求得比例尺 的英文怎麼說
中文拼音 [qiúdebǐlìchǐ]
求得比例尺
英文
scale calculated from a map- 求 : Ⅰ動詞1 （請求; 要求） ask; beg; request; entreat; beseech : 求人幫忙 ask sb a favour; ask a favou...
- 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
- 尺 : 尺名詞[音樂] （中國民族音樂音階上的一級 樂譜上用做記音符號 參看「工尺」） a note of the scale in ...
- 求得 : go for
- 比例 : 1. （長度上縮小和放大的倍數） scale; scaling 2. （比率） proportion; ratio; proportionality
-
The effect of different sizes of sections, modes and values of residual stresses are studied. through the analysis, the conclusion is arrived at that the universal slenderness ratio should be used to better correlate the stability of box section beams with the member length instead of the out - of - plane slenderness, and the stability coefficient is taken to be 1. 0 for practical used box girder. then, the elastic critical loads of box section beam - columns are obtained based on the gjelsvik theory, and the relationship between axis force p and moment m is given
最後，運用ansys通用有限元程序的beam189單元，引入初彎曲和殘余應力的影響，用考慮幾何和材料雙重非線性的有限元求解格式求得箱形柱在不同軸力和彎矩比例作用下的彈塑性極限承載力，通過對十幾個不同截面尺寸構件在不同長細比下的承載力計算，發現在軸力p遠大於彎矩m時，構件將是平面外失穩控制，而當軸力p遠小於彎矩m時，構件則以平面內失穩為主。Referring to three kinds of plan irregularity, structures individually with four kinds of irregularity as eccentricity in one direction, eccentricities in two directions, re - entrant corner irregularity and diaphragm discontinuity have been analyzed to investigate the relationship between torsion effects and parameters of above irregular structures. the parameters and the schemes for determining the scope of structures with different kind of irregularity considering seismic action in two directions simultaneously are proposed, some conclusions have been get as following : it is indicated by the analysis results that torsion effect has no dependency relation with eccentric torsional angel adopted in code for seismic design for buildings. it is suggested that the eccentric torsional angel should not be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricity in one direction due to irregular mass layout, the relative eccentricity can be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricities in two directions due to irregular mass layout, the ratio of relative eccentricities in two directions and the angel of them can be take as the parameters of torsion effect of structures considering seismic action in two directions simultaneously ; it is indicated by the analysis results that the torsion effect has no dependency relation with re - entrant corner ratio adopted in code for seismic design for buildings as
所取得的主要結論有：結構的扭轉效應與《抗震規范》所採用的扭轉不規則指標即偏心扭轉角之間的相關性較差，偏心扭轉角不宜作為判斷結構是否計及扭轉效應及需考慮雙向水平地震作用的界定指標；對于樓層間均勻偏心的多層單向偏心結構，建議採用相對偏心距作為需考慮雙向水平地震作用的界定指標，並給出針對不同平面尺寸的界限相對偏心距；對于樓層間均勻偏心的多層雙向偏心結構，建議採用兩個主軸方向的相對偏心距及其夾角作為界定指標，結合單向偏心結構的界定方案進行需考慮雙向水平地震作用的結構范圍界定；凸凹不規則結構的扭轉效應與凸凹比例無正相關關系， 《抗震規范》要求所有平面布置不對稱的凸凹不規則結構計及扭轉效應的規定欠妥當，建議凸凹不規則界限值從30改為15 ，只要求分析採用空間模型比較合適； 《抗震規范》關于有效樓板寬度較小的結構需計及扭轉效應的規定很有必要，樓板局部不連續的結構需採用符合樓板實際剛度的計算模型予以分析，可使用相對偏心距（及其夾角）參照單向（和雙向）偏心結構的界定方案，界定樓板局部不連續結構是否需要計入雙向水平地震作用下的扭轉效應。
分享友人