔離容積法等，簡化流場中固體障礙物的處理。
  5. This technique combines the edge - based finite - element method with physical optics ( po ) and physical theory of diffraction ( ptd ). the hybrid technique is applied to compute the scattering fields from the electrically large bodies with cracks and cavities on their surfaces. it is also used to analyze the scattering characteristics of microstrip antennas residing in a cavity mounted on metal objects with finite sizes

    本文採用edge - basedfem為基本方法，結合物理光學法（ po ） 、物理繞射理論（ ptd ） 、邊界積分方程（ bi ） 、區域分解技術（ ddm ）和完全匹配層（ pml ）吸收邊界條件等求解方法構成的混合方法，對電磁散射和輻射問題進行了研究，主要包括以下內容：提出了一種edge - basedfem與物理光學方法和物理繞射理論相結合的混合方法? fem po - ptd方法，並將該混合方法應用於帶有腔體或槽縫的電大尺寸導體目標的電磁散射特性分析和位於有限導體目標上的背腔式微帶貼片天線的電磁散射特性分析。
  6. Based on the theory of fluid dynamics. transient - flow and vibration, the structure parameters of the air - volume ( such as the volume and position of the air - volume ) affect the pressure oscillation in piping system is put forward, and the designing method for the parameters of the air - volume according to the role of the air - volume is provided

    本文根據流體力學、瞬變流以及振動學的理論，研究了管道系統中空氣室結構參數（空氣室的容積，安裝位置等）對壓力脈動的變化規律，提出了根據空氣室工作任務要求設計空氣室的計算方法。
  7. Fourthly, this article finds the solution to the main equation set about labyrinth seals model of two - control - volume, concludes the pressure distribution in labyrinth seals, and further obtains the answer of the calculation formula on the four dynamic characteristics about labyrinth seals

    4 、對迷宮密封兩控制容積模型主導方程組運用攝動分析方法進行了求解，得到了迷宮密封腔中的壓力分佈，並進一步求解得到迷宮密封的四個動力特性系數的計算公式。
  8. The dissertation gives a profound and extensive theoretic research of starting process, causes of fall - out and damages caused by fall - out as well as the electromagnetic process in large pumping station. the ? qual area criterion ? is used in this research to analyze the stability limitation of the synchromotors fall - out in detail. in the end, the study also puts forward a couple of practical methods to prevent synchromotors from fall - out and corresponding solutions to the fall - out

    本文主要內容是：圍繞大泵站同步電機起動過程、運行中的失步機理及危害、失步時電磁物理過程等方面進行了細致深入的理論研究；用「等面積定則」分析大泵站同步電機失步的穩定界限並提出求解方法；提出預防同步電機失步的措施。
  9. The main contents of this thesis are : ( 1 ) two numerical reconstruction methods - direct fourier transform method and envelope method, are presented. these methods are deduced on the base of fresnel diffraction integral formula, which is under the condition that particle field is illuminated by plane wave

    主要工作內容有： （ 1 ）分析推導了平面物菲涅耳衍射的兩種常用數值實現演算法，即直接傅里葉變換法和卷積法，結論表明後者更符合實際工作的要求。
  10. This paper adopt the ~ model of standard turbulence, apply staggered grid and finite volume approach discrete equation analysis

    本文採用標準湍流Ｋ模型，應用交錯網格和有限容積法離散方程求解。
  11. The finite volume method is used to discrete the flow controling equations on staggered grid and the simple algorithm is adopted to solve the equations

    採用有限容積法在交錯網格上對流動控制方程離散，然後採用simple演算法求解。
  12. The discrete equation was deduced by control volume integral method, and realized by numerical method

    用控制容積積分法導出了離散方程，並用數值方法進行了求解。
  13. Constructure forms and work principles of hydraulic vavle lifter ( hvl ) in four kinds of classic internal conbustion engine is introduced ; designment and application of oil - intake line, oil - reservoir volumn, and limit position of plunger running in hvl and requirement of hvl on lubrication system and valve train mechanism of internal combustion engine are analyzed ; in the meanwhile, corresponding solutions are put forword

    摘要介紹了4種典型內燃機液力挺柱的結構形式及工作原理，對液力挺柱在設計和應用中進油道、儲油室容積、柱塞工作極限位置及液力挺柱對內燃機潤滑系和配氣機構的要求等幾個問題進行了分析，並提出了相應的解決方法。
  14. Compared with the scroll compressor of traditional circle profile, it has the advantages of high efficiency, little leakage and high quotient of volume using. the research work is given as follows. a whole volume theory for the scroll chamber working process of new type combination profile compressor is set up

    論文的研究工作主要表現在以下幾個方面:論文對新型分段組合曲線渦旋壓縮機的容積理論進行了論述，系統地研究了組合曲線渦旋壓縮機各個壓縮腔容積的求解方法。
  15. ( 2 ) the explicit simulating process for the pulse combustion spray drying process in this project, both the gas - phase equations and particle - phase equations were integrated in the computational cell using up - wild scheme to obtain the finite difference equations. the gas - phase equations are solved using the simpler algorithm and multiple iterations have been made based on a two - way coupling ( legaml algorithm )

    （ 2 ）進行了模型的求解本文詳細論述了該類數學模型的具體求解過程，包括模擬區域的確定和非結構化網格的劃分、邊界條件的選擇、微分方程的控制容積離散方法、代數方程組的simpler解法以及兩相流方程的legami演算法。
  16. Workplace atmospheres - volumetric bioaerosol sampling devices - requirements and test methods

    工作場所空氣.容積式生物懸浮微粒取樣裝置.要求和試驗方法
  17. Fluid power - round hydraulic reservoirs made of steel - dimensions, requirements, test method - nominal capacity 1000 to 20000

    液壓.圓形蓄壓鋼瓶.尺寸要求試驗方法.額定容積10
  18. In the article, physical and mathematical models for the fluid flow and heat transfer inside a horizontal low - temperature have been established. and using the method of simple and integer evaluation and fvm has simulated the steady temperature and velocity distribution of a horizontal low - temperature refrigerator that the author has designed

    本文還建立了臥式低溫冰箱內空氣流動與換熱的物理和數學模型，並採用simple演算法、整體求解法和有限容積法對作者所設計的一臺臥式低溫箱箱內自然對流穩態溫度場的分佈進行計算機模擬研究。
  19. A numerical method, based on single temperature sensor, constant heat flux assumed and arbitrary number future time steps, was employed to determine the heat flux during rapid cooling on high temperature surface with multiply immersed impinging water jets the finite volume discretization method and treatment of boundary condition were presented

    摘要基於單點測溫、常熱流假設，任意未來時間步長的導熱反問題演算法求解浸沒水射流冷卻過程的熱流密度；採用有限容積法離散方程，附加源項法處理邊界條件。
  20. To a construction being built with determinate groundsill, the paper first assumes it with enough height, then devides its back exterior into several shelter bars. there will be borderlines on the shelter bars corresponding to every window being measured. in the paper it takes the number of the window whose borderline is kept by the shelter bar as the gene of the chromosome

    對一地基確定的待建建築物，開始時假定其足夠高，將其後表面分割成若干遮擋條，每個待測窗體在各遮擋條上都有對應的臨界線，將每個遮擋條所取的臨界線對應的窗體號作為染色體的基因進行編碼，按照繪制的遺傳演算法流程圖，通過vc語言編製成相應程序，求解出每個遮擋條應保留的高度，從而得到整幢建築物的高度和其最大容積。
分享友人
分享到 Line

分享到臉書